Spatial variation of the evolution and structure of the urban boundary layer

The spatial variation of the nocturnal urban boundary-layer structure is described and the time variation of the mixing height, and the nocturnal inversion top and strength after sunrise is presented for urban sites located upwind, downwind, and near the center of the heat island, and at an upwind rural site. Observations were derived from high resolution temperature profiles obtained by a helicopter during 35 intensive morning experiments in St. Louis, Missouri.The nocturnal urban boundary layer increased in depth from the upwind edge of the urban area. Far downwind, in suburban and rural areas, a remnant of the urban boundary layer existed between a stable surface-based layer and an upper inversion that resembled the upwind rural inversion.The mixing height (base of the inversion) evolved in a parabolic manner after sunrise at the urban locations. A rise in the inversion top after sunrise at the urban locations is believed to be due to low-level convergence which caused the entire inversion layer to be lifted. Due to large horizontal temperature gradients associated with the urban heat island, cold air advection tended to counteract the urban-induced lifting effect by inhibiting mixing-height growth at urban locations upwind of the heat-island center. Advection also caused the maximum height and fastest growth rate of the urban mixed layer to be shifted downwind of the urban area with time. However, mean mixing-height growth rates at various urban locations did not differ significantly. The rural mixing-height growth rate was about twice as large as urban values for up to 3 hr after sunrise. Spatial differences in the mixing height became small near the time of inversion dissipation, which appeared to occur at about the same time at all locations.