Droplet formation via squeezing mechanism in a microfluidic flow-focusing device

Abstract In this work, the formation of droplets in a microfluidic flow-focusing device is studied and presented. Spurious velocities at the fluid–fluid interface were found to be very small in the lattice Boltzmann simulations. Using this technique, simulations have been performed to study the effect of geometry on formation of droplets for a microfluidic flow-focusing device. The effect of orifice width, orifice length and distance of the orifice on the mechanism of droplet formation and size of droplets is presented for different Capillary numbers. It is shown that, for Ca ≪ 1, creation of droplets proceeds through the squeezing process that has earlier been observed in the T-junction configuration. The size of droplets increases with an increase in the (a) width, and (b) distance of orifice from the inlet. On increasing orifice length, droplet size first decreases to a minimum and increases thereafter. This study also reveals that the size of droplets becomes independent and approaches a constant beyond a critical value of the orifice length.

[1]  M. Dupin,et al.  Simulation of a microfluidic flow-focusing device. , 2006, Physical review. E, Statistical, nonlinear, and soft matter physics.

[2]  John S. Rowlinson,et al.  Molecular Theory of Capillarity , 1983 .

[3]  Howard A. Stone,et al.  ENGINEERING FLOWS IN SMALL DEVICES , 2004 .

[4]  Amit Gupta,et al.  Effect of geometry on droplet formation in the squeezing regime in a microfluidic T-junction , 2010 .

[5]  S. Anna,et al.  Microfluidic methods for generating continuous droplet streams , 2007 .

[6]  J. Boon.  The Lattice Boltzmann Equation for Fluid Dynamics and Beyond , 2003 .

[7]  S V Lishchuk,et al.  Lattice Boltzmann algorithm for surface tension with greatly reduced microcurrents. , 2003, Physical review. E, Statistical, nonlinear, and soft matter physics.

[8]  Chunfeng Zhou,et al.  Formation of simple and compound drops in microfluidic devices , 2006 .

[9]  P. Umbanhowar,et al.  Monodisperse Emulsion Generation via Drop Break Off in a Coflowing Stream , 2000 .

[10]  S. Quake,et al.  Dynamic pattern formation in a vesicle-generating microfluidic device. , 2001, Physical review letters.

[11]  D. Rothman,et al.  Diffusion properties of gradient-based lattice Boltzmann models of immiscible fluids. , 2005, Physical review. E, Statistical, nonlinear, and soft matter physics.

[12]  Howard A. Stone,et al.  A numerical study of two-phase Stokes flow in an axisymmetric flow-focusing device , 2006 .

[13]  H. Stone,et al.  Formation of dispersions using “flow focusing” in microchannels , 2003 .

[14]  Philip A. Romero,et al.  Flow focusing geometry generates droplets through a plug and squeeze mechanism. , 2012, Lab on a chip.

[15]  G. Whitesides,et al.  Nonlinear dynamics of a flow-focusing bubble generator: an inverted dripping faucet. , 2005, Physical review letters.

[16]  Erich J. Windhab,et al.  Drop formation in a co-flowing ambient fluid , 2004 .

[17]  S. M. Sohel Murshed,et al.  Droplet formation and stability of flows in a microfluidic T-junction , 2009 .

[18]  Amit Gupta,et al.  Flow regime transition at high capillary numbers in a microfluidic T-junction: Viscosity contrast and geometry effect , 2010 .

[19]  Shiyi Chen,et al.  LATTICE BOLTZMANN METHOD FOR FLUID FLOWS , 2001 .

[20]  G. Whitesides,et al.  Formation of droplets and bubbles in a microfluidic T-junction-scaling and mechanism of break-up. , 2006, Lab on a chip.

[21]  G. Tang,et al.  Lattice Boltzmann simulation of droplet formation in T-junction and flow focusing devices , 2014 .

[22]  Annie Colin,et al.  Stability of parallel flows in a microchannel after a T junction. , 2005, Physical review. E, Statistical, nonlinear, and soft matter physics.