Field and laboratory assessments of the friction coefficient at a railhead

The aim of this work was to prove that the oil applied to the wheel flange using on-board lubricators not only alters the friction coefficient between wheel and rail but also influences the braking and acceleration performance of trains on one of the lines of the metro in Mexico City. A series of tests were carried out in the presence of an oil lubricant, both in the laboratory and in the field, using a pendulum tester. It was observed that the oil migrated from the rail corner to the top of the rail. In another set of experiments, water was sprayed onto the lubricant on the top of the rail. The results indicated that under these conditions, the friction coefficient has a low value in rail sections where a high value of the friction coefficient is required. Tests with water/oil mixtures presented similar levels of friction to the oil-only tests. A set of tests were performed after the rail surface was cleaned and the oil lubricant and water were applied together. The laboratory and field tests showed similar behaviour trends for the friction coefficient. The pendulum method can be used to assess railhead friction on short-length sections of rail. Points are made regarding the conditioning of the pads and calibration of the pendulum arm.

[1]  K Nagase,et al.  A Study of Adhesion Between the Rails and Running Wheels on Main Lines: Results of Investigations by Slipping Adhesion Test Bogie , 1989 .

[2]  Yoshihiro Suda,et al.  Development of onboard friction control , 2005 .

[3]  I. J. McEwen,et al.  WHEEL/RAIL ADHESION-BOUNDARY LUBRICATION BY OILY FLUIDS , 1975 .

[4]  H Harrison,et al.  Recent developments in coefficient of friction measurements at the rail/wheel interface , 2002 .

[5]  Xuesong Jin,et al.  Wheel/rail adhesion and analysis by using full scale roller rig , 2002 .

[6]  John H. Beynon,et al.  The effect of intermittent lubrication on the fatigue life of pearlitic rail steel in rolling-sliding contact , 2000 .

[7]  Ulf Olofsson,et al.  An alternative method for the assessment of railhead traction , 2011 .

[8]  E. A. Gallardo-Hernández,et al.  Effect of oil and water mixtures on adhesion in the wheel/rail contact , 2009 .

[9]  Saeed Abbasi,et al.  The modification of a slip resistance meter for measurement of railhead adhesion , 2013 .

[10]  Ulf Olofsson,et al.  Seizure and wear rate testing of wheel–rail contacts under lubricated conditions using pin-on-disc methodology , 2008 .

[11]  R. Dwyer-Joyce,et al.  Effect of contaminants on wear, fatigue and traction , 2009 .

[12]  Xuesong Jin,et al.  Adhesion experiment on a wheel/rail system and its numerical analysis , 2004 .

[13]  E. A. Gallardo-Hernández,et al.  Twin disc assessment of wheel/rail adhesion , 2008 .

[14]  A. Lubrecht,et al.  Film thickness calculation in elasto-hydrodynamic lubricated line and elliptical contacts: The Dowson, Higginson, Hamrock contribution , 2009 .