Fundamentals of Fluid Power Control: System Dynamics

[1]  J. Watton,et al.  Open-loop dynamic performance of a servo-valve controlled motor transmission system with pump loading using steady-state characteristics , 2006 .

[2]  Barry E. Jones,et al.  Optically Powered Hydraulic Pilot Valve using Piezoelectric Multilayer Actuator , 2001 .

[3]  S. Mookherjee,et al.  Static-Performance Based Computer-Aided Design of a DDV and its Sensitivity Analysis , 2001 .

[4]  M. E. Franke,et al.  The Frequency Response of Pneumatic Lines , 1967 .

[5]  J. Watton.  The Generalized Response of Servovalve-Controlled, Single-Rod, Linear Actuators and the Influence of Transmission Line Dynamics , 1984 .

[6]  Salvatore Manco,et al.  Computerized Generation of Novel Gearings for Internal Combustion Engines Lubricating Pumps , 2000 .

[7]  Domenico Laforgia,et al.  Modelling and Simulation of a Hydraulic Breaker , 2005 .

[8]  K. F. Martin.  Flow Saturated Step Response of a Hydraulic Servo , 1974 .

[9]  Massimo Sorli,et al.  Time Domain Fluid Transmission Line Modelling using a Passivity Preserving Rational Approximation of the Frequency Dependent Transfer Matrix , 2006 .

[10]  Kenji Suzuki,et al.  DYNAMIC CHARACTERISTICS OF A DIRECT-PRESSURE SENSING WATER HYDRAULIC RELIEF VALUE , 2005 .

[11]  John K. Schueller,et al.  Dynamic Response of a Servovalve Controlled Hydraulic Motor Driven Centrifugal Pump , 1996 .

[12]  J Watton,et al.  Identification of Fluid Power Component Behaviour Using Dynamic Flowrate Measurement , 1995 .

[13]  Saeid Habibi,et al.  Derivation of Design Requirements for Optimization of a High Performance Hydrostatic Actuation System , 2000 .

[14]  Greg Schoenau,et al.  Establishing Operating Points for a Linearized Model of a Load Sensing System , 2002 .

[15]  Monika Ivantysynova,et al.  An Investigation into Micro- and Macrogeometric Design of Piston/Cylinder Assembly of Swash Plate Machines , 2004 .

[16]  F. T. Brown,et al.  The Transient Response of Fluid Lines , 1962 .

[17]  Ye Qian,et al.  Reducing Influence of Eccentric Load on Dynamic Characteristics of Rotary Actuator , 2007 .

[18]  Lars Olems.  Investigations of the Temperature Behaviour of the Piston Cylinder Assembly in Axial Piston Pumps , 2000 .

[19]  A. S. Iberall,et al.  Attenuation of Oscillatory Pressures in Instrument Lines , 1950, Journal of Fluids Engineering.

[20]  J S Stecki,et al.  Fluid Transmission Lines—Distributed Parameter Models Part 1: A Review of the State of the Art , 1986 .

[21]  Katsumasa Suzuki,et al.  Improving Zielke’s Method of Simulating Frequency-Dependent Friction in Laminar Liquid Pipe Flow , 1991 .

[22]  Greg Schoenau,et al.  Optimization and Experimental Verification of a Variable Ratio Flow Divider Valve , 2005 .

[23]  Monika Ivantysynova,et al.  An Investigation of Swash Plate Control Concepts for Displacement Controlled Actuators , 2005 .

[24]  Roger Fales.  Stability and Performance Analysis of a Metering Poppet Valve , 2006 .

[25]  Eiichi Kojima,et al.  Development of a Quieter Variable-Displacement Vane Pump for Automotive Hydraulic Power Steering System , 2003 .

[26]  K. Weddfelt,et al.  Fast Pipeline Models for Simulation of Hydraulic Systems , 1994 .

[27]  J. Watton,et al.  Neural network modelling of fluid power control systems using internal state variables , 1996 .

[28]  Alan Christopher Hansen,et al.  Modelling and identification of a hydrostatic transmission hardware-in-the-loop simulator , 2004 .

[29]  Matti Linjama,et al.  Applicability of a Laminar Flow Based Model in Pipeflow Modelling of Water Hydraulic Systems , 2001 .

[30]  W. E. Tobler,et al.  Dissipative Modal Approximation of Fluid Transmission Lines Using Linear Friction Model , 1991 .

[31]  Tatsuo Sawada,et al.  DISTORTED PRESSURE HISTORIES DUE TO THE STEP RESPONSES IN A LINEAR TAPERED PIPE : 5TH REPORT, CASE OF A TANK BEING INSTALLED AT THE END , 1982 .

[32]  J. K. Royle.  Inherent Non-Linear Effects in Hydraulic Control Systems with Inertia Loading , 1959 .

[33]  Monika Ivantysynova,et al.  Computer Aided Optimization of Bearing and Sealing Gaps in Hydrostatic Machines—The Simulation Tool Caspar , 2002 .

[34]  D. E. Turnbull.  The Response of a Loaded Hydraulic Servomechanism , 1959 .

[35]  Peter Carlsson,et al.  Numerical Optimization of a Distributor Valve , 2003 .

[36]  Salvatore Manco,et al.  A Contribution to the Design of Hydraulic Lube Pumps , 2002 .

[37]  Nebojsa Jovicic,et al.  Modelling of Spool Position Feedback Servovalves , 2004 .

[38]  J. T. Karam.  A Simple but Complete Solution for the Step Response of a Semi-Infinite, Circular Fluid Transmission Line , 1972 .

[39]  Eizo Urata,et al.  One-Degree-Of-Freedom Model for Torque-Motor Dynamics , 2004 .

[40]  Hironao Yamada,et al.  Development of a High-Speed on/off Digital Valve for Hydraulic Control Systems using a Multilayered PZT Actuator , 2000 .

[41]  Antonio Lippolis,et al.  A Review Analysis of Unsteady Forces in Hydraulic Valves , 2006 .

[42]  A. K. Trikha,et al.  An Efficient Method for Simulating Frequency-Dependent Friction in Transient Liquid Flow , 1975 .

[43]  Hubertus Murrenhoff,et al.  Wear and Friction of ZRCG-Coated Pistons of Axial Piston Pumps , 2006 .

[44]  J. Watton.  Optimum response design guides for electrohydraulic cylinder control systems , 1990 .

[45]  Hironao Yamada,et al.  The Dynamic Characteristics of Tapered Fluid Lines with Viscoelastic Pipe Walls , 2001 .

[46]  Wayne J. Book,et al.  Electronic Control of Pump Pressure for a Small Haptic Backhoe , 2007 .

[47]  P. R. Ukrainetz,et al.  Frequency Domain Modelling and Identification of 2D Digital Servo Valve , 2000 .

[48]  K A Edge,et al.  Modelling requirements for the parallel simulation of hydraulic systems , 1992 .

[49]  R. Oldenburger,et al.  Propagation of Disturbance in Fluid Lines , 1967 .

[50]  P. N. Nikiforuk,et al.  The Large Signal Response of a Loaded High-Pressure Hydraulic Servomechanism , 1965 .

[51]  Andrew G. Alleyne,et al.  Performance Limitations of a Class of Two-Stage Electro-Hydraulic Flow Valves , 2002 .

[52]  Hubertus Murrenhoff,et al.  Measurement of Friction Forces between Piston and Bushing of an Axial Piston Displacement Unit , 2005 .

[53]  Takayoshi Muto,et al.  Resonance and Transient Response of Pressurized Complex Pipe Systems , 1980 .

[54]  W. Zielke.  Frequency dependent friction in transient pipe flow , 1968 .

[55]  Matti Vilenius,et al.  Steady State and Dynamic Characteristics of Water Hydraulic Proportional Ceramic Spool Valve , 2000 .

[56]  J. Watton,et al.  A comparison of techniques for the analysis of transmission line dynamics in electrohydraulic control systems , 1988 .

[57]  D N Johnston,et al.  Measurement of Positive Displacement Pump Flow Ripple and Impedance , 1996 .

[58]  Alex V. Khrapak.  Controlled Valve Plate in Bent Axis Hydraulic Motors , 2001 .

[59]  Peter A. J. Achten,et al.  Movement of the Cups on the Barrel Plate of a Floating Cup, Axial Piston Machine , 2004 .

[60]  Peter A. J. Achten,et al.  Valving Land Phenomena of the Innas Hydraulic Transformer , 2000 .

[61]  J S Stecki,et al.  Fluid Transmission Lines—Distributed Parameter Models Part 2: Comparison of Models , 1986 .

[62]  J Watton.  Modelling of Electrohydraulic Systems with Transmission Lines using Modal Approximations , 1988 .

[63]  Yannick Bailly,et al.  Optimization Performance of a Microfluid Flow Power Converter , 2002 .

[64]  Alarico Macor,et al.  Hydrostatic Hybrid System: System Definition and Application , 2007 .

[65]  A. G. Ivakhnenko,et al.  Polynomial Theory of Complex Systems , 1971, IEEE Trans. Syst. Man Cybern..