Mechanical sensorless maximum power tracking control for direct-drive PMSG wind turbines

Wind turbine generators (WTGs) are usually equipped with mechanical sensors to measure wind speed and rotor position for system control, monitoring, and protection. The use of mechanical sensors increases the cost and hardware complexity and reduces the reliability of the WTG systems. This paper proposes a mechanical sensorless maximum power tracking control for wind turbines directly driving permanent magnetic synchronous generators (PMSGs). In the proposed algorithm, the PMSG rotor position is estimated from the measured stator voltages and currents by using a sliding mode observer (SMO). The wind turbine shaft speed is estimated from the PMSG back electromotive force (EMF) using a model adaptive reference system (MRAS) observer. A back propagation artificial neural network (BPANN) is designed to generate the optimal shaft speed reference in real time by using the estimated turbine shaft speed and the measured PMSG electrical power. A control system is developed for the PMSG wind turbine to continuously track the optimal shaft speed reference to generate the maximum electrical power without using any wind speed or rotor position sensors. The validity of the proposed control algorithm is shown by simulation studies on a 3-kW PMSG wind turbine and experimental results on a practical 300-W PMSG wind turbine.

[1]  M. Chinchilla,et al.  Control of permanent-magnet generators applied to variable-speed wind-energy systems connected to the grid , 2006, IEEE Transactions on Energy Conversion.

[2]  Anders Grauers,et al.  Efficiency of three wind energy generator systems , 1996 .

[3]  Tomonobu Senjyu,et al.  Investigation of influences of various losses on electromagnetic torque for surface-mounted permanent magnet synchronous motors , 2003 .

[4]  Jang-Mok Kim,et al.  Sensorless control of PMSM in high speed range with iterative sliding mode observer , 2004, Nineteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2004. APEC '04..

[5]  Tadashi Fukao,et al.  Robust speed identification for speed sensorless vector control of induction motors , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[6]  Wei Qiao,et al.  Dynamic modeling and control of doubly fed induction generators driven by wind turbines , 2009, 2009 IEEE/PES Power Systems Conference and Exposition.

[7]  Anjan Bose,et al.  Stability Simulation Of Wind Turbine Systems , 1983, IEEE Transactions on Power Apparatus and Systems.

[8]  Stephen J. Chapman,et al.  Electric Machinery Fundamentals , 1991 .

[9]  Dong-Choon Lee,et al.  Sensorless speed control of nonsalient permanent-magnet synchronous motor using rotor-position-tracking PI controller , 2006, IEEE Trans. Ind. Electron..

[10]  Liuchen Chang,et al.  An intelligent maximum power extraction algorithm for inverter-based variable speed wind turbine systems , 2004 .

[11]  K. Tan,et al.  Optimum control strategies in energy conversion of PMSG wind turbine system without mechanical sensors , 2004, IEEE Transactions on Energy Conversion.

[12]  Longya Xu,et al.  Position Sensorless Control of PMSM Based on a Novel Sliding Mode Observer over Wide Speed Range , 2006, 2006 CES/IEEE 5th International Power Electronics and Motion Control Conference.

[13]  H. Siguerdidjane,et al.  Nonlinear Control of Variable Speed Wind Turbines without wind speed measurement , 2005, Proceedings of the 44th IEEE Conference on Decision and Control.

[14]  Changsheng Li,et al.  A sliding mode observer for sensorless control of permanent magnet synchronous motors , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[15]  Bimal K. Bose,et al.  Fuzzy logic based intelligent control of a variable speed cage machine wind generation system , 1995 .

[16]  Ali Keyhani,et al.  A comparative study of rotor flux based MRAS and back EMF based MRAS speed estimators for speed sensorless vector control of induction machines , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[17]  R.G. Harley,et al.  Wind Speed Estimation Based Sensorless Output Maximization Control for a Wind Turbine Driving a DFIG , 2008, IEEE Transactions on Power Electronics.

[18]  T. Tanaka,et al.  Output control by hill-climbing method for a small scale wind power generating system , 1997 .