Programmable Analog Signal Conditioning Circuit for Integrated Systems

This work proposes an architecture of a programmable conditioning circuit for dc level adjustment and gain programming to be implemented for systems on chip. The conditioning circuit is developed using a methodology to minimize the number of passive components used for programming the gain guaranteeing the full measurement range. The circuit is designed using the switched capacitors technique with two gain stages, for a total gain varying from one to 512. It can operate in four different modes, single-ended with or without dc level adjustment, differential, and calibration. Simulation results are presented for the schematic and for the circuit extracted from the layout.

[1]  Raimundo Carlos Silvério Freire,et al.  Designing a programmable analog signal conditioning circuit without loss of measurement range , 2003, IEEE Trans. Instrum. Meas..

[2]  Torsten Lehmann,et al.  An implantable CMOS signal conditioning system for recording nerve signals with cuff electrodes , 2000, 2000 IEEE International Symposium on Circuits and Systems. Emerging Technologies for the 21st Century. Proceedings (IEEE Cat No.00CH36353).

[3]  E. Charry,et al.  A CMOS signal conditioning circuit for piezoresistive pressure sensors , 2002, 2002 IEEE International Symposium on Circuits and Systems. Proceedings (Cat. No.02CH37353).