Effect of pre-rolling path on mechanical properties of rolled ZK60 alloys

[1]  J. H. Chen,et al.  Structures and formation mechanisms of dislocation-induced precipitates in relation to the age-hardening responses of Al-Mg-Si alloys , 2020 .

[2]  Tingting Liu,et al.  Stability of twins in Mg alloys – A short review , 2020 .

[3]  Changlin Yang,et al.  Regulating Precipitates by Simple Cold Deformations to Strengthen Mg Alloys: A Review , 2019, Materials.

[4]  Qing Liu,et al.  Effects of precipitate type on twin/slip activity in ZK60 alloys and yield asymmetry , 2019, Journal of Alloys and Compounds.

[5]  W. Zhuang,et al.  Effect of deep surface rolling on microstructure and properties of AZ91 magnesium alloy , 2019, Transactions of Nonferrous Metals Society of China.

[6]  Qiang Yang,et al.  Improving age hardening response and mechanical properties of a new Mg-RE alloy via simple pre-cold rolling , 2019, Journal of Alloys and Compounds.

[7]  Xiang Chen,et al.  Grain refinement and mechanical properties of pure aluminum processed by accumulative extrusion bonding , 2019, Transactions of Nonferrous Metals Society of China.

[8]  Peng Chen,et al.  Formation of 60° 〈011̅0〉 boundaries between {101̅2} twin variants in deformation of a magnesium alloy , 2019, Materials Science and Engineering: A.

[9]  Lun Huang,et al.  Effect of Compressive Deformation on Wear Property of Extruded ZK60 Magnesium Alloy , 2018, Tribology Transactions.

[10]  Jiangfeng Song,et al.  An investigation on microstructure, texture and formability of AZ31 sheet processed by asymmetric porthole die extrusion , 2018 .

[11]  H. Kadiri,et al.  Effect of rare earth addition on {101̅2} twinning induced hardening in magnesium , 2018 .

[12]  Ruixiao Zheng,et al.  Improving tensile properties of Mg-Sn-Zn magnesium alloy sheets using pre-tension and ageing treatment , 2018 .

[13]  Yunping Li,et al.  Influence of aging on twin boundary strengthening in magnesium alloys , 2018 .

[14]  S. Ni,et al.  Improving the mechanical properties of a ZM61 magnesium alloy by pre-rolling and high strain rate rolling , 2018 .

[15]  Miaolin Feng,et al.  Mechanical behavior and microstructural evolution in rolled Mg-3Al-1Zn-0.5Mn alloy under large strain simple shear , 2018 .

[16]  Sung Hyuk Park,et al.  Effects of cold pre-forging on microstructure and tensile properties of extruded AZ80 alloy , 2017 .

[17]  Seong-Gu Hong,et al.  Anisotropic in-plane fatigue behavior of rolled magnesium alloy with {10−12} twins , 2017 .

[18]  Huihui Yu,et al.  The different hardening effects of tension twins on basal slip and prismatic slip in Mg alloys , 2017 .

[19]  L. Chai,et al.  Evolution of gradient microstructure in an extruded AZ31 rod during torsion and annealing and its effects on mechanical properties , 2017 .

[20]  Qing Liu,et al.  Enhancing the age-hardening response of rolled AZ80 alloy by pre-twinning deformation , 2017 .

[21]  Huihui Yu,et al.  The different effects of twin boundary and grain boundary on reducing tension-compression yield asymmetry of Mg alloys , 2016, Scientific Reports.

[22]  F. Pan,et al.  The yield asymmetry and precipitation behavior of pre-twinned ZK60 alloy , 2016 .

[23]  T. Sakai,et al.  Enhanced ductility and reduced asymmetry of Mg–2Al–1Zn alloy plate processed by torsion and annealing , 2015 .

[24]  Q. Liu,et al.  Dependence of tensile and compressive deformation behavior on aging precipitation in rolled ZK60 alloys , 2015 .

[25]  M. Jain,et al.  Large deformation of magnesium sheet at room temperature by preform annealing, part II: “Bending” , 2014 .

[26]  Tingting Liu,et al.  Improvement of formability and mechanical properties of magnesium alloys via pre-twinning: A review , 2014 .

[27]  Q. Liu,et al.  Twinning characteristic and variant selection in compression of a pre-side-rolled Mg alloy sheet , 2014 .

[28]  Liyun Sun,et al.  Enhancing the strength of rolled ZK60 alloys via the combined use of twinning deformation and aging treatment , 2013 .

[29]  Seong-Gu Hong,et al.  Enhanced stretch formability of rolled Mg–3Al–1Zn alloy at room temperature by initial {10–12} twins , 2013 .

[30]  Sung Hyuk Park,et al.  Improving the mechanical properties of extruded Mg–3Al–1Zn alloy by cold pre-forging , 2013 .

[31]  Seong-Gu Hong,et al.  In-plane anisotropic deformation behavior of rolled Mg–3Al–1Zn alloy by initial {10–12} twins , 2013 .

[32]  Hua Zhang,et al.  Improved formability of Mg-3Al-1Zn alloy by pre-stretching and annealing , 2012 .

[33]  Qing Liu,et al.  Improving tensile and compressive properties of magnesium alloy plates by pre-cold rolling , 2012 .

[34]  Qing Liu,et al.  Effect of crystal orientation on the mechanical properties and strain hardening behavior of magnesium alloy AZ31 during uniaxial compression , 2012 .

[35]  Qing Liu,et al.  Effect of initial texture on dynamic recrystallization of AZ31 Mg alloy during hot rolling , 2011 .

[36]  Dingfei Zhang,et al.  Effect of heat treatment on strain hardening of ZK60 Mg alloy , 2011 .

[37]  J. Robson,et al.  Effect of precipitate shape on slip and twinning in magnesium alloys , 2011 .

[38]  Surya R. Kalidindi,et al.  Deformation twinning in AZ31: Influence on strain hardening and texture evolution , 2010 .

[39]  Seong-Gu Hong,et al.  Role of {10–12} twinning characteristics in the deformation behavior of a polycrystalline magnesium alloy , 2010 .

[40]  A. Wilkinson,et al.  Electron backscatter diffraction study of dislocation content of a macrozone in hot-rolled Ti?6Al?4V alloy , 2010 .

[41]  M. Jahazi,et al.  Strain hardening behavior of a friction stir welded magnesium alloy , 2007 .

[42]  O. Ruano,et al.  Influence of texture and grain size on work hardening and ductility in magnesium-based alloys processed by ECAP and rolling , 2006 .

[43]  M. Barnett,et al.  Influence of grain size on the compressive deformation of wrought Mg–3Al–1Zn , 2004 .

[44]  K. Chawla,et al.  Mechanical Behavior of Materials , 1998 .

[45]  B. Song.  Research progress of strain hardening behavior at room temperature in wrought magnesium alloys , 2014 .

[46]  U. F. Kocks.  Thermodynamics and kinetics of slip , 1975 .