A Mixed-Phase SiOx Hole Selective Junction Compatible With High Temperatures Used in Industrial Solar Cell Manufacturing

We present a p-type passivating rear contact that complies with integration into standard solar cell manufacturing with phosphorus-diffused front side. Our contact structure consists of a thin SiOx tunneling layer grown by wet chemistry and a stack of layers deposited in one single run by plasma-enhanced chemical vapor deposition. The layers of the stack were tailored to protect the interfacial oxide layer, to act as a source for boron diffusion into the wafer and to connect to the external metallisation with low contact resistivity. We found that this stack tolerated annealing at 900 °C over a wide range of dwell times: for 15 min anneals we obtained dark saturation current densities (Jo) as low as 10 fA·cm−2 (after hydrogenation) and after 12-fold increase of the annealing time to 180 min, J0 was only increased to 12 fA·cm−2. These values corresponded to implied open circuit voltages (iVoc) of 718 and 715 mV, respectively. To test passivating rear contacts under realistic operation conditions, we combined them with an n-type heterojunction into hybrid solar cells. With conversion efficiencies abovementioned 22% and Voc > 705 mV, these devices demonstrated high level of rear surface passivation. Finally, we demonstrated the integration of the hole selective rear contact with a POCl3 diffusion process. To this end, we added a phosphorus diffusion barrier to our layer stack by depositing one additional layer of amorphous SiOx on top of the stack. For symmetric samples with this layer structure on both sides, we observed iVoc values of 714 and 712 mV on n- and p-type silicon wafers after hydrogenation, respectively. Co-diffused cells with POCl3 front diffused emitter and rear passivating contact resulted so far in efficiencies of 20.4% and 20.1% for n- and p-type wafers, respectively.

[1]  B. Lim,et al.  For none, one, or two polarities—How do POLO junctions fit best into industrial Si solar cells? , 2019, Progress in Photovoltaics: Research and Applications.

[2]  Thomas G. Allen,et al.  Passivating contacts for crystalline silicon solar cells , 2019, Nature Energy.

[3]  T. Kluge,et al.  Investigation of 23% monoPoly Screen-Printed Silicon Solar Cells with an Industrial Rear Passivated Contact , 2019, 2019 IEEE 46th Photovoltaic Specialists Conference (PVSC).

[4]  C. Ballif,et al.  A passivating contact for silicon solar cells formed during a single firing thermal annealing , 2018, Nature Energy.

[5]  C. Ballif,et al.  Silicon heterojunction solar cells: Recent technological development and practical aspects - from lab to industry , 2018, Solar Energy Materials and Solar Cells.

[6]  C. Ballif,et al.  Recombination Analysis of Phosphorus-Doped Nanostructured Silicon Oxide Passivating Electron Contacts for Silicon Solar Cells , 2018, IEEE Journal of Photovoltaics.

[7]  C. Tool,et al.  Novel schemes of P+ polysi hydrogeneration implemented in industrial 6" bifacial front-and-rear passivating contacts solar cells , 2018 .

[8]  Josua Stückelberger.  Transparent Passivating Contacts for Front Side Application in Crystalline Silicon Solar Cells , 2018 .

[9]  C. Ballif,et al.  Interplay of annealing temperature and doping in hole selective rear contacts based on silicon-rich silicon-carbide thin films , 2017 .

[10]  S. Glunz,et al.  n-Type Si solar cells with passivating electron contact: Identifying sources for efficiency limitations by wafer thickness and resistivity variation , 2017 .

[11]  N. Wyrsch,et al.  Microcrystalline silicon carrier collectors for silicon heterojunction solar cells and impact on low-temperature device characteristics , 2017, 2017 IEEE 44th Photovoltaic Specialist Conference (PVSC).

[12]  K. Yoshikawa,et al.  Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26% , 2017, Nature Energy.

[13]  C. Ballif,et al.  Silicon-Rich Silicon Carbide Hole-Selective Rear Contacts for Crystalline-Silicon-Based Solar Cells. , 2016, ACS applied materials & interfaces.

[14]  A. Fejfar,et al.  Passivating electron contact based on highly crystalline nanostructured silicon oxide layers for silicon solar cells , 2016 .

[15]  A. Cuevas,et al.  Passivating contacts for silicon solar cells based on boron-diffused recrystallized amorphous silicon and thin dielectric interlayers , 2016 .

[16]  S. Glunz,et al.  The Irresistible Charm of a Simple Current Flow Pattern – 25% with a Solar Cell Featuring a Full-Area Back Contact , 2015 .

[17]  A. Rohatgi,et al.  730 mV implied Voc enabled by tunnel oxide passivated contact with PECVD grown and crystallized n+ polycrystalline Si , 2015, 2015 IEEE 42nd Photovoltaic Specialist Conference (PVSC).

[18]  E. Bugiel,et al.  Recombination behavior and contact resistance of n+ and p+ poly-crystalline Si/mono-crystalline Si junctions , 2014 .

[19]  S. Glunz,et al.  Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics , 2014 .

[20]  Benjamin G. Lee,et al.  Carrier-selective, passivated contacts for high efficiency silicon solar cells based on transparent conducting oxides , 2014, 2014 IEEE 40th Photovoltaic Specialist Conference (PVSC).

[21]  P. Cuony.  Optical Layers for Thin-film Silicon Solar Cells , 2011 .

[22]  C. Ballif,et al.  Mixed-phase p-type silicon oxide containing silicon nanocrystals and its role in thin-film silicon solar cells , 2010 .

[23]  N. Cherkashin,et al.  Imaging Si nanoparticles embedded in SiO(2) layers by (S)TEM-EELS. , 2008, Ultramicroscopy.

[24]  P. Altermatt,et al.  Excellent passivation of highly doped p-type Si surfaces by the negative-charge-dielectric Al2O3 , 2007 .

[25]  P. Altermatt,et al.  The surface recombination velocity at boron-doped emitters: Comparison between various passivation techniques , 2006 .

[26]  Takuya Kobayashi,et al.  Ultrathin silicon dioxide layers with a low leakage current density formed by chemical oxidation of Si , 2002 .

[27]  Jürgen Schumacher,et al.  Numerical modeling of highly doped Si:P emitters based on Fermi–Dirac statistics and self-consistent material parameters , 2002 .

[28]  R. M. Swanson,et al.  A 720 mV open circuit voltage SiOx:c‐Si:SiOx double heterostructure solar cell , 1985 .

[29]  N. G. Tarr.  A polysilicon emitter solar cell , 1985, IEEE Electron Device Letters.

[30]  R. M. Swanson,et al.  Measurement of the emitter saturation current by a contactless photoconductivity decay method , 1985 .

[31]  R. M. Swanson,et al.  SIPOS Heterojunction contacts to silicon , 1984, 1984 International Electron Devices Meeting.

[32]  M. A. Shibib,et al.  A minority-carrier transport model for polysilicon contacts to silicon bipolar devices, including solar cells , 1980, 1980 International Electron Devices Meeting.

[33]  L. Derick,et al.  Surface Protection and Selective Masking during Diffusion in Silicon , 1957 .

[34]  B. Bauer.  Equivalent Circuit of , 1955 .

[35]  F. M. Starr.  Equivalent circuits , 1932, Electrical Engineering.