Influence of persistence on behaviour of fractured rock masses

Abstract Most of the models that simulate fractured rock masses assume fully persistent discontinuities, simplifying the fact that, in nature, fractured rock masses are made of non-continuous sets of joints. A rock bridge gives an effective cohesion to the fracture and a block of rock cannot fall or slide until all the rock bridges fail. This failure involves the failure of the intact rock, which can be orders of magnitude stronger than the shear strength of the rock joint. In this study we focus on how the distribution of rock bridges influences the overall rock mass behaviour, to contribute to the understanding of how the presence of rock bridges influences the ‘scale’ effect that is observed between strength values measured on intact rock in the laboratory and those observed at the rock mass scale. To estimate the influence of spatial fracture, parameters of the rock mass strength and deformation were determined, using the orthogonal arrays method, UDEC and variance analysis. The numerical model was first calibrated on shear tests of samples made of continuous joints, and then used to investigate the shear behaviour of a fractured rock mass with non-persistent joints. The 2D approach was successfully extended to 3D models using 3DEC with the aim of providing a better approach for simulating the stability of an underground cavern in a fractured rockmass.

[1]  Herbert H. Einstein,et al.  Characterizing rock joint geometry with joint system models , 1988 .

[2]  John M Kemeny,et al.  The Time-Dependent Reduction of Sliding Cohesion due to Rock Bridges Along Discontinuities: A Fracture Mechanics Approach , 2003 .

[3]  W. Mendenhall,et al.  Statistics for engineering and the sciences , 1984 .

[4]  John M Kemeny,et al.  Effective moduli, non-linear deformation and strength of a cracked elastic solid , 1986 .

[5]  Oldrich Hungr,et al.  Large-scale brittle and ductile toppling of rock slopes , 2002 .

[6]  Jonny Sjöberg,et al.  Large scale slope stability in open pit mining : a review , 1996 .

[7]  E. T. Brown,et al.  Rock Mechanics: For Underground Mining , 1985 .

[8]  Gregory B. Baecher,et al.  The effect of discontinuity persistence on rock slope stability , 1983 .

[9]  Herbert H. Einstein,et al.  Coalescence of fractures under shear stresses in experiments , 1995 .

[10]  Mark S. Diederichs,et al.  Tensile strength and abutment relaxation as failure control mechanisms in underground excavations , 1999 .

[11]  Eric R. Ziegel,et al.  Probability and Statistics for Engineering and the Sciences , 2004, Technometrics.

[12]  H. H. Einstein,et al.  Failure Mechanisms of Fractured Rock - A Fracture Coalescence Model , 1991 .

[13]  P. K. Kaiser,et al.  Estimation of rock mass deformation modulus and strength of jointed hard rock masses using the GSI system , 2004 .

[14]  John M Kemeny,et al.  Time-dependent drift degradation due to the progressive failure of rock bridges along discontinuities , 2005 .