Study of sensitivity and noise in the piezoelectric self-sensing and self-actuating cantilever with an integrated Wheatstone bridge circuit.

A detection method using a self-sensing cantilever is more desirable than other detection methods (optical fiber and laser beam bounce detection) that are bulky and require alignment. The advantage of the self-sensing cantilever is its simplicity, particularly its simple structure. It can be used for the construction of an atomic force microscopy system with a vacuum, fluids, and a low temperature chamber. Additionally, the self-actuating cantilever can be used for a high speed scanning system because the bandwidth is larger than the bulk scanner. Frequently, ZnO film has been used as an actuator in a self-actuating cantilever. In this paper, we studied the characteristics of the self-sensing and self-actuating cantilever with an integrated Wheatstone bridge circuit substituting the ZnO film with a lead zirconate titanate (PZT) film as the actuator. We can reduce the leakage current (to less than 10(-4) A/cm(2)) in the PZT cantilever and improve sensor sensitivity through a reduction of noise level from the external sensor circuit using the Wheatstone bridge circuit embedded into the cantilever. The self-sensing and actuating cantilever with an integrated Wheatstone bridge circuit was compared with a commercial self-sensing cantilever or self-sensing and actuating cantilever without an integrated Wheatstone bridge circuit. The measurement results have shown that sensing the signal to noise level and the minimum detectable deflection improved to 4.78 mV and 1.18 nm, respectively. We believe that this cantilever allows for easier system integration and miniaturization, provides better controllability and higher scan speeds, and offers the potential for full automation.

[1]  O. Hansen,et al.  Optimization of sensitivity and noise in piezoresistive cantilevers , 2002 .

[2]  Jong-Uk Bu,et al.  Fabrication and characteristics of piezoelectric PZT cantilever for high speed atomic force microscopy , 2001 .

[3]  Todd Sulchek,et al.  High speed tapping mode atomic force microscopy in liquid using an insulated piezoelectric cantilever , 2003 .

[4]  C. Hagleitner,et al.  Smart single-chip gas sensor microsystem , 2001, Nature.

[5]  Wan Y. Shih,et al.  Effect of length, width, and mode on the mass detection sensitivity of piezoelectric unimorph cantilevers , 2002 .

[6]  C. Quate,et al.  AUTOMATED PARALLEL HIGH-SPEED ATOMIC FORCE MICROSCOPY , 1998 .

[7]  N. Amer,et al.  Novel optical approach to atomic force microscopy , 1988 .

[8]  Teodor Gotszalk,et al.  AFM with piezoresistive Wheatstone bridge cantilever: noise performance and applications in contact and noncontact mode , 1996, Other Conferences.

[9]  S O Reza Moheimani,et al.  Invited review article: accurate and fast nanopositioning with piezoelectric tube scanners: emerging trends and future challenges. , 2008, The Review of scientific instruments.

[10]  Y. Yong,et al.  Simultaneous sensing and actuation with a piezoelectric tube scanner. , 2008, The Review of scientific instruments.

[11]  Philippe Lutz,et al.  Quasistatic displacement self-sensing method for cantilevered piezoelectric actuators. , 2009, The Review of scientific instruments.

[12]  Chengkuo Lee,et al.  Characterization of micromachined piezoelectric PZT force sensors for dynamic scanning force microscopy , 1997 .

[13]  C. Quate,et al.  Bringing scanning probe microscopy up to speed , 1999 .

[14]  Calvin F. Quate,et al.  Microfabrication of integrated scanning tunneling microscope , 1990 .

[15]  Beth L Pruitt,et al.  Design optimization of piezoresistive cantilevers for force sensing in air and water. , 2009, Journal of applied physics.

[16]  Calvin F. Quate,et al.  Atomic force microscopy for high speed imaging using cantilevers with an integrated actuator and sensor , 1996 .

[17]  P. Hansma,et al.  An atomic-resolution atomic-force microscope implemented using an optical lever , 1989 .

[18]  N. D. Rooij,et al.  Integrated atomic force microscopy array probe with metal-oxide-semiconductor field effect transistor stress sensor, thermal bimorph actuator, and on-chip complementary metal-oxide-semiconductor electronics , 2000 .

[19]  K Youcef-Toumi,et al.  Use of self-actuating and self-sensing cantilevers for imaging biological samples in fluid , 2009, Nanotechnology.

[20]  Beth L. Pruitt,et al.  Review: Semiconductor Piezoresistance for Microsystems , 2009, Proceedings of the IEEE.

[21]  C. Quate,et al.  High-speed atomic force microscopy in liquid , 2000 .

[22]  T. Kenny,et al.  1/f noise considerations for the design and process optimization of piezoresistive cantilevers , 2000, Journal of Microelectromechanical Systems.