Power spectral density analysis of optical substrates for gravitational-wave interferometry.

The power spectral density of surface-relief variations on polished optical surfaces across microscopic through to macroscopic spatial scales is calculated from measurements on substrates that are being produced for the Laser Interferometer Gravitational-Wave Observatory (LIGO). These spectra give a guide to the scattering properties of the surface, which in turn critically influence the performance of LIGO. Measurements obtained by use of a full-aperture interferometer and an interference microscope with two different objectives are combined to produce one-dimensional power spectral density representations of the surfaces across spatial frequencies ranging from 0.1 to 8000 cm(-1). These measurements from different instruments are in good agreement with an analytic power spectrum that varies as nu(-1.5), where nu is the spatial frequency. Some anomalies in the power spectral density spectra can be related to aspects of the polishing process.

[1]  James C. Wyant,et al.  Development of a Three-Dimensional Noncontact Digital Optical Profiler , 1986 .

[2]  R. Edward English,et al.  Power spectral density specifications for high-power laser systems , 1996, Optical Systems Design.

[3]  Joshua R. Smith,et al.  LIGO: the Laser Interferometer Gravitational-Wave Observatory , 1992, Science.

[4]  Leon Golub,et al.  Normal incidence soft x-ray telescopes , 1991 .

[5]  J. E. Harvey,et al.  Performance predictions of a Schwarzschild imaging microscope for soft x-ray applications , 1996 .

[6]  Dirk-Roger Schmitt,et al.  Use of power spectral density (PSD) to specify optical surfaces , 1996, Optical Systems Design.

[7]  E. Church.  Fractal surface finish. , 1988, Applied optics.

[8]  Egon Marx,et al.  Round robin determination of power spectral densities of different Si wafer surfaces , 1998, Photonics West.

[9]  A. Leistner,et al.  Teflon polishers: their manufacture and use , 1976 .

[10]  D. Farrant,et al.  Fabrication and measurement of optics for the laser interferometer gravitational wave observatory. , 1999, Applied optics.

[11]  Eugene L. Church,et al.  Optimal estimation of finish parameters , 1991, Optics & Photonics.

[12]  J. Bennett,et al.  Introduction to Surface Roughness and Scattering , 1999 .

[13]  P. Hall.  Introduction to Surface Roughness and Scattering , 1989 .

[14]  E. L. Church,et al.  Use of an optical profiling instrument for the measurement of the figure and finish of optical quality surfaces , 1985 .

[15]  Wallace K. Wong,et al.  Comparison of low-scatter-mirror PSD derived from multiple-wavelength BRDFs and WYKO profilometer data , 1991, Optics & Photonics.

[16]  Bozenko F. Oreb,et al.  300-mm-aperture phase-shifting Fizeau interferometer , 1999 .

[17]  Rainer Weiss,et al.  Optics Development for LIGO , 1997 .

[18]  J. Bennett,et al.  Calculation of the power spectral density from surface profile data. , 1995, Applied optics.