It has previously been shown that the use of two-phase screw expanders in power generation cycles can achieve an increase in the utilisation of available energy from a low temperature heat source when compared with more conventional single-phase turbines. However, screw expander efficiencies are more sensitive to expansion volume ratio than turbines, and this increases as the expander inlet vapour dryness fraction decreases. For singlestage screw machines with low inlet dryness, this can lead to under expansion of the working fluid and low isentropic efficiency for the expansion process. The performance of the cycle can potentially be improved by using a two-stage expander, consisting of a low pressure machine and a smaller high pressure machine connected in series. By expanding the working fluid over two stages, the built-in volume ratios of the two machines can be selected to provide a better match with the overall expansion process, thereby increasing efficiency for particular inlet and discharge conditions. The mass flow rate though both stages must however be matched, and the compromise between increasing efficiency and maximising power output must also be considered. This research uses a rigorous thermodynamic screw machine model to compare the performance of single and two-stage expanders over a range of operating conditions. The model allows optimisation of the required intermediate pressure in the two- stage expander, along with the rotational speed and built-in volume ratio of both screw machine stages. The results allow the two-stage machine to be fully specified in order to achieve maximum efficiency for a required power output.
[1]
Ahmed Kovacevic,et al.
An Improved System for Power Recovery from Higher Enthalpy Liquid-Dominated Fields
,
2005
.
[2]
Nikola Stosic,et al.
Development of the Trilateral Flash Cycle System: Part 3: The Design of High-Efficiency Two-Phase Screw Expanders
,
1996
.
[3]
Nikola Stosic,et al.
Development and Optimization of Screw Machines With a Simulation Model—Part I: Profile Generation
,
1997
.
[4]
Ahmed Kovacevic,et al.
Screw Expanders Increase Output and Decrease the Cost of Geothermal Binary Power Plant Systems
,
2005
.
[5]
Nikola Stosic,et al.
Development and Optimization of Screw Machines With a Simulation Model—Part II: Thermodynamic Performance Simulation and Design Optimization
,
1997
.
[6]
Ian K. Smith,et al.
Power recovery from low-grade heat by means of screw expanders
,
2014
.
[7]
Nikola Stosic,et al.
Optimization of Screw Expanders for Power Recovery From Low-Grade Heat Sources
,
2014
.
[8]
Ahmed Kovacevic,et al.
POWER RECOVERY FROM LOW COST TWO-PHASE EXPANDERS
,
2003
.