Progress in ethanol production from corn kernel by applying cooking pre-treatment.

In order to improve technological properties of corn kernel for ethanol production, samples were treated with a hydrothermal pre-treatment of cooking (steaming), prior to drying. Two types of cooking process parameters were applied; steam pressure of 0.5 bars during a 10 min period, and steam pressure of 1.5 bars during a 30 min period. Afterwards, samples were dried at four different temperatures, 70, 90, 110 and 130 degrees C. Control sample was also submitted to the aforementioned drying parameters. Since the results showed that starch utilization, due to the gelatinization process, was considerably higher in the samples pre-treated before the ethanol production process, it was found that the cooking treatment had a positive effect on ethanol yield from corn kernel. Therefore, the highest ethanol yield was found in the corn kernel samples cooked for 30 min at steam pressure 1.5 bars and dried at 130 degrees C. Due to the similarity of processes used for starch fermentation, introduction of cooking pre-treatment will not significantly increase the overall ethanol production costs, whereas it will result in significantly higher ethanol yield.

[1]  Lidia Lombardi,et al.  Life cycle assessment comparison of technical solutions for CO2 emissions reduction in power generation , 2003 .

[2]  B. K. Bala.  Drying and Storage of Cereal Grains , 1997 .

[3]  T. W. Jeffries,et al.  Bacteria engineered for fuel ethanol production: current status , 2003, Applied Microbiology and Biotechnology.

[4]  C. Carrot,et al.  Gelatinization and gelation of corn starch followed by dynamic mechanical spectroscopy analysis , 2003 .

[5]  S. M. Hendorson.  Grain Drying Theory (I) Temperature Effect on Drying Coefficient , 1961 .

[6]  G. Birch,et al.  Degree of Gelatinisation of Cooked Rice , 1973 .

[7]  Yan Lin,et al.  Ethanol fermentation from biomass resources: current state and prospects , 2006, Applied Microbiology and Biotechnology.

[8]  A. Mujumdar.  DRYING TECHNOLOGY IN AGRICULTURE AND FOOD SCIENCE , 2001 .

[9]  Fausto Freire,et al.  Renewability and life-cycle energy efficiency of bioethanol and bio-ethyl tertiary butyl ether (bioETBE): Assessing the implications of allocation , 2006 .

[10]  Chumnong Sorapipatana,et al.  A Study of Ethanol Production Cost for Gasoline Substitution in Thailand and Its Competitiveness , 2007 .

[11]  B. E. Vaughan,et al.  Ethanol as Fuel: Energy, Carbon Dioxide Balances, and Ecological Footprint , 2005 .

[12]  L. Mojović,et al.  Production of bioethanol from corn meal hydrolyzates , 2006 .

[13]  J. Swanston,et al.  Starch production and industrial use , 1998 .

[14]  M. Turhan,et al.  A potential method for determining in situ gelatinization temperature of starch using initial water transfer rate in whole cereals , 2006 .

[15]  Levente L. Diosady,et al.  Model for Gelatinization of Wheat Starch in a Twin‐Screw Extruder , 1993 .

[16]  J. Doublier,et al.  Effect of thermomechanical treatment on the rheological properties of crosslinked waxy corn starch , 2003 .

[17]  W. Horwitz.  Official Methods of Analysis , 1980 .

[18]  Qin Zhang,et al.  Ethanol-diesel fuel blends -- a review. , 2005, Bioresource technology.