Analysis and Design of a New High-Efficiency Bidirectional Integrated ZVT PWM Converter for DC-Bus and Battery-Bank Interface

This paper proposes a high-efficiency bidirectional integrated zero-voltage transition (iZVT) pulsewidth-modulation (PWM) converter for dc-bus and battery-bank interface. The proposed converter can operate as battery charger when the utility is within its acceptable voltage range and can supply energy to critical loads when the utility fails. The converter practically eliminates both low- and high-frequency current ripple on the batteries, thus maximizing battery life without penalizing the volume of the converter. Moreover, soft switching of all switches is achieved using the proposed integrated auxiliary commutation circuit (iACC). Just one iACC is used to provide soft-switching conditions for the three converters that compose the system: the preregulator (boost), the battery charger (bidirectional converter operating as a buck), and the backup converter (bidirectional converter operating as a boost). This auxiliary circuit has few components and low reactive energy, increasing the system's overall efficiency. Experimental results based on a 580-W prototype are presented to validate the analysis and the proposed design procedure and to demonstrate the performance of the proposed approach

[1]  P. Bartholomeus,et al.  Battery charger with high quality input waveforms , 1995, 1995 Proceedings of the IEEE International Symposium on Industrial Electronics.

[2]  Humberto Pinheiro,et al.  A ZVT PWM boost converter using an auxiliary resonant source , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[3]  L.C. de Freitas,et al.  A novel family of DC-DC PWM converters using the self-resonance principle , 1994, Proceedings of 1994 Power Electronics Specialist Conference - PESC'94.

[4]  K. Hirachi,et al.  Development of UPS using new type of circuits , 1994, Proceedings of Intelec 94.

[5]  D. G. Vutetakis,et al.  The effect of charge rate and depth of discharge on the cycle life of sealed lead-acid aircraft batteries , 1992, IEEE 35th International Power Sources Symposium.

[6]  Ivo Barbi,et al.  A new ZVS semiresonant high power factor rectifier with reduced conduction losses , 1999, IEEE Trans. Ind. Electron..

[7]  Wu-Shiung Feng,et al.  A new single-phase on-line UPS structure pre-staged with PFC-and-boost converter , 1997, Proceedings of Second International Conference on Power Electronics and Drive Systems.

[8]  H.L. Hey,et al.  Integrated ZVT auxiliary commutation circuit for input stage of double-conversion UPSs , 2004, IEEE Transactions on Power Electronics.

[9]  Fred C. Lee,et al.  Novel zero-voltage-transition PWM converters , 1992 .

[10]  W. Solter A new international UPS classification by IEC 62040-3 , 2002, 24th Annual International Telecommunications Energy Conference.

[11]  R. Krishnan,et al.  Topologies for uninterruptible power supplies , 1993, ISIE '93 - Budapest: IEEE International Symposium on Industrial Electronics Conference Proceedings.

[12]  John A. O’Connor Simple Switchmode Lead-Acid Battery Charger , 1999 .

[13]  S. Karve,et al.  Three of a kind [UPS topologies, IEC standard] , 2000 .

[14]  D. Simonetti,et al.  Simplifying the design of a DCM boost PFP , 1996, V IEEE International Power Electronics Congress Technical Proceedings, CIEP 96.

[15]  Humberto Pinheiro,et al.  Evaluation of a digital control system for a high-efficiency battery charger/UPS , 2003, 2003 IEEE International Symposium on Industrial Electronics ( Cat. No.03TH8692).

[16]  H Kiehne,et al.  Battery Technology Handbook , 1989 .

[17]  B. Essig,et al.  Selecting batteries for uninterruptible power supply systems , 1991, [Proceedings] APEC '91: Sixth Annual Applied Power Electronics Conference and Exhibition.

[18]  I. Barbi,et al.  A low-cost high power factor resonant mode battery charger , 1993, Proceedings Eighth Annual Applied Power Electronics Conference and Exposition,.

[19]  Xinxiang Yan,et al.  Development of a zero-voltage-transition bidirectional DC-DC converter for a brushless DC machine EV propulsion system , 2002, 2002 IEEE 33rd Annual IEEE Power Electronics Specialists Conference. Proceedings (Cat. No.02CH37289).

[20]  D.M. Divan A new topology for single phase UPS systems , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.