A performance-enhanced energy harvester for low frequency vibration utilizing a corrugated cantilevered beam

This note proposes a performance-enhanced piezoelectric energy harvester by replacing a conventional flat cantilevered beam with a corrugated beam. It consists of a proof mass and a sinusoidally or trapezoidally corrugated cantilevered beam covered by a polyvinylidene fluoride (PVDF) film. Compared to the conventional energy harvester of the same size, it has a more flexible bending stiffness and a larger bonding area of the PVDF layer, so higher output voltage from the device can be expected. In order to investigate the characteristics of the proposed energy harvester, analytical developments and numerical simulations on its natural frequency and tip displacement are carried out. Shaking table tests are also conducted to verify the performance of the proposed device. It is clearly shown from the tests that the proposed energy harvester not only has a lower natural frequency than an equivalent sized standard energy harvester, but also generates much higher output voltage than the standard one.

[1]  In-Ho Kim,et al.  Publisher's Note: ``Multi-resonant energy harvester exploiting high-mode resonances frequency down-shifted by a flexible body beam'' [Appl. Phys. Lett. 101, 123903 (2012)] , 2012 .

[2]  Jan M. Rabaey,et al.  Energy Scavenging for Wireless Sensor Networks: with Special Focus on Vibrations , 2012 .

[3]  Hyung-Jo Jung,et al.  Broadband energy-harvesting using a two degree-of-freedom vibrating body , 2011 .

[4]  In-Ho Kim,et al.  Multi-resonant energy harvester exploiting high-mode resonances frequency down-shifted by a flexible body beam , 2012 .

[5]  In-Ho Kim,et al.  Performance enhancement of a rotational energy harvester utilizing wind-induced vibration of an inclined stay cable , 2013 .

[6]  In-Ho Kim,et al.  A multi-functional cable-damper system for vibration mitigation, tension estimation and energy harvesting , 2011 .

[7]  Ann Marie Sastry,et al.  Powering MEMS portable devices—a review of non-regenerative and regenerative power supply systems with special emphasis on piezoelectric energy harvesting systems , 2008 .

[8]  Paul D. Franzon,et al.  Load characterization of high displacement piezoelectric actuators with various end conditions , 2001 .

[9]  Daniel J. Inman,et al.  Analytical Modeling and Experimental Verification of the Vibrations of the Zigzag Microstructure for Energy Harvesting , 2011 .

[10]  In-Ho Kim,et al.  An energy harvesting system using the wind-induced vibration of a stay cable for powering a wireless sensor node , 2011 .

[11]  Daniel J. Inman,et al.  Generation and Storage of Electricity from Power Harvesting Devices , 2005 .

[12]  In-Ho Kim,et al.  A tunable rotational energy harvester for low frequency vibration , 2011 .

[13]  Huan Xue,et al.  A spiral-shaped harvester with an improved harvesting element and an adaptive storage circuit , 2007, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[14]  Gene H. Haertling,et al.  Rainbow actuators and sensors: a new smart technology , 1997, Smart Structures.

[15]  Jeongsu Park,et al.  Investigation of Applicability of Electromagnetic Energy Harvesting System to Inclined Stay Cable Under Wind Load , 2012, IEEE Transactions on Magnetics.

[16]  In-Ho Kim,et al.  Experimental evaluation of a self-powered smart damping system in reducing vibrations of a full-scale stay cable , 2010 .

[17]  Shaorong Xie,et al.  A review of non-contact micro- and nano-printing technologies , 2014 .

[18]  Jaehwan Kim,et al.  A review of piezoelectric energy harvesting based on vibration , 2011 .

[19]  Daniel J. Inman,et al.  Electromechanical Modeling of the Low-Frequency Zigzag Micro-Energy Harvester , 2011 .

[20]  Gene H. Haertling,et al.  Stress‐Enhanced Displacements in PLZT Rainbow Actuators , 2005 .

[21]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[22]  Demetres Briassoulis,et al.  Equivalent orthotropic properties of corrugated sheets , 1986 .

[23]  Othman Sidek,et al.  A review of vibration-based MEMS piezoelectric energy harvesters , 2011 .