Novel Design Charts for Optimum Source Degeneration Tradeoff in Conjugately Matched Multistage Low-Noise Amplifiers

Source degenerative feedback is extensively applied in the low-noise amplifier design. The beneficial effects of this technique are well established in the open literature. However, the designer is often left to trial-and-error or optimization procedures to identify the adequate amount of feedback when other linear requirements, such as signal matching, come into play. This issue is even more relevant in multistage designs. In this article, we present a synthesis procedure and the relevant design chart to identify the optimum feedback inductor value on all transistors of an <inline-formula> <tex-math notation="LaTeX">$N$ </tex-math></inline-formula>-stage amplifier to obtain a perfect match at its external ports in conjunction with amplifier noise figure minimization and a specified gain requirement. It is shown that the method is applicable to arbitrary <inline-formula> <tex-math notation="LaTeX">$N$ </tex-math></inline-formula> values although it becomes more elaborate for <inline-formula> <tex-math notation="LaTeX">$N$ </tex-math></inline-formula> greater than 6. The method is deterministic as opposed to optimization or trial-and-error-based procedures. The design flow is illustrated at first through a four-stage design with ideal matching elements and subsequently validated by an monolithic microwave integrated circuit (MMIC) test vehicle designed and realized in the WIN foundry’s Gallium Arsenide PIH1-10 process. The measured performance of the test vehicle is NF = 1.9 dB, 26 dB gain, typical I/O return loss of 15 dB in the 26.5–29.5-GHz bandwidth, and practically ideal behavior at the design frequency of 28 GHz.

[1]  Todd Gaier,et al.  Cryogenic low noise MMIC amplifiers for U-Band (40–60 GHz) , 2016, 2016 11th European Microwave Integrated Circuits Conference (EuMIC).

[2]  Walter Ciccognani,et al.  A straightforward design technique for narrowband multi‐stage low‐noise amplifiers with I/O conjugate match , 2019, International Journal of RF and Microwave Computer-Aided Engineering.

[3]  H. Fukui,et al.  Available Power Gain, Noise Figure, and Noise Measure of Two-Ports and Their Graphical Representations , 1966 .

[4]  R. Leblanc,et al.  V-Band GaAs Metamorphic Low-Noise Amplifier Design Technique for Sharp Gain Roll-Off at Lower Frequencies , 2020, IEEE Microwave and Wireless Components Letters.

[5]  Jakob Engberg.  Simultaneous Input Power Match and Noise Optimization using Feedback , 1974 .

[6]  G. D. Vendelin.  Feedback Effects on the Noise Performance of GaAs MESFETs , 1975 .

[7]  Hyungcheol Shin,et al.  A Simple Figure of Merit of RF MOSFET for Low-Noise Amplifier Design , 2008, IEEE Electron Device Letters.

[8]  Filiz Güneş,et al.  Pareto Optimal Characterization of a Microwave Transistor , 2020, IEEE Access.

[9]  Denis Flandre,et al.  A gm/ID based methodology for the design of CMOS analog circuits and its application to the synthesis of a silicon-on-insulator micropower OTA , 1996, IEEE J. Solid State Circuits.

[10]  R. T. Webster,et al.  Unifying interpretation of reflection coefficient and smith chart definitions , 2011 .

[11]  D. K. Paul,et al.  Optimum Noise Measure Terminations for Microwave Transistor Amplifiers (Short Paper) , 1985 .

[12]  Hermann A. Haus,et al.  Circuit Theory of Linear Noisy Networks , 1959 .

[13]  Ji-Chyun Liu,et al.  Plots with matching circles for optimizing the performance of a low‐noise amplifier , 1993 .

[14]  Fernando Silveira,et al.  MOST Moderate–Weak-Inversion Region as the Optimum Design Zone for CMOS 2.4-GHz CS-LNAs , 2014, IEEE Transactions on Microwave Theory and Techniques.

[15]  B. M. Albinsson,et al.  A graphic design method for matched low-noise amplifiers , 1990 .

[16]  M. Ohtomo.  Stability analysis and numerical simulation of multidevice amplifiers , 1993 .

[17]  K. Kurokawa,et al.  Power Waves and the Scattering Matrix , 1965 .

[18]  R.E. Lehmann,et al.  X-band monolithic series feedback LNA , 1985, IEEE Transactions on Electron Devices.

[19]  Manuel Sierra.  Matching, gain, and noise limits on linear amplifier four‐poles , 1989 .

[20]  M. L. Edwards,et al.  A new criterion for linear 2-port stability using a single geometrically derived parameter , 1992 .

[21]  Walter Ciccognani,et al.  Constant Mismatch Circles and Application to Low-Noise Microwave Amplifier Design , 2013, IEEE Transactions on Microwave Theory and Techniques.

[22]  R. D. Pollard,et al.  Optimum noise-source reflection-coefficient design with feedback amplifiers , 1997 .

[23]  Arnulf Leuther,et al.  Comparison of a 35-nm and a 50-nm gate-length metamorphic HEMT technology for millimeter-wave low-noise amplifier MMICs , 2017, 2017 IEEE MTT-S International Microwave Symposium (IMS).

[24]  S. Iversen,et al.  The effect of feedback on noise figure , 1975, Proceedings of the IEEE.

[25]  V. Ortega,et al.  A Graphical Method for the Design of Feedback Networks for Microwave Transistor Amplifiers: Theory and Applications , 1981 .

[26]  B.S. Hewitt,et al.  Optimization of low-noise GaAs MESFET's , 1980, IEEE Transactions on Electron Devices.

[27]  Lorene Samoska,et al.  Cryogenic MMIC low-noise amplifiers for V-band , 2017, 2017 IEEE MTT-S International Microwave Symposium (IMS).

[28]  Walter Ciccognani,et al.  On the Optimum Noise-Gain Locus of Two-Ports , 2019, IEEE Transactions on Microwave Theory and Techniques.