Testing and initial verification of the world's first metal 3D printed bridge

Abstract Wire and arc additive manufacturing (WAAM) is a method of metal 3D printing that is suited to the requirements of the construction industry in terms of scale, speed and cost. Using this technology, a 10.5 m span footbridge, the first of its kind, has been printed. The testing, analysis and initial verification of the bridge and its components are described herein. The experiments performed included advanced geometric analysis, material testing, compressive testing of cross-sections and full-scale load testing of the bridge at various stages throughout and post construction. Parallel finite element modelling of the full bridge and its constituent elements has also been performed as part of the verification. Confirmation that the bridge was able to sustain its full serviceability design load enabled to the bridge to be unveiled to the public, with controlled access, for Dutch Design Week 2018. Further testing under ultimate limit state design loading is planned before the bridge is placed in its final location and fully opened to the public. The project highlights the potential for metal 3D printing in structural engineering, as well as the necessary considerations for design.

[1]  H. N. Hill.  Determination of stress-strain relations from "offset" yield strength values , 1944 .

[2]  E. Mirambell,et al.  On the calculation of deflections in structural stainless steel beams: an experimental and numerical investigation , 2000 .

[3]  Pinelopi Kyvelou,et al.  Mechanical and microstructural testing of wire and arc additively manufactured sheet material , 2020, Materials & Design.

[4]  L. Gardner,et al.  Description of stress-strain curves for stainless steel alloys , 2015 .

[5]  Tomaso Trombetti,et al.  Tensile properties and microstructural features of 304L austenitic stainless steel produced by wire-and-arc additive manufacturing , 2020, The International Journal of Advanced Manufacturing Technology.

[6]  Leroy Gardner,et al.  Material properties and compressive local buckling response of high strength steel square and rectangular hollow sections , 2017 .

[7]  Enad Mahmoud,et al.  Experimental study on Portland cement pervious concrete mechanical and hydrological properties , 2014 .

[8]  Brandon A. Krick,et al.  Wire and arc additive manufactured steel: Tensile and wear properties , 2017 .

[9]  Leroy Gardner,et al.  Structural performance of additive manufactured metallic material and cross-sections , 2017 .

[10]  Tomaso Trombetti,et al.  Experimental results for structural design of Wire-and-Arc Additive Manufactured stainless steel members , 2019 .

[11]  A. Addison,et al.  Wire + Arc Additive Manufacturing , 2016 .

[12]  D. G. Harlow,et al.  Fatigue crack growth anisotropy, texture and residual stress in austenitic steel made by wire and arc additive manufacturing , 2018 .

[13]  Leroy Gardner,et al.  Description of stress-strain curves for cold-formed steels , 2018, Construction and Building Materials.

[14]  Kim Rasmussen,et al.  Full-range stress–strain curves for stainless steelalloys , 2003 .

[15]  Carolyn Conner Seepersad,et al.  Applications of additive manufacturing in the construction industry – A forward-looking review , 2018 .

[16]  Ming Yan,et al.  Mechanical properties and cross-sectional behavior of additively manufactured high strength steel tubular sections , 2019, Thin-Walled Structures.

[17]  Leroy Gardner,et al.  Metal 3D printing in construction: A review of methods, research, applications, opportunities and challenges , 2019, Engineering Structures.

[18]  Mahmud Ashraf,et al.  Structural design for non-linear metallic materials , 2006 .

[19]  W. Ramberg,et al.  Description of Stress-Strain Curves by Three Parameters , 1943 .