Moisture influence and geometry effect of Au and Pt electrodes on CO sensing response of SnO2 microsensors based on sol–gel thin film

Abstract Undoped tin oxide-based gas microsensors have been prepared by the sol–gel deposition technique. The influence of the gaseous atmosphere (humidity and carbon monoxide) on the electrical conductance of the samples has been investigated. Then, the variation of the geometry and the nature of the electric contacts has been considered as interesting factor that can modulate the selectivity. SEM observations of the surface have shown a good quality of the electrodes. A pre-deposited Ti thin layer improves the adhesion of the contacts to the SnO2 film. A diversification of the sensors, when exposed to CO, was observed depending on two different electrodes materials (Au and Pt) arranged in two different geometric configurations of the interdigitated fingers. Preliminary results have shown that CO response is enhanced by the use of interdigitated electrodes with a short separation gap (200 μm) as compared to those with wider one (400 μm) for both Pt and Au electrodes, while the use of gold contacts seems to reduce the working temperature of our sensors, probably due to some effects related to the diffusion of Au into the Ti and/or the active layer, but other drawbacks could also arise.

[1]  Chao-Nan Xu,et al.  Grain size effects on gas sensitivity of porous SnO2-based elements , 1991 .

[2]  Guangjin Li,et al.  Relationships between sensitivity, catalytic activity, and surface areas of SnO2 gas sensors , 1999 .

[3]  Udo Weimar,et al.  A.c. measurements on tin oxide sensors to improve selectivities and sensitivities , 1995 .

[4]  G. Tournier,et al.  Selective detection of CO and CH4 with gas sensors using SnO2 doped with palladium , 1995 .

[5]  J. Brezmes,et al.  Numerical simulation of the electrode geometry and position effects on semiconductor gas sensor response , 1998 .

[6]  Gerd Sulz,et al.  Thin-film SnO2 sensor arrays controlled by variation of contact potential—a suitable tool for chemometric gas mixture analysis in the TLV range , 1997 .

[7]  A. Stoneham,et al.  Effect of Electrode Geometry on Sensor Response , 1990 .

[8]  Julian W. Gardner,et al.  Intelligent gas sensing using an integrated sensor pair , 1995 .

[9]  V. Lantto,et al.  Some differences between Au and Pt electrodes in SnO2 thick-film gas sensors , 1993 .

[10]  Udo Weimar,et al.  The effect of Pt and Pd surface doping on the response of nanocrystalline tin dioxide gas sensors to CO , 1996 .

[11]  K. Steiner,et al.  Contact and sheet resistance of SnO2 thin films from transmission-line model measurements , 1995 .

[12]  René Lalauze,et al.  Sintering catalytic effects and defect chemistry in polycrystalline tin dioxide , 1995 .

[13]  Cox,et al.  Oxygen vacancies and defect electronic states on the SnO2(110)-1 x 1 surface. , 1988, Physical review. B, Condensed matter.

[14]  K. Fukui,et al.  Effects of tin oxide semiconductor-electrode interface on gas-sensitivity characteristics , 1993 .

[15]  R. Ionescu,et al.  The mechanism of the interaction between CO and an SnO2 surface: the role of water vapour , 1993 .

[16]  Nicolae Barsan,et al.  Selectivity enhancement of SnO2 gas sensors: simultaneous monitoring of resistances and temperatures , 1999 .

[17]  Monica Cǎldǎraru,et al.  Surface dynamics in tin dioxide-containing catalysts II. Competition between water and oxygen adsorption on polycrystalline tin dioxide , 1996 .

[18]  D. Kohl.  Surface processes in the detection of reducing gases with SnO2-based devices , 1989 .

[19]  Udo Weimar,et al.  Gas identification by modulating temperatures of SnO2-based thick film sensors , 1997 .

[20]  R. Ionescu,et al.  Role of water vapour in the interaction of SnO2 gas sensors with CO and CH4 , 1999 .

[21]  M. Lumbreras,et al.  Electrode nature effects on stannic oxide type layers prepared by electrostatic spray deposition , 1999 .

[22]  J. Gardner,et al.  Integrated tin oxide odour sensors , 1991 .

[23]  L. Vasanelli,et al.  A novel gas sensor based on SnO2/Os thin film for the detection of methane at low temperature , 1999 .