Propagation of Motor‐Side‐Originated Conducted Emission Toward the Power Grid

The most significant part of conducted emission in an ASD is initially generated at the output side of frequency converter. Majority of standard regulations establish emission limits primarily for the grid side of an ASD. Therefore, understanding of conducted emission transfer from the output side to the power grid is fundamental issue for decreasing final emission of the ASD into the power grid. In this chapter the importance of parameters of DC bus link, as one of the most essential for conducted emission propagation, internal component of ASD, is discussed. Analysis high frequency CM parasitic currents transfer phenomena based on simplified circuit models of most commonly applied ASDs is presented. The influence of difficult to avoid parasitic capacitances of internal components of FCs are underlined with correlation to intensionally implemented capacitors and DC chokes as extra components used for limitation of conducted emission. Results of the theoretical analysis as well as experimental verification are presented.

[1]  R. M. Tallam,et al.  System Design of Adjustable Speed Drives, Part 1: Equipment and Load Interactions , 2012, IEEE Industry Applications Magazine.

[2]  Jian Sun,et al.  Characterization of IGBT modules for system EMI simulation , 2010, 2010 Twenty-Fifth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[3]  Jian Sun,et al.  Conducted Common-Mode EMI Reduction by Impedance Balancing , 2012, IEEE Transactions on Power Electronics.

[4]  Robert Smolenski.  EMI Measuring Procedures in Smart Grids , 2012 .

[5]  J.A. Ferreira,et al.  Common-Mode DC-Bus Filter Design for Variable-Speed Drive System via Transfer Ratio Measurements , 2009, IEEE Transactions on Power Electronics.

[6]  D. W. P. Thomas,et al.  Practical measure of cable coupling , 2009, 2009 International Conference on Electromagnetics in Advanced Applications.

[7]  Z. John Shen,et al.  Extracting parasitic inductances of IGBT power modules with two-port S-parameter measurement , 2017, 2017 IEEE Transportation Electrification Conference and Expo (ITEC).

[8]  Philippe Baudesson,et al.  A New Carrier-Based PWM Providing Common-Mode-Current Reduction and DC-Bus Balancing for Three-Level Inverters , 2007, IEEE Transactions on Industrial Electronics.

[9]  Jian Sun,et al.  DC bus grounding capacitance optimizatio for common-mode EMI minimization , 2011, 2011 Twenty-Sixth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[10]  Piotr J. Chrzan,et al.  Quasi-Resonant DC-Link Inverter With a Reduced Number of Active Elements , 2007, IEEE Transactions on Industrial Electronics.

[11]  Duan Jiandong,et al.  Prediction Model of Conducted Common-Mode EMI in PWM Motor Drive System , 2010, 2010 First International Conference on Pervasive Computing, Signal Processing and Applications.