Drops, slugs, and flooding in polymer electrolyte membrane fuel cells

The process of flooding has been examined with a single-channel fuel cell that permits direct observation of liquid water motion and local current density. As product water flows through the largest pores in the hydrophobic GDL, drops detach from the surface, aggregate, and form slugs. Flooding in polymer electrolyte membrane (PEM) fuel cells occurs when liquid water slugs accumulate in the gas flow channel, inhibiting reactant transport. Because of the importance of gravity, we observe different characteristics with different orientations of the flow channels. Liquid water may fall away from the GDL and be pushed out with minimal effect on the local current density, accumulate on the GDL surface and cause local fluctuations, or become a pulsating flow of liquid slugs and cause periodic oscillations. We show that flooding in PEM fuel cells is gravity-dependent and the local current densities depend on dynamics of liquid slugs moving through the flow channels. 2008 American Institute of Chemical Engineers AIChE J, 54: 1313–1332, 2008

[1]  J. St-Pierre,et al.  A microfluidic approach for measuring capillary pressure in PEMFC gas diffusion layers , 2007 .

[2]  Tianshou Zhao,et al.  A new flow field design for polymer electrolyte-based fuel cells , 2007 .

[3]  M. Watanabe,et al.  New Metal Separators Coated with Carbon/Resin Composite Layers for PEFCs , 2007 .

[4]  Claire H. Woo,et al.  PEM fuel cell current regulation by fuel feed control , 2007 .

[5]  M. Lai,et al.  Numerical study of water management in the air flow channel of a PEM fuel cell cathode , 2007 .

[6]  Zongchang Zhao,et al.  A two-fluid model for two-phase flow in PEMFCs , 2007 .

[7]  Thomas A. Trabold,et al.  In situ investigation of water transport in an operating PEM fuel cell using neutron radiography: Part 1 – Experimental method and serpentine flow field results , 2006 .

[8]  Thomas A. Trabold,et al.  In situ investigation of water transport in an operating PEM fuel cell using neutron radiography: Part 2 – Transient water accumulation in an interdigitated cathode flow field , 2006 .

[9]  Hongzhang Zhang,et al.  Diagnostic tool to detect liquid water removal in the cathode channels of proton exchange membrane fuel cells , 2006 .

[10]  B. Yi,et al.  Effects of hydrophilic/hydrophobic properties on the water behavior in the micro-channels of a proton exchange membrane fuel cell , 2006 .

[11]  Alexander Wokaun,et al.  Experimental investigation of coupling phenomena in polymer electrolyte fuel cell stacks , 2006 .

[12]  Jack S. Brenizer,et al.  Quantification of liquid water accumulation and distribution in a polymer electrolyte fuel cell using neutron imaging , 2006 .

[13]  Ramana G. Reddy,et al.  Corrugated bipolar sheets as fuel distributors in PEMFC , 2006 .

[14]  Jinsheng Xiao,et al.  Characteristics of droplet and film water motion in the flow channels of polymer electrolyte membrane fuel cells , 2006 .

[15]  A. A. Kulikovsky,et al.  Voltage loss in bipolar plates in a fuel cell stack , 2006 .

[16]  Wei-Mon Yan,et al.  EXPERIMENTAL STUDIES ON OPTIMAL OPERATING CONDITIONS FOR DIFFERENT FLOW FIELD DESIGNS OF PEM FUEL CELLS , 2006 .

[17]  Warren H. J. Hogarth,et al.  Operation of polymer electrolyte membrane fuel cells with dry feeds: Design and operating strategies , 2006 .

[18]  Zhixiang Liu,et al.  A two dimensional partial flooding model for PEMFC , 2006 .

[19]  J. Nouri,et al.  Dynamics of water droplets detached from porous surfaces of relevance to PEM fuel cells. , 2006, Journal of colloid and interface science.

[20]  Yoshitsugu Sone,et al.  One kilowatt-class fuel cell system for the aerospace applications in a micro-gravitational and closed environment , 2006 .

[21]  I. Kevrekidis,et al.  Ignition and Front Propagation in Polymer Electrolyte Membrane Fuel Cells , 2006, nlin/0606061.

[22]  Biao Zhou,et al.  Liquid water transport in straight micro-parallel-channels with manifolds for PEM fuel cell cathode , 2006 .

[23]  Mark Pritzker,et al.  Capillary pressure and hydrophilic porosity in gas diffusion layers for polymer electrolyte fuel cells , 2006 .

[24]  Xuan Liu,et al.  Water flooding and two-phase flow in cathode channels of proton exchange membrane fuel cells , 2006 .

[25]  Ramana G. Reddy,et al.  Effect of gas flow-field design in the bipolar/end plates on the steady and transient state performance of polymer electrolyte membrane fuel cells , 2006 .

[26]  Hisao Nishikawa,et al.  Measurements of humidity and current distribution in a PEFC , 2006 .

[27]  Robert M. Darling,et al.  Damage to the Cathode Catalyst of a PEM Fuel Cell Caused by Localized Fuel Starvation , 2006 .

[28]  N. Djilali,et al.  Ex situ visualization of liquid water transport in PEM fuel cell gas diffusion layers , 2006 .

[29]  Feng-Yuan Zhang,et al.  Liquid Water Removal from a Polymer Electrolyte Fuel Cell , 2006 .

[30]  Takuya Taniuchi,et al.  Simulation of the current density distribution for a PEMFC by using measured electrochemical and physical properties of the membrane , 2005 .

[31]  D. Jacobson,et al.  Real-Time Imaging of Liquid Water in an Operating Proton Exchange Membrane Fuel Cell , 2005 .

[32]  David Blackwell,et al.  Water flow in the gas diffusion layer of PEM fuel cells , 2005 .

[33]  Trung Van Nguyen,et al.  Current distribution in PEM fuel cells. Part 1: Oxygen and fuel flow rate effects , 2005 .

[34]  Chao-Yang Wang,et al.  Model of Two-Phase Flow and Flooding Dynamics in Polymer Electrolyte Fuel Cells , 2005 .

[35]  Christopher Hebling,et al.  Spatially resolved measurement of PEM fuel cells , 2005 .

[36]  F. Büchi,et al.  Dependence of current distribution on water management in PEFC of technical size , 2005 .

[37]  L. J. Bregoli,et al.  A Reverse-Current Decay Mechanism for Fuel Cells , 2005 .

[38]  B. Wetton,et al.  Discharge of a Segmented Polymer Electrolyte Membrane Fuel Cell , 2005 .

[39]  Jack S. Brenizer,et al.  Study of water distribution and transport in a polymer electrolyte fuel cell using neutron imaging , 2005 .

[40]  T. Nguyen,et al.  Modeling Liquid Water Effects in the Gas Diffusion and Catalyst Layers of the Cathode of a PEM Fuel Cell , 2004 .

[41]  Chaoyang Wang,et al.  Visualization of Liquid Water Transport in a PEFC , 2004 .

[42]  J. Newman,et al.  Modeling Two-Phase Behavior in PEFCs , 2004 .

[43]  A. Taniguchi,et al.  Analysis of electrocatalyst degradation in PEMFC caused by cell reversal during fuel starvation , 2004 .

[44]  Chao-Yang Wang,et al.  Liquid Water Transport in Gas Diffusion Layer of Polymer Electrolyte Fuel Cells , 2004 .

[45]  C. Hebling,et al.  Visualization of water buildup in the cathode of a transparent PEM fuel cell , 2003 .

[46]  Trung Van Nguyen,et al.  Three-dimensional effects of liquid water flooding in the cathode of a PEM fuel cell , 2003 .

[47]  Z. H. Wang,et al.  Two-phase flow and transport in the air cathode of proton exchange membrane fuel cells , 2000 .

[48]  R. Rowell,et al.  Physical Chemistry of Surfaces, 6th ed. , 1998 .

[49]  Mark W. Verbrugge,et al.  A Mathematical Model of the Solid‐Polymer‐Electrolyte Fuel Cell , 1992 .

[50]  S. Yariv,et al.  Physical Chemistry of Surfaces , 1979 .