Low-Power ASIC for Microwatt Electrostatic Energy Harvesters

This paper presents a technique for enhancing the power output from vibration-based charge-constrained electrostatic energy harvesters (EEHs). Starting from a diode-based charge pump and a buck converter stage with an inductive energy flyback scheme, a novel controller integrated circuit is proposed to monitor and control the charging/discharging events of the electrostatic converter. The fundamental challenges of designing self-powered event-synchronization circuits for charge-constrained EEHs are addressed. Synchronous energy conversion is accomplished with minimal power dissipation without the complexity of precise timing circuitry. Experimental results are presented for the design, implemented in AMI 0.7-μm high-voltage CMOS process, using a macroscale electrostatic converter prototype. The energy-harvesting circuit produces a measured 1.688 μW of power for a power investment of 417 nW. The measured power consumption associated with the on-chip controller unit is 24nW, approximately 1.42% of the total power harvested.

[1]  R. Jacob Baker,et al.  CMOS Circuit Design, Layout, and Simulation , 1997 .

[2]  Pedro Lluís Miribel-Català,et al.  A Multiharvested Self-Powered System in a Low-Voltage Low-Power Technology , 2011, IEEE Transactions on Industrial Electronics.

[3]  Timothy C. Green,et al.  Micro-machined variable capacitors for power generation , 2004 .

[4]  Erick O. Torres,et al.  Harvesting Ambient Kinetic Energy With Switched-Inductor Converters , 2011, IEEE Transactions on Circuits and Systems I: Regular Papers.

[5]  Eric M. Yeatman,et al.  Rolling Rod Electrostatic Microgenerator , 2009, IEEE Transactions on Industrial Electronics.

[6]  Ghislain Despesse,et al.  Design and fabrication of a new system for vibration energy harvesting , 2005 .

[7]  Dimitri Galayko,et al.  VHDL-AMS modeling of adaptive electrostatic harvester of vibration energy with dual-output DC-DC converter , 2009, 2009 IEEE Behavioral Modeling and Simulation Workshop.

[8]  Erick O. Torres,et al.  Self-Tuning Electrostatic Energy-Harvester IC , 2010, IEEE Transactions on Circuits and Systems II: Express Briefs.

[9]  Pedro Lluís Miribel-Català,et al.  Power-Conditioning Circuitry for a Self-Powered System Based on Micro PZT Generators in a 0.13-$\mu\hbox{m}$ Low-Voltage Low-Power Technology , 2008, IEEE Transactions on Industrial Electronics.

[10]  Jan M. Rabaey,et al.  A study of low level vibrations as a power source for wireless sensor nodes , 2003, Comput. Commun..

[11]  Anantha Chandrakasan,et al.  Vibration-to-electric energy conversion , 1999, Proceedings. 1999 International Symposium on Low Power Electronics and Design (Cat. No.99TH8477).

[12]  Mona Mostafa Hella,et al.  Analysis and Optimization of Asynchronously Controlled Electrostatic Energy Harvesters , 2012, IEEE Transactions on Industrial Electronics.

[13]  Raimundo Carlos Silvério Freire,et al.  Electrostatic vibration energy harvester with piezoelectric start-up generator , 2011, 2011 IEEE International Symposium of Circuits and Systems (ISCAS).

[14]  P. Miribel-Catala,et al.  Power conditioning circuitry for a self-powered mobile system based on an array of micro PZT generators in a 0.13μm technology , 2007, 2007 IEEE International Symposium on Industrial Electronics.

[15]  Jeffrey H. Lang,et al.  A variable-capacitance vibration-to-electric energy harvester , 2006, IEEE Transactions on Circuits and Systems I: Regular Papers.

[16]  Giulia Fanti,et al.  Wireless power transfer using weakly coupled magnetostatic resonators , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[17]  M. S. Moses,et al.  A MEMS sensor for low-frequency vibration energy harvesting , 2012, 2012 Microsystems for Measurement and Instrumentation (MAMNA).

[18]  Peng Zeng,et al.  Kinetic Energy Harvesting Using Piezoelectric and Electromagnetic Technologies—State of the Art , 2010, IEEE Transactions on Industrial Electronics.

[19]  José Oscar,et al.  Electrostatic vibration-to-electric energy conversion , 2004 .

[20]  S. Roundy.  Energy Scavenging for Wireless Sensor Nodes with a Focus on Vibration-to-Electricity Conversion , 2003 .

[21]  Scott Meninger.  A low power controller for a MEMS based energy converter , 1999 .

[22]  G. Ono,et al.  Electric-energy generation using variable-capacitive resonator for power-free LSI: efficiency analysis and fundamental experiment , 2003, Proceedings of the 2003 International Symposium on Low Power Electronics and Design, 2003. ISLPED '03..

[23]  S. O. R. Moheimani,et al.  A 2-DOF wideband electrostatic transducer for energy harvesting and implantable applications , 2009, 2009 IEEE Sensors.

[24]  Erick O. Torres,et al.  Electrostatic Energy-Harvesting and Battery-Charging CMOS System Prototype , 2009, IEEE Transactions on Circuits and Systems I: Regular Papers.

[25]  Xingjun Wang,et al.  A New Level Shifter with Low Power in Multi-Voltage System , 2006, 2006 8th International Conference on Solid-State and Integrated Circuit Technology Proceedings.

[26]  Dimitri Galayko,et al.  A batch-fabricated and electret-free silicon electrostatic vibration energy harvester , 2009 .

[27]  Ahmadreza Tabesh,et al.  A Low-Power Stand-Alone Adaptive Circuit for Harvesting Energy From a Piezoelectric Micropower Generator , 2010, IEEE Transactions on Industrial Electronics.

[28]  Mona M. Hella,et al.  Modeling of Kinetic to Electrical Energy Conversion via Capacitive MEMS With Switchable Dielectric , 2008 .

[29]  T.C. Green,et al.  Converter circuit design, semiconductor device selection and analysis of parasitics for micropower electrostatic Generators , 2006, IEEE Transactions on Power Electronics.

[30]  Erick O. Torres,et al.  A 0.7-$\mu$ m BiCMOS Electrostatic Energy-Harvesting System IC , 2010, IEEE Journal of Solid-State Circuits.

[31]  Maysam Ghovanloo,et al.  An Integrated Full-Wave CMOS Rectifier With Built-In Back Telemetry for RFID and Implantable Biomedical Applications , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.

[32]  José Gerardo V. da Rocha,et al.  Energy Harvesting From Piezoelectric Materials Fully Integrated in Footwear , 2010, IEEE Transactions on Industrial Electronics.

[33]  G. De Pasquale,et al.  Capacitive vibration energy harvesting with resonance tuning , 2009, 2009 Symposium on Design, Test, Integration & Packaging of MEMS/MOEMS.