Fast and reliable pre-approach for scanning probe microscopes based on tip-sample capacitance.

Within the last three decades Scanning Probe Microscopy has been developed to a powerful tool for measuring surfaces and their properties on an atomic scale such that users can be found nowadays not only in academia but also in industry. This development is still pushed further by researchers, who continuously exploit new possibilities of this technique, as well as companies that focus mainly on the usability. However, although imaging has become significantly easier, the time required for a safe approach (without unwanted tip-sample contact) can be very time consuming, especially if the microscope is not equipped or suited for the observation of the tip-sample distance with an additional optical microscope. Here we show that the measurement of the absolute tip-sample capacitance provides an ideal solution for a fast and reliable pre-approach. The absolute tip-sample capacitance shows a generic behavior as a function of the distance, even though we measured it on several completely different setups. Insight into this behavior is gained via an analytical and computational analysis, from which two additional advantages arise: the capacitance measurement can be applied for observing, analyzing, and fine-tuning of the approach motor, as well as for the determination of the (effective) tip radius. The latter provides important information about the sharpness of the measured tip and can be used not only to characterize new (freshly etched) tips but also for the determination of the degradation after a tip-sample contact/crash.

[1]  L. Crama,et al.  The ReactorSTM: atomically resolved scanning tunneling microscopy under high-pressure, high-temperature catalytic reaction conditions. , 2014, The Review of scientific instruments.

[2]  Giorgio Ferrari,et al.  Dielectric-constant measurement of thin insulating films at low-frequency by nanoscale capacitance microscopy , 2007 .

[3]  Neil C. Bruce,et al.  Rough-surface capacitor: approximations of the capacitance with elementary functions , 1999 .

[4]  Paul K. Hansma,et al.  Tapping mode atomic force microscopy in liquids , 1994 .

[5]  A. Sakai,et al.  Gap dependence of the tip-sample capacitance , 1998 .

[6]  G. Ferrari,et al.  Nanoscale capacitance imaging with attofarad resolution using ac current sensing atomic force microscopy. , 2006, Nanotechnology.

[7]  Jochen Mannhart,et al.  Stability considerations and implementation of cantilevers allowing dynamic force microscopy with optimal resolution: the qPlus sensor , 2004 .

[8]  Rolf Möller,et al.  Thermovoltage in scanning tunneling microscopy , 2000 .

[9]  P ? ? ? ? ? ? ? % ? ? ? ? , 1991 .

[10]  K. Kern,et al.  A nanoscale gigahertz source realized with Josephson scanning tunneling microscopy , 2015 .

[11]  J. Frenken,et al.  The ReactorAFM: non-contact atomic force microscope operating under high-pressure and high-temperature catalytic conditions. , 2015, The Review of scientific instruments.

[12]  J. Ziegler,et al.  Electrochemical fabrication of large arrays of metal nanoclusters , 1998 .

[13]  Peter Liljeroth,et al.  Current-Induced Hydrogen Tautomerization and Conductance Switching of Naphthalocyanine Molecules , 2007, Science.

[14]  S. Hudlet,et al.  Evaluation of the capacitive force between an atomic force microscopy tip and a metallic surface , 1998 .

[15]  D. Yablon.  Overview of Atomic Force Microscopy , 2013 .

[16]  K. Kern,et al.  Sensing the quantum limit in scanning tunnelling spectroscopy , 2016, Nature Communications.

[17]  M. J. Rost,et al.  Video‐rate scanning probe control challenges: setting the stage for a microscopy revolution , 2009 .

[18]  P. Nag,et al.  Design and properties of a cryogenic dip-stick scanning tunneling microscope with capacitive coarse approach control. , 2014, The Review of scientific instruments.

[19]  T. Kondo,et al.  Principles and Application of Heterodyne Scanning Tunnelling Spectroscopy , 2014, Scientific Reports.

[20]  Young Jae Song,et al.  Invited review article: A 10 mK scanning probe microscopy facility. , 2010, The Review of scientific instruments.

[21]  Francois Rieutord,et al.  Electrostatic forces in atomic force microscopy , 2002 .

[22]  D. Kouznetsov,et al.  The lateral resolution limit for imaging periodic conducting surfaces in capacitive microscopy , 2000 .

[23]  R. Wiesendanger,et al.  Recent advances in spin-polarized scanning tunneling microscopy , 1992 .

[24]  Peter Liljeroth,et al.  Amplifying the Pacific Climate System Response to a Small 11-Year Solar Cycle Forcing , 2009, Science.

[25]  B. Bhushan,et al.  Instrumentation for direct, low frequency scanning capacitance microscopy, and analysis of position dependent stray capacitance , 2002 .

[26]  Rolf Möller,et al.  Thermovoltage in scanning tunneling microscopy , 1997 .

[27]  Hamed Sadeghian,et al.  Development of a detachable high speed miniature scanning probe microscope for large area substrates inspection. , 2015, The Review of scientific instruments.

[28]  Š. Lányi.  Effect of tip shape on capacitance determination accuracy in scanning capacitance microscopy. , 2005, Ultramicroscopy.

[29]  M. J. Rost,et al.  Scanning probe microscopes go video rate and beyond , 2005 .

[30]  M F Crommie,et al.  Confinement of Electrons to Quantum Corrals on a Metal Surface , 1993, Science.

[31]  Š. Lányi,et al.  The resolution limit of scanning capacitance microscopes , 2003 .

[32]  M. Hersam,et al.  Nanoscale impedance microscopy-a characterization tool for nanoelectronic devices and circuits , 2005, IEEE Transactions on Nanotechnology.

[33]  R. Wiesendanger,et al.  Realizing All-Spin–Based Logic Operations Atom by Atom , 2011, Science.

[34]  J. Georges,et al.  The influence of surface roughness on the capacitance between a sphere and a plane , 1994 .

[35]  Ricardo Garcia,et al.  The emergence of multifrequency force microscopy. , 2012, Nature nanotechnology.

[36]  Ž. Šljivančanin,et al.  Magnetic remanence in single atoms , 2016, Science.

[37]  Y. Sugimoto.  Atomic Force Microscopy for Imaging, Identification and Manipulation of Single Atoms , 2016 .

[38]  G. Gomila,et al.  Finite-size effects and analytical modeling of electrostatic force microscopy applied to dielectric films , 2014, Nanotechnology.

[39]  T. Ando,et al.  A high-speed atomic force microscope for studying biological macromolecules , 2001, Proceedings of the National Academy of Sciences of the United States of America.

[40]  Toward single-atom memory , 2016, Science.

[41]  Y. Yanson,et al.  Structural accelerating effect of chloride on copper electrodeposition. , 2013, Angewandte Chemie.

[42]  D. Eigler,et al.  Molecule Cascades , 2002, Science.

[43]  G. Gomila,et al.  Nanoscale capacitance microscopy of thin dielectric films , 2008 .

[44]  M Maarten Steinbuch,et al.  Identification, control and hysteresis compensation of a 3 DOF metrological AFM , 2009 .

[45]  B. Bhushan,et al.  Scanning capacitance microscopy for thin film measurements , 2006 .

[46]  D. Eigler,et al.  Positioning single atoms with a scanning tunnelling microscope , 1990, Nature.

[47]  Dong Qian,et al.  Topological surface states protected from backscattering by chiral spin texture , 2009, Nature.

[48]  Ute Drechsler,et al.  The "Millipede"-More than thousand tips for future AFM storage , 2000, IBM J. Res. Dev..

[49]  M J Rost,et al.  In situ real-time observation of thin film deposition: roughening, zeno effect, grain boundary crossing barrier, and steering. , 2007, Physical review letters.

[50]  Bielefeldt,et al.  Subatomic Features on the Silicon (111)-(7x7) Surface Observed by Atomic Force Microscopy. , 2000, Science.