A novel method for analysis and prediction of methanol mass transfer in direct methanol fuel cell

Abstract Two-phase gas/liquid flows coupled with electrochemical reactions in the anode of direct methanol fuel cell (DMFC) are quite complicated transport phenomena. The methanol transport is a key factor influencing the performance as well as fuel utilization efficiency. In this paper, a dimensionless correlation of methanol mass transfer in DMFC anode is proposed. Firstly, a method for detecting methanol concentration in catalyst layer was developed, which is the key parameter to obtain the mass transfer coefficient. Then, the influences of the various factors on the mass transfer coefficient, including physical properties of fluid, structures of the electrode, cell configuration and cell operation conditions, were investigated. And a correlation between four dimensionless groups, i.e., Sh, Re, Sc and Π (ratio of consumption and feeding rate of methanol), was deduced using the dimensional analysis. Finally, MEA optimization and fuel utilization efficiency evaluation based on the above analysis is performed. A maximum power density of 178 mW cm−2 at 80 °C and atomistic air is achieved, 40% higher than that of commercial one made by Johnson Matthery.

[1]  Chaoyang Wang,et al.  Elucidating differences between carbon paper and carbon cloth in polymer electrolyte fuel cells , 2007 .

[2]  S. Sideman,et al.  MASS TRANSFER IN GAS-LIQUID CONTACTING SYSTEMS , 1966 .

[3]  Bubbles in the anode channel and performance of a DMFC: Asymptotic solutions , 2006 .

[4]  Javit A. Drake,et al.  Evaluation of the Experimental Model for Methanol Crossover in DMFCs , 2004 .

[5]  H. Vogt.  The role of single-phase free convection in mass transfer at gas evolving electrodes—I. Theoretical , 1993 .

[6]  Keith Scott,et al.  Gas evolution and power performance in direct methanol fuel cells , 1999 .

[7]  Yuri S. Muzychka,et al.  Effective property models for homogeneous two-phase flows , 2008 .

[8]  Hongwei Zhou,et al.  Structure optimization of cathode microporous layer for direct methanol fuel cells , 2015 .

[9]  Keith Scott,et al.  Performance and modelling of a direct methanol solid polymer electrolyte fuel cell , 1997 .

[10]  Rongzhong Jiang,et al.  CO 2 Crossover Through a Nafion Membrane in a Direct Methanol Fuel Cell , 2002 .

[11]  H. Vogt,et al.  The Concentration Overpotential of Gas Evolving Electrodes as a Multiple Problem of Mass Transfer , 1990 .

[12]  S. Kamarudin,et al.  Performance of a novel non-platinum cathode catalyst for direct methanol fuel cells , 2017 .

[13]  S. Z. Mikhail,et al.  Densities and Viscosities of Methanol-Water Mixtures. , 1961 .

[14]  Chao-Yang Wang,et al.  Mathematical Modeling of Liquid-Feed Direct Methanol Fuel Cells , 2003 .

[15]  O. Crisalle,et al.  Systematic approach for modeling methanol mass transport on the anode side of direct methanol fuel cells , 2014 .

[16]  Detlef Stolten,et al.  Recent developments of the measurement of the methanol permeation in a direct methanol fuel cell , 2002 .

[17]  Marko Zlokarnik,et al.  Scale-Up in Chemical Engineering: Second, Completely Revised and Extended Edition , 2002 .

[18]  C. Hong,et al.  Direct methanol fuel cell bubble transport simulations via thermal lattice Boltzmann and volume of fluid methods , 2010 .

[19]  Eric W. Lemmon,et al.  Thermophysical Properties of Fluid Systems , 1998 .

[20]  Yituo Wang,et al.  A novel anode catalyst layer with multilayer and pore structure for improving the performance of a direct methanol fuel cell , 2013 .

[21]  Andrei A. Kulikovsky,et al.  Analytical Modelling of Fuel Cells , 2010 .

[22]  Rong Chen,et al.  Analysis of Mass Transport of Methanol at the Anode of a Direct Methanol Fuel Cell , 2006 .

[23]  Chao-Yang Wang,et al.  Electrochemical and flow characterization of a direct methanol fuel cell , 2004 .

[24]  Hongwei Zhou,et al.  Effect of fabrication and operating parameters on electrochemical property of anode and cathode for direct methanol fuel cells , 2016 .

[25]  Ji Young Kim,et al.  Design of 3-electrode system for in situ monitoring direct methanol fuel cells during long-time running test at high temperature , 2017 .

[26]  T. Zhao,et al.  A crack-free and super-hydrophobic cathode micro-porous layer for direct methanol fuel cells , 2015 .

[27]  David Blackwell,et al.  Water flow in the gas diffusion layer of PEM fuel cells , 2005 .

[28]  Kaspar Andreas Friedrich,et al.  Performance and methanol permeation of direct methanol fuel cells: dependence on operating conditions and on electrode structure , 2004 .

[29]  Hang Guo,et al.  2D analytical model of a direct methanol fuel cell , 2004 .

[30]  S. Ookawara,et al.  Efficient fuel utilization by enhancing the under-rib mass transport using new serpentine flow field designs of direct methanol fuel cells , 2017 .

[31]  Ji Young Kim,et al.  A study on anode diffusion layer for performance enhancement of a direct methanol fuel cell , 2016 .

[32]  Brant A. Peppley,et al.  A Review of Mathematical Models for Hydrogen and Direct Methanol Polymer Electrolyte Membrane Fuel Cells , 2004 .

[33]  L. Janssen.  Behaviour of and mass transfer at gas-evolving electrodes , 1989 .

[34]  Kai Sundmacher,et al.  Limiting current behaviour of the direct methanol fuel cell , 1999 .

[35]  John Newman,et al.  Application of the limiting current method to mass transfer in packed beds at very low reynolds numbers , 1976 .

[36]  Yituo Wang,et al.  Pore‐forming technology and performance of MEA for direct methanol fuel cells , 2013 .

[37]  Kwang‐Yong Kim,et al.  Effects of geometric configuration of the channel and electrodes on the performance of a membraneless micro-fuel cell , 2017 .

[38]  H. Vogt.  The role of single-phase free convection in mass transfer at gas evolving electrodes. II: Experimental verification , 1993 .

[39]  J. Robert Selman,et al.  Mass-Transfer Measurements by the Limiting-Current Technique , 1978 .

[40]  R. O’Hayre,et al.  Fuel Cell Fundamentals , 2005 .

[41]  Weiwei Yang,et al.  A transient two-phase mass transport model for liquid feed direct methanol fuel cells , 2008 .

[42]  Jeremy P. Meyers,et al.  Modeling of Coupled Multiphase Transport in Direct Methanol Fuel Cell Diffusion Layers , 2011 .