High boost ratio hybrid transformer DC-DC converter for photovoltaic module applications

This paper presents a non-isolated, high boost ratio hybrid transformer dc-dc converter with applications for low voltage renewable energy sources. The proposed converter utilizes a hybrid transformer to transfer the inductive and capacitive energy simultaneously, achieving a high boost ratio with a smaller size magnetic component. As a result of incorporating the resonant operation mode into the traditional high boost ratio PWM converter, the turn off loss of the switch is reduced, increasing the efficiency of the converter under all load conditions. The input current ripple is also reduced because of the linear-sinusoidal hybrid waveforms. The voltage stresses on the active switch and diodes are maintained at a low level and are independent of the changing input voltage over a wide range as a result of the resonant capacitor transferring energy to the output. The effectiveness of the proposed converter was experimentally verified using a 220 W prototype circuit. Utilizing an input voltage ranging from 20V to 45V and a load range of 30W to 220W, the experimental results show system of efficiencies greater than 96% with a peak efficiency of 97.4% at 35V input, 160W output. Because of high efficiency over wide output power range and the ability to operate with a wide variable input voltage, the proposed converter is an attractive design for alternative low dc voltage energy sources, such as solar photovoltaic (PV) modules.

[1]  Jiann-Fuh Chen,et al.  Novel High Step-Up DC–DC Converter With Coupled-Inductor and Switched-Capacitor Techniques for a Sustainable Energy System , 2011, IEEE Transactions on Power Electronics.

[2]  Quan Li,et al.  A Review of the Single Phase Photovoltaic Module Integrated Converter Topologies With Three Different DC Link Configurations , 2008, IEEE Transactions on Power Electronics.

[3]  V. Ramesh,et al.  An Efficient High-Step-Up Interleaved DC – DC Converter with a Common Active Clamp , 2022 .

[4]  F. Blaabjerg,et al.  A review of single-phase grid-connected inverters for photovoltaic modules , 2005, IEEE Transactions on Industry Applications.

[5]  Tsorng-Juu Liang,et al.  Analysis of integrated boost-flyback step-up converter , 2005 .

[6]  Tsorng-Juu Liang,et al.  Novel high-efficiency step-up converter , 2004 .

[7]  Jiann-Fuh Chen,et al.  A Novel High Step-Up DC–DC Converter for a Microgrid System , 2011, IEEE Transactions on Power Electronics.

[8]  Slobodan Cuk Coupled Inductor and Integrated Magnetics Techniques in Power Electronics , 1983, INTELEC '83 - Fifth International Telecommunications Energy Conference.

[9]  Shih-Ming Chen,et al.  A Cascaded High Step-Up DC–DC Converter With Single Switch for Microsource Applications , 2011, IEEE Transactions on Power Electronics.

[10]  Yung-Ruei Chang,et al.  High-Efficiency Power Conversion System for Kilowatt-Level Stand-Alone Generation Unit With Low Input Voltage , 2008, IEEE Transactions on Industrial Electronics.

[11]  Jih-Sheng Lai,et al.  High-Efficiency MOSFET Inverter with H6-Type Configuration for Photovoltaic Nonisolated AC-Module Applications , 2011, IEEE Transactions on Power Electronics.

[12]  J.A. Melkebeek,et al.  A single switch boost converter with a high conversion ratio , 2005, Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005..

[13]  Wensong Yu,et al.  High efficiency converter with charge pump and coupled inductor for wide input photovoltaic AC module applications , 2009, 2009 IEEE Energy Conversion Congress and Exposition.

[14]  Dragan Maksimovic,et al.  Switching converters with wide DC conversion range , 1991 .

[15]  Fred C. Lee,et al.  High-efficiency, high step-up DC-DC converters , 2003 .

[16]  F. Blaabjerg,et al.  Power electronics as efficient interface in dispersed power generation systems , 2004, IEEE Transactions on Power Electronics.

[17]  Rong-Jong Wai,et al.  High-Efficiency DC-DC Converter With High Voltage Gain and Reduced Switch Stress , 2007, IEEE Transactions on Industrial Electronics.

[18]  Esam H. Ismail,et al.  A Family of Single-Switch PWM Converters With High Step-Up Conversion Ratio , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.

[19]  Yu-Sheng Lai,et al.  An improved boost converter with coupled inductors and buck-boost type of active clamp , 2008, Fourtieth IAS Annual Meeting. Conference Record of the 2005 Industry Applications Conference, 2005..

[20]  Gun-Woo Moon,et al.  Nonisolated High Step-Up Stacked Converter Based on Boost-Integrated Isolated Converter , 2011, IEEE Transactions on Power Electronics.

[21]  Tsorng-Juu Liang,et al.  Novel High Step-Up DC–DC Converter for Fuel Cell Energy Conversion System , 2010, IEEE Transactions on Industrial Electronics.

[22]  Bangyin Liu,et al.  Photovoltaic DC-Building-Module-Based BIPV System—Concept and Design Considerations , 2011, IEEE Transactions on Power Electronics.

[23]  Rong-Jong Wai,et al.  High step-up converter with coupled-inductor , 2005 .

[24]  Wuhua Li,et al.  Review of Nonisolated High-Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications , 2011, IEEE Transactions on Industrial Electronics.

[25]  J. Bordonau,et al.  Topologies of single-phase inverters for small distributed power generators: an overview , 2004, IEEE Transactions on Power Electronics.

[26]  Yaow-Ming Chen,et al.  Boost Converter with Coupled Inductors and Buck-Boost Type of Active Clamp , 2005 .

[27]  Jih-Sheng Lai,et al.  Power conditioning circuit topologies , 2009, IEEE Industrial Electronics Magazine.

[28]  Jiann-Fuh Chen,et al.  Novel High Step-Up DC–DC Converter With Coupled-Inductor and Switched-Capacitor Techniques , 2012, IEEE Transactions on Industrial Electronics.