Structural Evolution and Thermoelectric Properties of Mg3sbxbi2-X Thin Films Deposited by Magnetron Sputtering

Mg3Bi2-based compounds are of great interest for thermoelectric applications near room temperature. Here, undoped p-type Mg3SbxBi2−x thin films were synthesized using magnetron sputtering (three elemental targets in Ar atmosphere) with a growth temperature of 200 °C on three different substrates, namely, Si as well as c- and r-sapphire. The elemental composition was measured with energy-dispersive x-ray spectroscopy and the structure by x-ray diffraction. The electrical resistivity and the Seebeck coefficient were determined under He atmosphere from room temperature to the growth temperature. All samples are crystalline exhibiting the La2O3-type crystal structure (space group P-3m1). The observed thermoelectric response is consistent with a semiconductive behavior. With increasing x, the samples become more electrically resistive due to the increasing bandgap. High Bi content (x < 1) is thus beneficial due to lower resistivity and a higher power factor near room temperature. Thermoelectric thin films synthesized at low temperatures may provide novel pathways to enable flexible devices on polymeric and other heat-sensitive substrates.

[1]  B. Iversen,et al.  Insight into the Strategies for Improving the Thermal Stability of Efficient N-Type Mg3Sb2-Based Thermoelectric Materials. , 2022, ACS applied materials & interfaces.

[2]  Dawei Tang,et al.  Zintl Phase Compounds Mg3Sb2−x Bi x (x = 0, 1, and 2) Monolayers: Electronic, Phonon and Thermoelectric Properties From ab Initio Calculations , 2022, Frontiers in Mechanical Engineering.

[3]  Zihang Liu,et al.  Maximizing the performance of n-type Mg3Bi2 based materials for room-temperature power generation and thermoelectric cooling , 2022, Nature communications.

[4]  D. Music,et al.  Epitaxial growth and thermoelectric properties of Mg3Bi2 thin films deposited by magnetron sputtering , 2022, Applied Physics Letters.

[5]  Jingfeng Li,et al.  Room-temperature thermoelectric materials: Challenges and a new paradigm , 2021, Journal of Materiomics.

[6]  P. Qin,et al.  Solid‐State Janus Nanoprecipitation Enables Amorphous‐Like Heat Conduction in Crystalline Mg3Sb2‐Based Thermoelectric Materials , 2021, Advanced science.

[7]  J. Tani,et al.  Fabrication of Mg3Sb2 thin films via radio-frequency magnetron sputtering and analysis of the corresponding electrical properties , 2021, Journal of Materials Science: Materials in Electronics.

[8]  Anubhav Jain,et al.  Compromise between band structure and phonon scattering in efficient n-Mg3Sb2-Bi thermoelectrics , 2021 .

[9]  Gang Chen,et al.  Thermoelectric cooling materials , 2020, Nature Materials.

[10]  Z. Ren,et al.  N-type Mg3Sb2-Bi with improved thermal stability for thermoelectric power generation , 2020 .

[11]  Lei Yang,et al.  Cu2Se thermoelectrics: property, methodology, and device , 2020 .

[12]  P. Eklund,et al.  An upgraded ultra-high vacuum magnetron-sputtering system for high-versatility and software-controlled deposition , 2020, Vacuum.

[13]  S. Zoras,et al.  A review on recent developments of thermoelectric materials for room-temperature applications , 2020, Sustainable Energy Technologies and Assessments.

[14]  K. Yu,et al.  Near-room-temperature thermoelectric materials and their application prospects in geothermal power generation , 2019 .

[15]  Hongyu Yu,et al.  Significant enhancement in thermoelectric performance of Mg3Sb2 from bulk to two-dimensional mono layer , 2019, Nano Energy.

[16]  M. Dargusch,et al.  Flexible Thermoelectric Materials and Generators: Challenges and Innovations , 2019, Advanced materials.

[17]  Huijin Jin,et al.  Attaining reduced lattice thermal conductivity and enhanced electrical conductivity in as-sintered pure n-type Bi2Te3 alloy , 2018, Journal of Materials Science.

[18]  Y. Liu,et al.  Mg3+δSbxBi2−x Family: A Promising Substitute for the State‐of‐the‐Art n‐Type Thermoelectric Materials near Room Temperature , 2018, Advanced Functional Materials.

[19]  Yong Du,et al.  Flexible thermoelectric materials and devices , 2018, Applied Materials Today.

[20]  G. J. Snyder,et al.  Heat capacity of Mg3Sb2, Mg3Bi2, and their alloys at high temperature , 2018, Materials Today Physics.

[21]  Fernando Briones,et al.  High Thermoelectric zT in n‐Type Silver Selenide films at Room Temperature , 2018 .

[22]  Z. Ren,et al.  Study on anisotropy of n-type Mg3Sb2-based thermoelectric materials , 2018 .

[23]  Tay-Rong Chang,et al.  Realization of a Type‐II Nodal‐Line Semimetal in Mg3Bi2 , 2017, Advanced science.

[24]  Liu Yong,et al.  New trends, strategies and opportunities in thermoelectric materials: A perspective , 2017 .

[25]  T. Kanno,et al.  Isotropic Conduction Network and Defect Chemistry in Mg3+δSb2‐Based Layered Zintl Compounds with High Thermoelectric Performance , 2016, Advanced materials.

[26]  J. Goodenough,et al.  Suppressing the bipolar contribution to the thermoelectric properties of Mg2Si0.4Sn0.6 by Ge substitution , 2015 .

[27]  Donald T. Morelli,et al.  On the Thermoelectric Properties of Zintl Compounds Mg3Bi2−xPnx (Pn = P and Sb) , 2013, Journal of Electronic Materials.

[28]  Ravi Mahajan,et al.  On-chip cooling by superlattice-based thin-film thermoelectrics. , 2009, Nature nanotechnology.

[29]  G. J. Snyder,et al.  Thermoelectric properties and microstructure of Mg3Sb2 , 2006 .

[30]  A. Watanabe,et al.  Electronic structures of Mg3Pn2 (Pn=N, P, As, Sb and Bi) and Ca3N2 calculated by a first-principle pseudopotential method , 2006 .

[31]  R. Venkatasubramanian,et al.  Thin-film thermoelectric devices with high room-temperature figures of merit , 2001, Nature.