Iso-phote Based Tool-path Generation for Machining Free-form Surfaces

This paper presents a novel approach for generating efficient tool paths in machining free-form surfaces. Concept of iso-phote is used to facilitate tool-path generation. An iso-phote is defined as a region on a surface where the normal vector does not differ by more than a prescribed angle from a fixed reference vector. The boundary curves of the iso-phote, called iso-inclination curves, are numerically generated and are served as the initial master tool paths. These iso-inclination curves are then projected to a 2D plane which is perpendicular to the fried reference vector. 2D curve offsetting of the projected iso-inclination curve is then performed. The resulted 2D offset curves are projected back to 3D surface to form final tool paths. The resulted tool paths can guarantee the satisfaction of machining tolerance requirements. A comparison study of this iso-phote based machining with the conventional iso-parametric machining and the iso-planar machining shows favorite result for the new approach.

[1]  Gábor Lukács,et al.  Pocket machining based on contour-parallel tool paths generated by means of proximity maps , 1994, Comput. Aided Des..

[2]  Gregory C Loney,et al.  NC machining of free form surfaces , 1987 .

[3]  James E. Bobrow,et al.  NC machine tool path generation from CSG part representations , 1985 .

[4]  Jordan J. Cox,et al.  Space-filling curves in tool-path applications , 1994, Comput. Aided Des..

[5]  Gershon Elber,et al.  Toolpath generation for freeform surface models , 1994, Comput. Aided Des..

[6]  Suk-Hwan Suh,et al.  Avoiding tool interference in four-axis NC machining of rotationally free surfaces , 1992, IEEE Trans. Robotics Autom..

[7]  Wayne Tiller,et al.  Offsets of Two-Dimensional Profiles , 1984, IEEE Computer Graphics and Applications.

[8]  H. Persson,et al.  NC machining of arbitrarily shaped pockets , 1978 .

[9]  Yoram Koren,et al.  Efficient Tool-Path Planning for Machining Free-Form Surfaces , 1996 .

[10]  Krishnan Suresh,et al.  Constant Scallop-height Machining of Free-form Surfaces , 1994 .

[11]  Alan C. F. Colchester,et al.  Superficial and deep structure in linear diffusion scale space: isophotes, critical points and separatrices , 1995, Image Vis. Comput..

[12]  J. S. Hwang.  Interference-free tool-path generation in the NC machining of parametric compound surfaces , 1992, Comput. Aided Des..

[13]  Tony C. Woo,et al.  Visibility maps and spherical algorithms , 1994, Comput. Aided Des..

[14]  P. Broomhead,et al.  Generating NC data at the machine tool for the manufacture of free-form surfaces , 1986 .

[15]  Kunwoo Lee,et al.  NC milling tool path generation for arbitrary pockets defined by sculptured surfaces , 1990, Comput. Aided Des..