High sulfur dioxide deposition velocities measured with the flux–gradient technique in a boreal forest in the Alberta Oil Sands Region

Abstract. The emission of SO2 from the Athabasca Oil Sands Region (AOSR) has been shown to impact the surrounding forest area. Recent studies using aircraft-based measurements have demonstrated that deposition of SO2 to the forest is at a rate many times higher than model estimates. Here we use the flux–gradient method to estimate SO2 deposition rates at two tower sites in the boreal forest downwind of AOSR SO2 emissions. We use both continuous and passive sampler measurements and compare the two techniques. The measurements infer SO2 deposition velocities ranging from 2.1–5.9 cm s−1 (when corrections are applied). There are uncertainties associated with the passive sampler flux–gradient analysis, primarily due to an assumed Schmidt number, a required assumption of independent variables, and potential wind effects. We estimate the total uncertainty as ± 2 cm s−1. Accounting for these uncertainties, the range of measurements is approximately double the previous aircraft-based measurements (1.2–3.4 cm s−1) and more than 10 times higher than model estimates for the same measurement periods (0.1–0.6 cm s−1), suggesting that SO2 in the AOSR has a much shorter lifetime in the atmosphere than is currently predicted by models.

[1]  M. Gordon,et al.  Aerosol deposition to the boreal forest in the vicinity of the Alberta Oil Sands , 2023, Atmospheric Chemistry and Physics.

[2]  S. Alvarez,et al.  Development and testing of a novel sulfur dioxide sonde , 2022, Atmospheric Measurement Techniques.

[3]  Y. Lei,et al.  Using Passive Air Samplers to Quantify Vertical Gaseous Elemental Mercury Concentration Gradients Within a Forest and Above Soil , 2021, Journal of Geophysical Research: Atmospheres.

[4]  R. Staebler,et al.  Methane emissions from an oil sands tailings pond: a quantitative comparison of fluxes derived by different methods , 2021, Atmospheric Measurement Techniques.

[5]  Shao-Meng Li,et al.  New Methodology Shows Short Atmospheric Lifetimes of Oxidized Sulfur and Nitrogen due to Dry Deposition , 2021, Atmospheric Chemistry and Physics.

[6]  J. Aherne,et al.  Spatiotemporal variation in summer ground-level ozone in the Sandbanks Provincial Park, Ontario , 2019, Atmospheric Pollution Research.

[7]  J. Wyngaard,et al.  The Atmospheric Boundary Layer , 2019, Wind Effects on Structures.

[8]  Shao-Meng Li,et al.  Estimates of exceedances of critical loads for acidifying deposition in Alberta and Saskatchewan , 2018, Atmospheric Chemistry and Physics.

[9]  C. McLinden,et al.  The effects of forest canopy shading and turbulence on boundary layer ozone , 2017, Nature Communications.

[10]  F. Bombardelli,et al.  On the Values for the Turbulent Schmidt Number in Environmental Flows , 2017 .

[11]  Jonathan Gillespie,et al.  Influence of wind-speed on short-duration NO2 measurements using Palmes and Ogawa passive diffusion samplers , 2017 .

[12]  J. Aherne,et al.  Critical loads of acidity for 90,000 lakes in northern Saskatchewan: A novel approach for mapping regional sensitivity to acidic deposition , 2016 .

[13]  M. Fenn,et al.  Atmospheric dry deposition of sulfur and nitrogen in the Athabasca Oil Sands Region, Alberta, Canada. , 2016, The Science of the total environment.

[14]  P. Jackson,et al.  Ambient nitrogen dioxide and sulfur dioxide concentrations over a region of natural gas production, Northeastern British Columbia, Canada , 2016 .

[15]  Zhiyong Wu,et al.  Dry deposition of O3 and SO2 estimated from gradient measurements above a temperate mixed forest. , 2016, Environmental pollution.

[16]  M. MacLeod,et al.  Comparison of eddy covariance and modified Bowen ratio methods for measuring gas fluxes and implications for measuring fluxes of persistent organic pollutants , 2015 .

[17]  Shao-Meng Li,et al.  Determining air pollutant emission rates based on mass balance using airborne measurement data over the Alberta oil sands operations , 2015 .

[18]  S. Wofsy,et al.  Ecosystem fluxes of hydrogen: a comparison of flux-gradient methods , 2014 .

[19]  J. Aherne,et al.  Ambient concentrations of atmospheric ammonia, nitrogen dioxide and nitric acid across a rural–urban–agricultural transect in southern Ontario, Canada , 2012 .

[20]  H. Plaisance.  The effect of the wind velocity on the uptake rates of various diffusive samplers , 2011 .

[21]  J. Aherne,et al.  Impacts of sulphur and nitrogen deposition in western Canada , 2010 .

[22]  J. Aherne,et al.  Estimating the sensitivity of forest soils to acid deposition in the Athabasca Oil Sands Region, Alberta , 2010 .

[23]  A. A. Salem,et al.  Determination of nitrogen dioxide, sulfur dioxide, ozone, and ammonia in ambient air using the passive sampling method associated with ion chromatographic and potentiometric analyses , 2009, Air quality, atmosphere, & health.

[24]  Paul A. Makar,et al.  Role of canopy‐scale photochemistry in modifying biogenic‐atmosphere exchange of reactive terpene species: Results from the CELTIC field study , 2005 .

[25]  John H. Prueger,et al.  Turbulent Schmidt number from a tracer experiment , 2002 .

[26]  M. Hultengren,et al.  A filter method for the active and passive monitoring of sulfur dioxide in workplace air. , 1984, Scandinavian journal of work, environment & health.

[27]  D. Tarasick,et al.  Ozone in the boreal forest in the Alberta oil sands region , 2023 .

[28]  R. Staebler,et al.  Methane emissions from an oil sands tailings pond: A quantitative comparison of fluxes derived by different methods , 2020 .

[29]  Leiming Zhang,et al.  Impacts and Effects Indicators of Atmospheric Deposition of Major Pollutants to Various Ecosystems - A Review , 2018 .

[30]  P Hofschreuder,et al.  The influence of geometry and draught shields on the performance of passive samplers. , 1999, Journal of environmental monitoring : JEM.