MATLAB and LabVIEW in modeling, analysis and real time control of a motion control system

This paper presents usage of two software programs, MATLAB and LabVlEW, for designing a motion control system and provides a brief look on the issue from the control system designer's level. Firstly, mathematical modeling and controller for a motion control system including permanent magnet brush type direct current motor and gear head is given with MATLAB and then suitable hardware for specific purposes is mentioned. Afterwards, real time control of the system is presented with LabVlEW FPGA and LabVlEW RT (real time).

[1]  Vladimír Havlena,et al.  A BRIEF INTRODUCTION TO CONTROL DESIGN DEMONSTRATED ON LABORATORY MODEL SERVO DR300 - AMIRA , 2005 .

[2]  Giuseppe Buja,et al.  Disturbance torque estimation in a sensorless DC drive , 1993, Proceedings of IECON '93 - 19th Annual Conference of IEEE Industrial Electronics.

[3]  Jun Yang,et al.  LabVIEW AND MATLAB-based virtual control system for virtual prototyping of cyclotron , 2007, 2007 IEEE Particle Accelerator Conference (PAC).

[4]  Zaher M. Kassas,et al.  New Mechatronics Development Techniques for FPGA-Based Control and Simulation of Electromechanical Systems , 2008 .

[5]  A. Gambier,et al.  Real-time control systems: a tutorial , 2004, 2004 5th Asian Control Conference (IEEE Cat. No.04EX904).

[6]  F. Coito,et al.  SMCRVI - a Labview/Matlab based tool for remote monitoring and control , 2005, 2005 IEEE Conference on Emerging Technologies and Factory Automation.