Application of High Performance Computing for Simulating Cycle-to-Cycle Variation in Dual-Fuel Combustion Engines

Interest in operational cost reduction is driving engine manufacturers to consider lower-cost fuel substitution in heavy-duty diesel engines. These dual-fuel (DF) engines could be operated either in diesel-only mode or operated with premixed natural gas (NG) ignited by a pilot flame of compression-ignited direct-injected diesel fuel. One promising application is that of large-bore, medium-speed engines such as those used in locomotives. With realistic natural gas substitution levels in the fleet of locomotives currently in service, such fuel substitution could result in billions of dollars of savings annually in the US alone. However, under certain conditions, dual-fuel operation can result in increased cycle-to-cycle variability (CCV) during combustion, resulting in variations in cylinder pressure and work extraction. In certain situations, the CCV of dual-fuel operation can be notably higher than that of diesel-only combustion under similar operating conditions. Excessive CCV can limit the NG substitution rate and operating range of a dual-fuel engine by increasing emissions and reducing engine stability, reliability and fuel efficiency via incomplete natural-gas combustion. Running multiple engine cycles in series to simulate CCV can be quite time consuming. Hence innovative modelling techniques and large computing resources are needed to investigate the factors affecting CCV in dual-fuel engines. Thismore » paper discusses the use of the High Performance Computing resource Titan, at the Oak Ridge Leadership Computing Facility at Oak Ridge National Laboratory, to investigate cycle-to-cycle combustion variability of a dual-fuel engine. The CONVERGE CFD software was used to simulate multiple, parallel single cycles of dual-fuel combustion with perturbed operating parameters and boundary conditions. These perturbations are imposed according to a sparse grids sampling of the parameter space. The sampling scheme chosen is similar to a design of experiments method but uses functions designed to minimize the number of samples required to achieve a desired degree of accuracy. The perturbed input parameters were connected to engine performance output over a large parameter space. Additionally, the same methodology was used to perform a set of diesel-only simulations at similar operating conditions to assess the numerical capability of capturing relatively low combustion variation. Lastly, this technique is expected to be useful to understand and predict combustion stability limits (knock and misfire) which are important for designing dual-fuel engines with improved operability and reliability.« less

[1]  P. K. Senecal,et al.  Grid-Convergent Spray Models for Internal Combustion Engine Computational Fluid Dynamics Simulations , 2014 .

[2]  Thomas Wallner,et al.  Capturing Cyclic Variability in EGR Dilute SI Combustion Using Multi-Cycle RANS , 2015 .

[3]  Daniel L. Flowers,et al.  Acceleration of Detailed Chemical Kinetics Using Multi-zone Modeling for CFD in Internal Combustion Engine Simulations , 2012 .

[4]  Rolf D. Reitz,et al.  Investigation of Fuel Reactivity Stratification for Controlling PCI Heat-Release Rates Using High-Speed Chemiluminescence Imaging and Fuel Tracer Fluorescence. , 2012 .

[5]  P. K. Senecal,et al.  A New Parallel Cut-Cell Cartesian CFD Code for Rapid Grid Generation Applied to In-Cylinder Diesel Engine Simulations , 2007 .

[6]  Clayton G. Webster,et al.  A dynamically adaptive sparse grids method for quasi-optimal interpolation of multidimensional functions , 2016, Comput. Math. Appl..

[7]  D. T. Hountalas,et al.  A Simulation Model for the Combustion Process of Natural Gas Engines with Pilot Diesel Fuel as an Ignition Source , 2001 .

[8]  T. Poinsot,et al.  Large-Eddy Simulation and experimental study of cycle-to-cycle variations of stable and unstable operating points in a spark ignition engine , 2012 .

[9]  F. Ducros,et al.  A thickened flame model for large eddy simulations of turbulent premixed combustion , 2000 .

[10]  Christopher J. Rutland,et al.  A new droplet collision algorithm , 2000 .

[11]  P. K. Senecal,et al.  Multi-Dimensional Modeling and Validation of Combustion in a High-Efficiency Dual-Fuel Light-Duty Engine , 2013 .

[12]  A. Gosman,et al.  Solution of the implicitly discretised reacting flow equations by operator-splitting , 1986 .

[13]  P. K. Senecal,et al.  Modeling Turbulent Combustion Using a RANS Model, Detailed Chemistry, and Adaptive Mesh Refinement , 2014 .

[14]  Charles E. A. Finney,et al.  Application of High Performance Computing for Simulating the Unstable Dynamics of Dilute Spark-Ignited Combustion , 2014 .

[15]  Thierry Poinsot,et al.  LES study of cycle-to-cycle variations in a spark ignition engine , 2011 .

[16]  S M Aceves,et al.  A fully coupled computational fluid dynamics and multi-zone model with detailed chemical kinetics for the simulation of premixed charge compression ignition engines , 2005 .

[17]  P. K. Senecal,et al.  Predictions of Transient Flame Lift-Off Length With Comparison to Single-Cylinder Optical Engine Experiments , 2013 .

[18]  S. Orszag,et al.  Development of turbulence models for shear flows by a double expansion technique , 1992 .

[19]  Tommaso Lucchini,et al.  Numerical Investigation of Non-Reacting and Reacting Diesel Sprays in Constant-Volume Vessels , 2009 .

[20]  Cecile Pera,et al.  Using large-eddy simulation and multivariate analysis to understand the sources of combustion cyclic variability in a spark-ignition engine , 2015 .

[21]  Sameera Wijeyakulasuriya,et al.  Multidimensional Modeling and Validation of Dual-Fuel Combustion in a Large Bore Medium Speed Diesel Engine , 2015 .

[22]  R. Reitz,et al.  Structure of High-Pressure Fuel Sprays , 1987 .

[23]  Sage L. Kokjohn,et al.  Investigation of the Effect of Injection and Control Strategies on Combustion Instability in Reactivity-Controlled Compression Ignition Engines , 2014 .

[24]  Michele Battistoni,et al.  Modeling of Internal and Near-Nozzle Flow for a GDI Fuel Injector , 2015 .

[25]  Raymond A. Bair,et al.  A Numerical Investigation on Scalability and Grid Convergence of Internal Combustion Engine Simulations , 2013 .

[26]  M. Musculus,et al.  Evaluating temperature and fuel stratification for heat-release rate control in a reactivity-controlled compression-ignition engine using optical diagnostics and chemical kinetics modeling , 2015 .