Fault modeling of RF blocks based on noise analysis

The paper addresses spot defects in CMOS RF blocks. In a softer resistive form they degrade the circuit performance such as noise figure (NF) and gain. The NF considered here is the test response. Based on a noisy two-port model an impact of the generic faults is analyzed. A practical example of a CMOS mixer supports this analysis. Discussed is also effect of masking by the circuit tolerances. The detectability threshold for the generic faults is captured assuming Gaussian distribution for the two-port parameters. The analysis reveals both strength and weakness of the presented test approach.

[1]  Y. Xing.  Defect-oriented testing of mixed-signal ICs: some industrial experience , 1998, Proceedings International Test Conference 1998 (IEEE Cat. No.98CH36270).

[2]  Doris Lupea,et al.  RF-BIST: loopback spectral signature analysis , 2003, 2003 Design, Automation and Test in Europe Conference and Exhibition.

[3]  Bozena Kaminska,et al.  Closing the gap between analog and digital testing , 2001, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..

[4]  T. R. Viswanathan,et al.  Integrated circuit testing for quality assurance in manufacturing: history, current status, and future trends , 1997 .

[5]  Michael J. Ohletz.  Realistic faults mapping scheme for the fault simulation of integrated analogue CMOS circuits , 1996, Proceedings International Test Conference 1996. Test and Design Validity.

[6]  Manoj Sachdev,et al.  Industrial relevance of analog IFA: a fact or a fiction , 1995, Proceedings of 1995 IEEE International Test Conference (ITC).

[7]  Jerzy Dabrowski.  BiST model for IC RF-transceiver front-end , 2003, Proceedings 18th IEEE Symposium on Defect and Fault Tolerance in VLSI Systems.