Synthesis of surface molecular imprinted TiO2/graphene photocatalyst and its highly efficient photocatalytic degradation of target pollutant under visible light irradiation

Abstract The molecular imprinted TiO2/graphene photocatalyst (MIP-TiO2/GR) was successfully prepared with bisphenol A (BPA) as the template molecule (target pollutant) and o-phenylenediamine (OPDA) as functional monomers by the surface molecular imprinting method. The combination between BPA and OPDA led to the formation of the precursor, and the subsequent polymerization of OPDA initiated by ultraviolet radiation can ensure the realization of MIP-TiO2/GR. The samples were characterized by SEM, EDS, XRD, BET, UV–vis DRS and Zeta potential. In addition, adsorption capacities, adsorption selectivity and visible light photocatalytic performances of MIP-TiO2/GR and non-imprinted TiO2/graphene (NIP-TiO2/GR) were evaluated. Moreover, the effects of pH and initial BPA concentration on removal efficiency of BPA were also investigated. The results showed that MIP-TiO2/GR exhibited better adsorption capacity and adsorption selectivity towards the template molecule compared to NIP-TiO2/GR due to the imprinted cavities on the surface of MIP-TiO2/GR. Moreover, the photocatalytic activity of MIP-TiO2/GR toward the target molecules was stronger than that of NIP-TiO2/GR as a result of large adsorption capacity to target molecules and narrow band gap energy on MIP-TiO2/GR. Therefore, modifying the photocatalyst by the surface molecular imprinting is a promising method to improve the molecule recognition and photocatalytic efficiency of photocatalyst for target pollutant.

[1]  P. Xu,et al.  Controlled synthesis of ordered mesoporous TiO2-supported on activated carbon and pore-pore synergistic photocatalytic performance , 2015 .

[2]  Juan Yang,et al.  Synthesis, characterization and degradation of Bisphenol A using Pr, N co-doped TiO2 with highly visible light activity , 2011 .

[3]  J. Weber,et al.  UV–vis versus visible degradation of Acid Orange II in a coupled CdS/TiO2 semiconductors suspension , 2006 .

[4]  Z. Yaakob,et al.  Degradation and mineralization of methylene blue using a heterogeneous photo-Fenton catalyst under visible and solar light irradiation , 2016 .

[5]  Lin Sun,et al.  Structural, magnetic and optical properties of Ni-doped TiO2 thin films deposited on silicon(1 0 0) substrates by sol–gel process , 2013 .

[6]  Xiantao Shen,et al.  Enhanced photocatalytic degradation and selective removal of nitrophenols by using surface molecular imprinted titania. , 2008, Environmental science & technology.

[7]  Vincent G. Gomes,et al.  Hybrid nanostructures based on titanium dioxide for enhanced photocatalysis , 2015 .

[8]  M. Ma,et al.  Facile synthesis of magnetically recoverable Fe3O4/Al2O3/molecularly imprinted TiO2 nanocomposites and its molecular recognitive photocatalytic degradation of target contaminant , 2015 .

[9]  X. Bai,et al.  Uniformly distributed anatase TiO2 nanoparticles on graphene: Synthesis, characterization, and photocatalytic application , 2014 .

[10]  S. Baup,et al.  Sonochemical removal of naphthol blue black azo dye: influence of parameters and effect of mineral ions , 2013, International Journal of Environmental Science and Technology.

[11]  Xiantao Shen,et al.  Synthesis of molecular imprinted polymer coated photocatalysts with high selectivity. , 2007, Chemical communications.

[12]  R. Leary,et al.  Carbonaceous nanomaterials for the enhancement of TiO2 photocatalysis , 2011 .

[13]  C. Au,et al.  Sol-hydrothermal synthesis of inorganic-framework molecularly imprinted TiO2/SiO2 nanocomposite and its preferential photocatalytic degradation towards target contaminant. , 2014, Journal of hazardous materials.

[14]  Guangming Zeng,et al.  Nanoporous Au-based chronocoulometric aptasensor for amplified detection of Pb(2+) using DNAzyme modified with Au nanoparticles. , 2016, Biosensors & bioelectronics.

[15]  W. Lu,et al.  Improved synthesis of graphene oxide. , 2010, ACS nano.

[16]  Uraiwan Sirimahachai,et al.  Recyclable UV and visible light photocatalytically active amorphous TiO2 doped with M (III) ions (M = Cr and Fe) , 2011 .

[17]  Xiaoping Wang,et al.  Solvothermal synthesis of C–N codoped TiO2 and photocatalytic evaluation for bisphenol A degradation using a visible-light irradiated LED photoreactor , 2010 .

[18]  W. C. Finney,et al.  Formation of hydroxyl radicals, hydrogen peroxide and aqueous electrons by pulsed streamer corona discharge in aqueous solution , 1995 .

[19]  F. Beltrán,et al.  Simulated solar-light assisted photocatalytic ozonation of metoprolol over titania-coated magnetic activated carbon , 2012 .

[20]  Jin Suk Chung,et al.  The role of graphene oxide content on the adsorption-enhanced photocatalysis of titanium dioxide/graphene oxide composites , 2011 .

[21]  Jianming Pan,et al.  Selective adsorption and separation of BPA from aqueous solution using novel molecularly imprinted polymers based on kaolinite/Fe3O4 composites , 2011 .

[22]  J. Jang,et al.  Synthesis of TiO2 nanorod-decorated graphene sheets and their highly efficient photocatalytic activities under visible-light irradiation. , 2012, Journal of hazardous materials.

[23]  Xubiao Luo,et al.  Preparation of conductive polypyrrole/TiO2 nanocomposite via surface molecular imprinting technique and its photocatalytic activity under simulated solar light irradiation , 2012 .

[24]  Misaki Ito,et al.  Adsorptive removal and photocatalytic decomposition of sulfamethazine in secondary effluent using TiO2–zeolite composites , 2013, Environmental Science and Pollution Research.

[25]  Jianfu Zhao,et al.  Photocatalytic degradation of Bisphenol A (BPA) using immobilized TiO2 and UV illumination in a horizontal circulating bed photocatalytic reactor (HCBPR). , 2009, Journal of hazardous materials.

[26]  J. Lian,et al.  Photocatalytic activity of TiO2 films with mixed anatase and rutile structures prepared by pulsed laser deposition , 2008 .

[27]  G. Achari,et al.  Some Observations on the Development of Superior Photocatalytic Systems for Application to Water Purification by the “Adsorb and Shuttle” or the Interphase Charge Transfer Mechanisms , 2014, Molecules.

[28]  Yongjiao Sun,et al.  Preparation and Evaluation of Water-Compatible Surface Molecularly Imprinted Polymers for Selective Adsorption of Bisphenol A from Aqueous Solution , 2014 .

[29]  G. Marcì,et al.  PREPARATION, CHARACTERIZATION AND PHOTOCATALYTIC ACTIVITY OF POLYCRYSTALLINE ZNO/TIO2 SYSTEMS. 2. SURFACE, BULK CHARACTERIZATION, 4-NITROPHENOL PHOTODEGRADATION IN LIQUID–SOLID REGIME , 2001 .

[30]  Xiaofei Yang,et al.  Graphene-spindle shaped TiO₂ mesocrystal composites: facile synthesis and enhanced visible light photocatalytic performance. , 2013, Journal of hazardous materials.

[31]  Xiantao Shen,et al.  Selective photocatalysis mediated by magnetic molecularly imprinted polymers , 2012 .

[32]  Jun Ma,et al.  The selective binding character of a molecular imprinted particle for Bisphenol A from water. , 2014, Water research.

[33]  P. Kamat,et al.  Enhanced Rates of Photocatalytic Degradation of an Azo Dye Using SnO2/TiO2 Coupled Semiconductor Thin Films. , 1995, Environmental science & technology.

[34]  D. Gazzoli,et al.  Photo-electro catalytic oxidation of aromatic alcohols on visible light-absorbing nitrogen-doped TiO2 , 2010 .

[35]  Chiung-Fen Chang,et al.  Titania-Coated Magnetic Composites as Photocatalysts for Phthalate Photodegradation , 2011 .

[36]  P. Kosky,et al.  The aqueous phase in the interfacial synthesis of polycarbonates. Part 1. Ionic equilibria and experimental solubilities in the BPA-sodium hydroxide-water system , 1991 .

[37]  Huilong Wang,et al.  Synthesis and photocatalytic activity of poly-o-phenylenediamine (PoPD)/TiO2 composite under VIS-light irradiation , 2012 .

[38]  Shoji Yamanaka,et al.  Enhanced photocatalytic decomposition of 4-nonylphenol by surface-organografted TiO2: a combination of molecular selective adsorption and photocatalysis , 2004 .

[39]  Chang-Tang Chang,et al.  Photocatalytic reduction of CO2 to energy products using Cu–TiO2/ZSM-5 and Co–TiO2/ZSM-5 under low energy irradiation , 2015 .

[40]  W. Zhiqiang,et al.  Enhancing the photocatalytic degradation of salicylic acid by using molecular imprinted S-doped TiO2 under simulated solar light , 2014 .

[41]  C. Au,et al.  Facile one-step synthesis of inorganic-framework molecularly imprinted TiO2/WO3 nanocomposite and its molecular recognitive photocatalytic degradation of target contaminant. , 2013, Environmental science & technology.

[42]  Guangming Zeng,et al.  Efficacy of carbonaceous nanocomposites for sorbing ionizable antibiotic sulfamethazine from aqueous solution. , 2016, Water research.

[43]  Chun-jing Zhang,et al.  Enhanced removal of bilirubin on molecularly imprinted titania film. , 2011, Colloids and surfaces. B, Biointerfaces.

[44]  G. Zeng,et al.  Combined removal of di(2-ethylhexyl)phthalate (DEHP) and Pb(II) by using a cutinase loaded nanoporous gold-polyethyleneimine adsorbent , 2014 .