An experimental and numerical study of the behaviour of glass fibre reinforced plastics (GRP) short columns at elevated temperatures

Abstract This paper presents the results of experimental and numerical studies to determine the compression strength of short glass reinforced plastic (GRP) C-shaped channels at different elevated temperatures. Several possible compressive testing methods were explored to obtain the compression strength of the material. Eventually a pair of grooved steel end plates was used to restrain the test specimen under compression. Using the measured longitudinal compressive strengths of the material from this study and the measured longitudinal Young modulus from a previous study by the same research group, a numerical modelling study utilising the commercial finite element package ABAQUS has been performed to simulate the compressive behaviour of the test columns at elevated temperatures. Estimation of other material properties has been made to enable the numerical simulations. Comparison between the numerical and test results confirms that it is suitable to use ABAQUS and the adopted material properties to model GRP columns at elevated temperatures.

[1]  J. Clarke.  Structural design of polymer composites : EUROCOMP design code and handbook , 1996 .

[2]  D. J. Wilkins,et al.  Kink-Band Failure Analysis of Thick Composites in Compression , 1993 .

[3]  Isaac M Daniel,et al.  Engineering Mechanics of Composite Materials , 1994 .

[4]  Ever J. Barbero,et al.  Prediction and measurement of the post-critical behavior of fiber-reinforced composite columns , 1998 .

[5]  B. Harris,et al.  Compression strength of carbon, glass and Kevlar-49 fibre reinforced polyester resins , 1980 .

[6]  B. Harris,et al.  The compression strength of composites with kinked, misaligned and poorly adhering fibres , 1981 .

[7]  John S. Tomblin,et al.  Experimental determination of the compressive strength of pultruded structural shapes , 1999 .

[8]  Marios K. Chryssanthopoulos,et al.  Numerical simulation of glass-reinforced plastic cylinders under axial compression , 2001 .

[9]  Lawrence C. Bank,et al.  Local buckling of pultruded beams — nonlinearity, anisotropy and inhomogeneity , 1995 .

[10]  Olli Kaitila.  Imperfection sensitivity analysis of lipped channel columns at high temperatures , 2002 .

[11]  E. Barbero.  Introduction to Composite Materials Design , 1998 .

[12]  A. Maji,et al.  Evaluation of Pultruded FRP Composites for Structural Applications , 1997 .

[13]  R. M. Mayer,et al.  Design Data for Reinforced Plastics: A guide for engineers and designers , 1993 .

[15]  Anthony M. Waas,et al.  Compressive failure of composites, part I: Testing and micromechanical theories , 1996 .

[16]  L. Hollaway,et al.  Handbook of polymer composites for engineers , 1994 .

[17]  M. Shuart,et al.  An evaluation of the sandwich beam compression test method for composites , 1981 .

[18]  Js Berg,et al.  An Evaluation of Composite Material Compression Test Methods , 1989 .

[19]  R. J. Brooks,et al.  Lateral buckling of pultruded GRP I-section cantilevers , 1995 .

[20]  R. Gibson.  Principles of Composite Material Mechanics , 1994 .

[21]  B. Harris,et al.  FACTORS AFFECTING THE COMPRESSION STRENGTH OF ALIGNED FIBRE COMPOSITES , 1980 .

[22]  Et Camponeschi,et al.  Compression of Composite Materials: A Review , 1987 .

[23]  P. K. Dutta,et al.  Low-Temperature Compressive Strength of Glass-Fiber-Reinforced Polymer Composites , 1994 .