Experimental monitoring of chloride-induced reinforcement corrosion and chloride contamination in concrete with ground-penetrating radar

In this article, we present a laboratory experiment to monitor the accelerated corrosion in concrete using ground-penetrating radar (GPR). Four concrete test specimens were cast with rebars of different size and placed at different depths. The lifetime decades of reinforcement corrosion process were accelerated into 18 days by using the impress current technique. The electrochemical corrosion process was periodically monitored with GPR. Two control specimens were also prepared to investigate the influence of chloride contamination on GPR signal. The measured data were analysed both in time and frequency domains. In time domain, the peak-to-peak amplitude of a wave reflected by a rebar was calculated to investigate the relationship between an increase in signal amplitude and the degree of corrosion. In frequency domain, the time–frequency representations of the signal were computed by using S-transform. The results show that reinforce corrosion increased the amplitude of reflected signal in time domain but did not change the peak frequency in frequency domain while chloride contamination attenuates the signal to smaller amplitude and lower peak frequency. Based on the results, a novel process is finally proposed for GPR-based corrosion detection.

[1]  Michael Raupach,et al.  Half-cell potential measurements—Potential mapping on reinforced concrete structures , 2003 .

[2]  C. Gabriel,et al.  Complex permittivity of sodium chloride solutions at microwave frequencies , 2007, Bioelectromagnetics.

[3]  Khaled Soudki,et al.  Effectiveness of Impressed Current Technique to Simulate Corrosion of Steel Reinforcement in Concrete , 2003 .

[4]  Richard E. Weyers,et al.  MODELING THE TIME-TO-CORROSION CRACKING IN CHLORIDE CONTAMINATED REINFORCED CONCRETE STRUCTURES , 1998 .

[5]  Lalu Mansinha,et al.  Localization of the complex spectrum: the S transform , 1996, IEEE Trans. Signal Process..

[6]  Herbert Wiggenhauser,et al.  Using ground penetrating radar and time–frequency analysis to characterize construction materials , 2011 .

[7]  A C Smith,et al.  Corrosion of steel in concrete , 1982 .

[8]  MansinhaL..  Localization of the complex spectrum , 1996 .

[9]  Nigel J. Cassidy,et al.  Chapter 2 – Electrical and Magnetic Properties of Rocks, Soils and Fluids , 2009 .

[10]  Susan S. Hubbard,et al.  EXPERIMENTAL DETECTION OF REINFORCING BAR CORROSION USING NONDESTRUCTIVE GEOPHYSICAL TECHNIQUES , 2003 .

[11]  K R Maser,et al.  MODELING THE ELECTROMAGNETIC PROPERTIES OF CONCRETE , 1993 .

[12]  R. Helmerich,et al.  Monitoring accelerated corrosion in chloride contaminated concrete with ground penetrating radar , 2012, 2012 14th International Conference on Ground Penetrating Radar (GPR).

[13]  U. Böniger,et al.  Improving the interpretability of 3D GPR data using target–specific attributes: application to tomb detection , 2010 .

[15]  Kenneth R. MASER.  Integration of Ground Penetrating Radar and Infrared Thermography for Bridge Deck Condition Evaluation , 2009 .

[16]  Herbert Wiggenhauser,et al.  Measurement of Accelerated Steel Corrosion in Concrete Using Ground-Penetrating Radar and a Modified Half-Cell Potential Method , 2013 .