Molten Carbonate Fuel Cell performance analysis varying cathode operating conditions for carbon capture applications

Abstract The results of a systematic experimental campaign to verify the impact of real operating conditions on the performance of a complete Molten Carbonate Fuel Cell (MCFC) are presented. In particular, the effects of ageing and composition of water, oxygen and carbon dioxide in the cathodic feeding stream are studied through the analysis of current-voltage curves and Electrochemical Impedance Spectroscopy (EIS). Based on a proposed equivalent electrical circuit model and a fitting procedure, a correlation is found among specific operating parameters and single EIS coefficients. The obtained results suggest a new performance monitoring approach to be applied to MCFC for diagnostic purpose. Particular attention is devoted to operating conditions characteristic of MCFC application as CO2 concentrators, which, by feeding the cathode with exhaust gases, is a promising route for efficient and cheap carbon capture.

[1]  Ermete Antolini,et al.  The stability of molten carbonate fuel cell electrodes: A review of recent improvements , 2011 .

[2]  Suk Woo Nam,et al.  Integrated numerical and experimental study of a MCFC-plasma gasifier energy system , 2012 .

[3]  Paolo Chiesa,et al.  Application of MCFCs for active CO2 capture within natural gas combined cycles , 2011 .

[4]  J. Selman,et al.  Gas Electrode Reactions in Molten Carbonate Media Part V . Electrochemical Analysis of the Oxygen Reduction Mechanism at a Fully Immersed Gold Electrode , 1990 .

[5]  H Michaels.  EMISSIONS OF NITROUS OXIDE FROM HIGHWAY MOBILE SOURCES: COMMENTS ON THE DRAFT "INVENTORY OF U.S. GREENHOUSE GAS EMISSIONS AND SINKS, 1990-1996" (MARCH 1998) , 1998 .

[6]  Jian Colin Sun,et al.  AC impedance technique in PEM fuel cell diagnosis—A review , 2007 .

[7]  A Amorelli,et al.  An Experimental Investigation Into the Use of Molten Carbonate Fuel Cells to Capture CO2 from Gas Turbine Exhaust Gases , 2004 .

[8]  Barbara Bosio,et al.  Extension of an effective MCFC kinetic model to a wider range of operating conditions , 2016 .

[9]  Lan Hu,et al.  Electrochemical performance of reversible molten carbonate fuel cells , 2014 .

[10]  Anna Moreno,et al.  Electrochemical impedance study of the poisoning behaviour of Ni-based anodes at low concentrations of H2S in an MCFC , 2012 .

[11]  J. R. Selman,et al.  The Polarization of Molten Carbonate Fuel Cell Electrodes II . Characterization by AC Impedance and Response to Current Interruption , 1991 .

[12]  G. Comodi,et al.  More accurate macro-models of solid oxide fuel cells through electrochemical and microstructural parameter estimation - Part I: Experimentation , 2015 .

[13]  J. Selman,et al.  ac-superimposed-on-dc characteristics of fuel cell electrode reactions—part I. Partially submerged smooth electrode , 1993 .

[14]  Francesco Calise,et al.  Molten carbonate fuel cell: An experimental analysis of a 1kW system fed by landfill gas , 2015 .

[15]  B. Popov,et al.  Performance studies of bare and Co-plated titanium alloy as cathode current collector in Molten Carbonate Fuel Cell (MCFC) , 2007 .

[16]  Ralph E. White,et al.  Impedance Analysis for Oxygen Reduction in a Lithium Carbonate Melt: Effects of Partial Pressure of Carbon Dioxide and Temperature , 1993 .

[17]  U. Desideri,et al.  Off-design operation of coal power plant integrated with natural gas fueled molten carbonate fuel cell as CO2 reducer , 2016 .

[18]  G. Cinti,et al.  Carbon capture with molten carbonate fuel cells: Experimental tests and fuel cell performance assessment , 2012 .

[19]  Luciano Caprile,et al.  Carbon capture: Energy wasting technologies or the MCFCs challenge? , 2011 .

[20]  Mark E. Orazem,et al.  Contribution of Surface Distributions to Constant-Phase-Element (CPE) Behavior: 1. Influence of Roughness , 2015 .

[21]  Linda Barelli,et al.  Diagnosis methodology and technique for solid oxide fuel cells: A review , 2013 .

[22]  B. Bosio,et al.  Experimental influence of operating variables on the performances of MCFCs under SO2 poisoning , 2015 .

[23]  D. Franceschetti,et al.  Interpretation of Finite‐Length‐Warburg‐Type Impedances in Supported and Unsupported Electrochemical Cells with Kinetically Reversible Electrodes , 1991 .

[24]  J. Jorcin,et al.  CPE analysis by local electrochemical impedance spectroscopy , 2006 .

[25]  L. Barelli,et al.  Kinetic modelling of molten carbonate fuel cells: Effects of cathode water and electrode materials , 2016 .

[26]  Andi Mehmeti,et al.  Life cycle assessment of molten carbonate fuel cells: State of the art and strategies for the future , 2016 .

[27]  Paolo Chiesa,et al.  Economic analysis of CO2 capture from natural gas combined cycles using Molten Carbonate Fuel Cells , 2014 .

[28]  Parthasarathy M. Gomadam,et al.  Analysis of electrochemical impedance spectroscopy in proton exchange membrane fuel cells , 2005 .

[29]  J. Selman,et al.  Application of ac impedance in fuel cell research and development , 1993 .

[30]  Jung-Ho Wee,et al.  Molten carbonate fuel cell and gas turbine hybrid systems as distributed energy resources , 2011 .

[31]  Hiroshi Morita,et al.  Performance analysis of molten carbonate fuel cell using a Li/Na electrolyte , 2002 .

[32]  U. Desideri,et al.  Modeling the performance of MCFC for various fuel and oxidant compositions , 2014 .

[33]  M. Cassir,et al.  Porous nickel MCFC cathode coated by potentiostatically deposited cobalt oxide III. Electrochemical behaviour in molten carbonate , 2007 .

[34]  J. I. Gazzarri,et al.  Non-destructive delamination detection in solid oxide fuel cells , 2007 .

[35]  J. Milewski,et al.  Experimental Investigation of CO2 Separation from Lignite Flue Gases by 100 cm2 Single Molten Carbonate Fuel Cell , 2013 .

[36]  Barbara Bosio,et al.  Membranes and Molten Carbonate Fuel Cells to Capture CO2 and Increase Energy Production in Natural Gas Power Plants , 2013 .

[37]  M. Cassir,et al.  Porous nickel MCFC cathode coated by potentiostatically deposited cobalt oxide: I. A structural and morphological study , 2005 .

[38]  S. Nam,et al.  Experimental and theoretical analysis of H2S effects on MCFCs , 2012 .

[39]  G. Cinti,et al.  Adsorptive removal of H2S in biogas conditions for high temperature fuel cell systems , 2014 .

[40]  Hee Chun Lim,et al.  Effect of various stack parameters on temperature rise in molten carbonate fuel cell stack operation , 2000 .

[41]  Jarosław Milewski,et al.  Separating CO2 from Flue Gases Using a Molten Carbonate Fuel Cell , 2012 .

[42]  L. Barelli,et al.  Experimental investigation of SO2 poisoning in a Molten Carbonate Fuel Cell operating in CCS configuration , 2016 .

[43]  Umberto Desideri,et al.  MCFC-based CO2 capture system for small scale CHP plants , 2012 .

[44]  J. I. Gazzarri,et al.  Electrochemical AC impedance model of a solid oxide fuel cell and its application to diagnosis of multiple degradation modes , 2007 .

[45]  G. Lindbergh,et al.  Effect of sulfur contaminants on MCFC performance , 2014 .

[46]  Ricardo Chacartegui,et al.  Potential of molten carbonate fuel cells to enhance the performance of CHP plants in sewage treatment facilities , 2013 .

[47]  Stefano Consonni,et al.  Application of Molten Carbonate Fuel Cells in Cement Plants for CO2 Capture and Clean Power Generation , 2014 .

[48]  Choong-Gon Lee,et al.  Effect of carbon monoxide addition to the anode of a molten carbonate fuel cell , 2004 .

[49]  Stefano Campanari,et al.  Carbon dioxide separation from high temperature fuel cell power plants , 2002 .

[50]  R. E. Fields,et al.  Electrochemical Impedance Spectroscopy for Direct Methanol Fuel Cell Diagnostics , 2006 .

[51]  Tatsuo Nishina,et al.  Water effect on oxygen reduction in molten (Li + K)CO3 eutectic , 1996 .

[52]  B. Bosio,et al.  Thermal management of the molten carbonate fuel cell plane , 2010 .

[53]  B. Yi,et al.  AC impedance characteristics of a 2 kW PEM fuel cell stack under different operating conditions and load changes , 2007 .

[54]  S. J. McPhail,et al.  Molten carbonate fuel cells for CO2 separation and segregation by retrofitting existing plants – An analysis of feasible operating windows and first experimental findings , 2015 .

[55]  Gas Electrode Reactions in Molten Carbonate Media IV . Electrode Kinetics and Mechanism of Hydrogen Oxidation in Eutectic , 1990 .

[56]  Kimihiko Sugiura,et al.  The carbon dioxide concentrator by using MCFC , 2003 .

[57]  P. Tomczyk,et al.  Investigation of the oxygen electrode reaction in basic molten carbonates using electrochemical impedance spectroscopy , 2001 .

[58]  Umberto Desideri,et al.  Analysis of pollutant emissions from cogeneration and district heating systems aimed to a feasibility study of MCFC technology for carbon dioxide separation as retrofitting of existing plants , 2011 .

[59]  Paolo Chiesa,et al.  Using MCFC for high efficiency CO2 capture from natural gas combined cycles: Comparison of internal and external reforming , 2013 .

[60]  Gianni Bidini,et al.  Performance assessment of natural gas and biogas fueled molten carbonate fuel cells in carbon capture configuration , 2016 .

[61]  J. Selman,et al.  O2‐reduction at high temperature: MCFC , 2010 .

[62]  Jarosław Milewski,et al.  A reduced order model of Molten Carbonate Fuel Cell: A proposal , 2013 .

[63]  J. R. Selman,et al.  The Polarization of Molten Carbonate Fuel Cell Electrodes I . Analysis of Steady‐State Polarization Data , 1991 .