Hydrophilic modification of polyethersulfone membranes by low temperature plasma-induced graft polymerization

A complete and permanent hydrophilic modification of polyethersulfone (PES) membranes is achieved by argon plasma treatment followed by polyacrylic acid (PAA) grafting in vapor phase. Both Ar plasma treatment alone and post-PAA grafting rendered a complete hydrophilicity to the PES membranes. The hydrophilicity of the membranes treated with only the Ar plasmas is not, however, permanent. In contrast, the PES membranes treated with Ar plasma and subsequent acrylic acid (AA) grafting are permanently hydrophilic. High energy resolution X-ray photoelectron spectroscopy (XPS) confirmed the grafting of PAA to all surfaces of the membrane. Furthermore, water bubble point measurements remain unaffected. The pore sizes of the grafted membranes at higher grafting yield are slightly decreased. The modified membranes are less susceptible to protein fouling than the unmodified membranes and the pure water flux for the modified membranes was tremendously increased by plasma treatment. Furthermore, the modified membranes are easier to clean and required little caustic to recover permeation flux.

[1]  B. Gupta,et al.  Plasma-induced graft polymerization of acrylic acid onto poly(ethylene terephthalate) films: characterization and human smooth muscle cell growth on grafted films. , 2001, Biomaterials.

[2]  G. Belfort,et al.  Development of a novel photochemical technique for modifying poly (arylsulfone) ultrafiltration membranes , 1995 .

[3]  C. Kao,et al.  Plasma-induced grafted polymerization of acrylic acid and subsequent grafting of collagen onto polymer film as biomaterials. , 1996, Biomaterials.

[4]  G. Ellinghorst,et al.  Tailoring of ultrafiltration membranes by plasma treatment and their application for the desalination and concentration of water-soluble organic substances , 1988 .

[5]  Y. Lee,et al.  Plasma surface graft of acrylic acid onto a porous poly(vinylidene fluoride) membrane and its riboflavin permeation , 1996 .

[6]  M. Wahlgren,et al.  A rheological screening method for membrane modifying polymers , 1990 .

[7]  R. Nuzzo,et al.  Preparation and characterization of functionalized polyethylene surfaces , 1984 .

[8]  G. Belfort,et al.  Surface modification of ultrafiltration membranes by low temperature plasma. I. Treatment of polyacrylonitrile , 1995 .

[9]  C. Kao,et al.  Preparation and characterization of a homobifunctional silicone rubber membrane grafted with acrylic acid via plasma‐induced graft copolymerization , 1996 .

[10]  R. L. Valentine,et al.  Removal of suspended clay from water using transmembrane pressure pulsed microfiltration , 1999 .

[11]  G. Belfort,et al.  Surface modification of ultrafiltration membranes by low temperature plasma II. Graft polymerization onto polyacrylonitrile and polysulfone , 1996 .

[12]  D. Castner,et al.  Comparison of Pulsed and Continuous-Wave Deposition of Thin Films from Saturated Fluorocarbon/H2 Inductively Coupled rf Plasmas , 1997 .

[13]  G. Belfort,et al.  Evaluation of photochemically modified poly (arylsulfone) ultrafiltration membranes , 1995 .

[14]  T. Robbertsen,et al.  The anti-fouling action of polymers preadsorbed on ultrafiltration and microfiltration membranes , 1993 .

[15]  K. Olafsen,et al.  Modification of polyolefin surfaces by plasma-induced grafting , 1996 .

[16]  D. Briggs,et al.  High resolution monochromated X-ray photoelectron spectroscopy of organic polymers: A comparison between solid state data for organic polymers and gas phase data for small molecules , 1992 .

[17]  Noguchi,et al.  Electron Spin Resonance Study of the Special Features of Plasma-Induced Radicals and Their Corresponding Peroxy Radicals in Polytetrafluoroethylene. , 1991 .

[18]  L. Gerenser.  X-Ray photoemission study of plasma modified polyethylene surfaces , 1987 .

[19]  Michelle L. Steen,et al.  Identification of Gas-Phase Reactive Species and Chemical Mechanisms Occurring at Plasma−Polymer Surface Interfaces , 2001 .

[20]  Y. Hsieh,et al.  Residual reactivity for surface grafting of acrylic acid on argon glow-discharged poly(ethylene terephthalate) (PET) films , 1991 .

[21]  F. Vigo,et al.  Poly(vinyl chloride) ultrafiltration membranes modified by high frequency discharge treatment , 1988 .

[22]  J. Mano,et al.  Some comments on the significance of the compensation effect observed in thermally stimulated current experiments , 1997 .

[23]  L. Schlapbach,et al.  Creation of a conductive surface layer on polypropylene samples by low‐pressure plasma treatments , 1995 .

[24]  G. Belfort,et al.  Photoinduced grafting of ultrafiltration membranes: comparison of poly(ether sulfone) and poly(sulfone) , 2001 .

[25]  Y. Ikada,et al.  GRAFT COPOLYMERIZATION OF ACRYLAMIDE ONTO A POLYETHYLENE SURFACE PRETREATED WITH GLOW DISCHARGE , 1986 .

[26]  G. Belfort,et al.  Surface modification of poly(ether sulfone) ultrafiltration membranes by low-temperature plasma-induced graft polymerization , 1999 .

[27]  Grafting of acrylic acid onto corona-treated polyethylene surfaces , 1992 .

[28]  G. Belfort,et al.  Photochemical modification of 10 kDa polyethersulfone ultrafiltration membranes for reduction of biofouling , 1999 .

[29]  A. Michaels.  Membranes, membrane processes, and their applications: Needs, unsolved problems, and challenges of the 1990's , 1990 .

[30]  J. Feijen,et al.  Introduction of functional groups on polyethylene surfaces by a carbon dioxide plasma treatment , 1995 .

[31]  Eberhard Staude,et al.  Surface modification of polysulfone ultrafiltration membranes and fouling by BSA solutions , 1997 .

[32]  Sung Soo Kim,et al.  Surface modification of polypropylene membrane by low-temperature plasma treatment , 2001 .

[33]  David G. Castner,et al.  Low temperature plasma treatment of asymmetric polysulfone membranes for permanent hydrophilic surface modification , 2001 .

[34]  G. Belfort,et al.  Intermolecular forces between proteins and polymer films with relevance to filtration , 1997 .

[35]  C. Kao,et al.  Artificial cornea: surface modification of silicone rubber membrane by graft polymerization of pHEMA via glow discharge. , 1996, Biomaterials.

[36]  Y. Hsieh,et al.  Argon glow discharge and vapor‐phase grafting of vinyl monomers on wettability of polyethylene , 1997 .

[37]  I. Gancarz,et al.  Modification of polysulfone membranes. 2. Plasma grafting and plasma polymerization of acrylic acid , 1999 .

[38]  T. Matsuura,et al.  The effect of fluorinated surface modifying macromolecules on the surface morphology of polyethersulfone membranes , 2000, Journal of biomaterials science. Polymer edition.

[39]  Michelle L. Steen,et al.  Hydrophilic modification of polymeric membranes by low temperature H2O plasma treatment , 2002 .

[40]  L. Zeman.  Adsorption effects in rejection of macromolecules by ultrafiltration membranes , 1983 .

[41]  Z. Osawa,et al.  Effect of ageing atmospheres on the changes in surface free energies of oxygen plasma-treated polyethylene films , 1994 .