On characterisation of local stress–strain properties in friction stir welded aluminium AA 5083 sheets using micro-tensile specimen testing and instrumented indentation technique

[1]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[2]  Michael V. Swain,et al.  Determining the mechanical properties of small volumes of material from submicrometer spherical indentations , 1995 .

[3]  F. Kosel,et al.  New analytical procedure to determine stress-strain curve from spherical indentation data , 1998 .

[4]  Z. Mroz,et al.  Identification of Hardening Parameters of Metals From Spherical Indentation Tests , 2001 .

[5]  Zenon Mróz,et al.  Identification of plastic hardening parameters of metals from spherical indentation tests , 2001 .

[6]  M. Koçak,et al.  Mechanical and fracture characterization of a bi-material steel plate , 2002 .

[7]  K. N. Krishnan,et al.  On the formation of onion rings in friction stir welds , 2002 .

[8]  A. ADoefaa,et al.  ? ? ? ? f ? ? ? ? ? , 2003 .

[9]  E. Tyulyukovskiy,et al.  A new loading history for identification of viscoplastic properties by spherical indentation , 2004 .

[10]  Ingo Scheider,et al.  Procedure for the Determination of True Stress-Strain Curves From Tensile Tests With Rectangular Cross-Section Specimens , 2004 .

[11]  Jesper Henri Hattel,et al.  Material flow in butt friction stir welds in AA2024-T3 , 2006 .

[12]  E. Tyulyukovskiy,et al.  Identification of viscoplastic material parameters from spherical indentation data: Part I. Neural networks , 2006 .

[13]  D. Klötzer,et al.  Identification of viscoplastic material parameters from spherical indentation data: Part II. Experimental validation of the method , 2006 .

[14]  Nagahisa Ogasawara,et al.  A new approach to measure the elastic–plastic properties of bulk materials using spherical indentation , 2006 .

[15]  N. Huber,et al.  Spherical indentation into elastoplastic materials: Indentation-response based definitions of the representative strain , 2007 .

[16]  Norbert Huber,et al.  Neural networks for tip correction of spherical indentation curves from bulk metals and thin metal films , 2007 .

[17]  S. T. Amancio-Filho,et al.  Preliminary study on the microstructure and mechanical properties of dissimilar friction stir welds in aircraft aluminium alloys 2024-T351 and 6056-T4 , 2008 .

[18]  E. Tyulyukovskiy,et al.  An indentation system for determination of viscoplastic stress–strain behavior of small metal volumes before and after irradiation , 2008 .

[19]  N. Huber,et al.  On the effect of a general residual stress state on indentation and hardness testing , 2008 .

[20]  Timotius Pasang,et al.  Shear flow and formation of Nugget zone during friction stir welding of aluminium alloy 5083-O , 2008 .

[21]  N. Huber,et al.  Influence of specimen preparation, microstructure anisotropy, and residual stresses on stress–strain curves of rolled Al2024 T351 as derived from spherical indentation tests , 2009 .