Reliability assessment of high temperature lead-free device attach technologies

The demand for electronics capable of operating at temperatures above the traditional 125degC limit continues to increase. Devices based on wide band gap semiconductors have been demonstrated to operate at temperatures up to 500degC, but packaging them remains major hurdle to product development. Recent regulations, such as RoHS and WEEE, increase the complexity of the packaging task as they prohibit the use of certain materials in electronic products such as lead, which has traditionally been widely used in high temperature solder attach. In this investigation, a series of Pb-free die attach technologies have been identified as possible alternatives to Pb-based ones for high temperature applications. This paper describes the fabrication sequence for each system and assesses their long term reliability using accelerated thermal cycling and physics-of-failure modeling. The reliability of the lead rich alloy was confirmed during this investigation while early failures of the silver filled epoxy demonstrated their inability to survive high temperatures. An empirical damage model was developed for the silver nanoparticle paste based on fatigue induced failures. Encouraging reliability data has been presented for the gold-tin SLID system where bond quality was demonstrated to be a critical factor on its failure mode and mechanism.

[1]  M. Hansen,et al.  Constitution of Binary Alloys , 1958 .

[2]  H. Schwarzbauer,et al.  Novel large area joining technique for improved power device performance , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.

[3]  Guo-Quan Lu,et al.  Pressure-assisted low-temperature sintering of silver paste as an alternative die-attach solution to solder reflow , 2002 .

[4]  William D. Callister,et al.  Materials Science and Engineering: An Introduction , 1985 .

[5]  D. Lu,et al.  Forming High Temperature Solder Interfaces by Low Temperature Fluxless Processing , 2007, 2007 International Symposium on High Density packaging and Microsystem Integration.

[6]  Michael Pecht,et al.  Lead-free Electronics , 2006 .

[7]  E. S. Palma,et al.  Fatigue life prediction of sintered steels , 1999 .

[8]  K. Bowman.  Mechanical Behavior of Materials , 2003 .

[9]  E. S. Palma,et al.  Strain-life fatigue predictions for sintered steels with nonzero mean stress , 2000 .

[10]  Richard Ulrich,et al.  Advanced electronic packaging , 2006 .

[11]  Marc André Meyers,et al.  Mechanical Behavior of Materials (2nd ed.) , 2009 .

[12]  Guo-Quan Lu,et al.  A lead-free, low-temperature sintering die-attach technique for high-performance and high-temperature packaging , 2004, Proceedings of the Sixth IEEE CPMT Conference on High Density Microsystem Design and Packaging and Component Failure Analysis (HDP '04).

[13]  K. Chawla,et al.  Mechanical Behavior of Materials , 1998 .

[14]  J. B. Casady,et al.  A hybrid 6H-SiC temperature sensor operational from 25/spl deg/C to 500/spl deg/C , 1996 .

[15]  P. McCluskey,et al.  High Temperature Lead-Free Attach Reliability , 2007 .

[16]  R. Campbell,et al.  High Temperature Electronics. , 1971 .

[17]  Chin C. Lee,et al.  Advances in Bonding Technology for Electronic Packaging , 1993 .

[18]  Ricky W. Chuang,et al.  Silver-indium joints produced at low temperature for high temperature devices , 2002 .