Enhancement of output performance of Cu2ZnSnS4 thin film solar cells—A numerical simulation approach and comparison to experiments

Abstract The formation of stable, low resistance and nonrectifying contacts to Cu 2 ZnSnS 4 (CZTS) thin film photovoltaic material are the major and critical challenges associated with its effect over the output performance of fabricated solar cells. The solution of continuity equation in one dimension for a soda lime glass substrates (SLG) |Mo | CZTS | CdS | ZnO:Al cell structure is considered in the simulation of its current–voltage characteristics that is governed by the back contact material, acceptor concentration as well as thickness of the CZTS layer. Our primary simulation shows a 6.44% efficiency of the CZTS solar cell which is comparable to reported experimental data if these parameters are not optimized. However, by optimizing them a simulated conversion efficiency as high as 13.41% ( V oc =1.002 V, J sc =19.31 mA/cm 2 , fill factor ( FF )=69.35%) could be achievable. The solar cell with a back contact metal work function of 5.5 eV, an absorber layer's thickness of 2.68 μm and an acceptor concentration of 5×10 16  cm −3 were optimum. The presented optimization is ideal and subject to experimental verification with a precise control of the process parameters along with reduced surface as well as bulk recombination, secondary phases and thermalization losses.

[1]  H. Michaelson.  The work function of the elements and its periodicity , 1977 .

[2]  S. Siebentritt,et al.  Shallow defects in Cu2ZnSnS4 , 2009 .

[3]  D. Mitzi,et al.  Loss mechanisms in hydrazine-processed Cu2ZnSn(Se,S)4 solar cells , 2010 .

[4]  Susanne Siebentritt,et al.  What limits the efficiency of chalcopyrite solar cells , 2011 .

[5]  P. Dale,et al.  Synthesis and characterization of Cu2ZnSnS4 absorber layers by an electrodeposition-annealing route , 2009 .

[6]  Rakesh Agrawal,et al.  Synthesis of Cu2ZnSnS4 nanocrystal ink and its use for solar cells. , 2009, Journal of the American Chemical Society.

[7]  Suhuai Wei,et al.  Kesterites and Chalcopyrites: A Comparison of Close Cousins; Preprint , 2011 .

[8]  Nowshad Amin,et al.  Prospects of novel front and back contacts for high efficiency cadmium telluride thin film solar cells from numerical analysis , 2010 .

[9]  Kyungkon Kim,et al.  Electrical and optical properties of Cu2ZnSnS4 thin films prepared by rf magnetron sputtering process , 2003 .

[10]  D. Mitzi,et al.  Thermally evaporated Cu2ZnSnS4 solar cells , 2010 .

[11]  P. Bhattacharya,et al.  Semiconductor Optoelectronic Devices , 1993 .

[12]  V. Raja,et al.  Preparation and characterization of spray-deposited Cu2ZnSnS4 thin films , 2009 .

[13]  Jun Zhang,et al.  Cu2ZnSnS4 thin films prepared by sulfurizing different multilayer metal precursors , 2009 .

[14]  L. Romankiw,et al.  A High Efficiency Electrodeposited Cu2ZnSnS4 Solar Cell , 2012 .

[15]  A. Postnikov,et al.  Electronic structure and lattice dynamics in kesterite-type Cu 2 ZnSnSe 4 from first-principles calculations , 2010 .

[16]  Aron Walsh,et al.  Crystal and electronic band structure of Cu2ZnSnX4 (X=S and Se) photovoltaic absorbers: First-principles insights , 2009 .

[17]  C. Surya,et al.  Preparation of Cu2ZnSnS4 films by electrodeposition using ionic liquids , 2010 .

[18]  Rakesh Agrawal,et al.  Earth Abundant Element Cu2Zn(Sn1−xGex)S4 Nanocrystals for Tunable Band Gap Solar Cells: 6.8% Efficient Device Fabrication , 2011 .

[19]  B. Marsen,et al.  Cu2ZnSnS4 thin film solar cells by fast coevaporation , 2011 .

[20]  B. Parkinson,et al.  Solution-based synthesis and characterization of Cu2ZnSnS4 nanocrystals. , 2009, Journal of the American Chemical Society.

[21]  A. Walsh,et al.  Intrinsic point defects and complexes in the quaternary kesterite semiconductor Cu2ZnSnS4 , 2010 .

[22]  C. Domain,et al.  Ab initio investigation of potential indium and gallium free chalcopyrite compounds for photovoltaic application , 2005 .

[23]  H. Queisser,et al.  Detailed Balance Limit of Efficiency of p‐n Junction Solar Cells , 1961 .

[24]  C. Persson.  Electronic and optical properties of Cu2ZnSnS4 and Cu2ZnSnSe4 , 2010 .

[25]  Nevill Mott,et al.  Metal-Insulator Transition , 1968 .

[26]  Galymzhan Temirkhanovich Koishiyev.  Analysis of impact of non-uniformities on thin-film solar cells and modules with 2-D simulations , 2010 .

[27]  David B Mitzi,et al.  High‐Efficiency Solar Cell with Earth‐Abundant Liquid‐Processed Absorber , 2010, Advanced materials.

[28]  Supratik Guha,et al.  The path towards a high-performance solution-processed kesterite solar cell ☆ , 2011 .

[29]  Kentaro Ito,et al.  Cu2ZnSnS4 Thin Film Solar Cells Utilizing Sulfurization of Metallic Precursor Prepared by Simultaneous Sputtering of Metal Targets , 2011 .

[30]  Marc Burgelman,et al.  Modeling polycrystalline semiconductor solar cells , 2000 .

[31]  Martin A. Green,et al.  Solar cell efficiency tables (version 37) , 2011 .

[32]  Tadashi Ito,et al.  Enhanced Conversion Efficiencies of Cu2ZnSnS4-Based Thin Film Solar Cells by Using Preferential Etching Technique , 2008 .

[33]  Zhian Zhang,et al.  In situ growth of Cu2ZnSnS4 thin films by reactive magnetron co-sputtering , 2010 .

[34]  Dong Xu,et al.  Fabrication of Cu2ZnSnS4 screen printed layers for solar cells , 2010 .