Hydrodynamic Modeling of Gas/Particle Flows in Riser Reactors

Complex hydrodynamic behavior of circulating fluidized beds makes their scale-up very complicated. In particular, large-scale lateral solids segregation causes a complex two-phase flow pattern which influences significantly their performance. Lateral solids segregation has been attributed to direct collisional interactions between particles as well as to interaction between gas-phase eddies and dispersed particles. However, these phenomena have not been investigated thoroughly. This article discusses an advanced 2-D hydrodynamic model developed for circulating fluidized beds based on the two-fluid concept. Because theory to model the interaction between gas-phase eddies and dispersed particles is not available, turbulence was modeled on a macroscopic scale using a modified Prandtl mixing length model. To model the influence of direct particle-particle collisions the kinetic theory for granular flow was applied based on the Chapman-Enskog theory of dense gases. For model validation purposes, a cold flow circulating fluidized bed was employed in which sand was transported with air as fluidizing agent. The column is equipped with pressure transducers to measure the axial pressure profile and with a reflective optical fiber probe to measure the local solids concentration and axial solids velocity. Theoretically calculated solids concentration and axial solids velocity agree satisfactorily with experiment, especially when one realizes that the model contains no adjustable parameters. In general, however, the model slightly underpredicted the experimentally observed lateral solids segregation and yielded a more peaked velocity profile compared to its experimental counterpart

[1]  Dimitri Gidaspow,et al.  Dense, vertical gas‐solid flow in a pipe , 1992 .

[2]  B. Alder,et al.  Studies in Molecular Dynamics. II. Behavior of a Small Number of Elastic Spheres , 1960 .

[3]  Goodarz Ahmadi,et al.  An equation of state for dense rigid sphere gases , 1986 .

[4]  A. Berker,et al.  Hydrodynamics of gas-solid flow in a catalytic cracker riser: Implications for reactor selectivity performance , 1986 .

[5]  D. Jeffrey,et al.  Kinetic theories for granular flow: inelastic particles in Couette flow and slightly inelastic particles in a general flowfield , 1984, Journal of Fluid Mechanics.

[6]  R. Jackson,et al.  Gas‐particle flow in a vertical pipe with particle‐particle interactions , 1989 .

[7]  Yong Jin,et al.  Investigation on slip velocity distributions in the riser of dilute circulating fluidized bed , 1992 .

[8]  W.P.M. van Swaaij,et al.  Hydrodynamic modelling of gas-solid two-phase flows , 1995 .

[9]  S. Ogawa,et al.  On the equations of fully fluidized granular materials , 1980 .

[10]  Joachim Werther,et al.  SOLIDS CONCENTRATION AND VELOCITY PATTERNS IN CIRCULATING FLUIDIZED BEDS , 1988 .

[11]  J. Kuipers,et al.  A numerical model of gas-fluidized beds , 1992 .

[12]  J. Jenkins,et al.  A theory for the rapid flow of identical, smooth, nearly elastic, spherical particles , 1983, Journal of Fluid Mechanics.

[13]  Jam Hans Kuipers,et al.  Theoretical and experimental bubble formation at a single orifice in a two-dimensional gas-fluidized bed , 1991 .

[14]  D. Gidaspow,et al.  A bubbling fluidization model using kinetic theory of granular flow , 1990 .

[15]  Yoshinobu Morikawa,et al.  LDV measurements of an air-solid two-phase flow in a vertical pipe , 1984, Journal of Fluid Mechanics.

[16]  Daizo Kunii.  CHAPTER 8 – High-Velocity Fluidization , 1991 .

[17]  R. H. Fowler.  The Mathematical Theory of Non-Uniform Gases , 1939, Nature.

[18]  W.P.M. van Swaaij,et al.  Hydrodynamic modelling of circulating fluidised beds , 1994 .

[19]  Sankaran Sundaresan,et al.  Developing flow of a gas‐particle mixture in a vertical riser , 1993 .

[20]  Sankaran Sundaresan,et al.  Gas‐solid flow in vertical tubes , 1991 .

[21]  L. Schiller.  Uber die Grundlegenden Berechnungen bei der Schwerkraftaufbereitung , 1933 .

[22]  Michel Y. Louge,et al.  The role of particle collisions in pneumatic transport , 1989, Journal of Fluid Mechanics.

[23]  C. Wen.  Mechanics of Fluidization , 1966 .