Optical Fiber Sensors for Structural Monitoring in Power Transformers

Power transformers are central elements of power transmission systems and their deterioration can lead to system failures, causing major disruptions in service. Catastrophic failures can occur, posing major environmental hazards due to fires, explosions, or oil spillage. Early fault detection can be accomplished or estimated using electrical sensors or a chemical analysis of oil or gas samples. Conventional methods are incapable of real-time measurements with a low electrical noise due to time-consuming analyses or susceptibility to electromagnetic interference. Optical fiber sensors, passive elements that are immune to electromagnetic noise, are capable of structural monitoring by being enclosed in power transformers. In this work, optical fiber sensors embedded in 3D printed structures are studied for vibration monitoring. The fiber sensor is encapsulated between two pressboard spacers, simulating the conditions inside the power transformer, and characterized for vibrations with frequencies between 10 and 800 Hz, with a constant acceleration of 10 m/s2. Thermal aging and electrical tests are also accomplished, aiming to study the oil compatibility of the 3D printed structure. The results reported in this work suggest that structural monitoring in power transformers can be achieved using optical fiber sensors, prospecting real-time monitoring.

[1]  Joao P. S. Catalao,et al.  Effect of Loads and Other Key Factors on Oil-Transformer Ageing: Sustainability Benefits and Challenges , 2015 .

[2]  J. Sader.  Frequency response of cantilever beams immersed in viscous fluids with applications to the atomic force microscope , 1998 .

[3]  Daniel Martin,et al.  The effect of acid accumulation in power-transformer oil on the aging rate of paper insulation , 2014, IEEE Electrical Insulation Magazine.

[4]  Jorge Martins,et al.  Power transformer end-of-life assessment-pracana case study* , 2011, IEEE Electrical Insulation Magazine.

[5]  Kin Seng Chiang,et al.  Micro-Fiber-Based FBG Sensor for Simultaneous Measurement of Vibration and Temperature , 2013, IEEE Photonics Technology Letters.

[6]  Horacio Lamela,et al.  Fiber optic interferometric sensor for acoustic detection of partial discharges , 2007 .

[7]  A.B. Lobo Ribeiro,et al.  Multipoint Fiber-Optic Hot-Spot Sensing Network Integrated Into High Power Transformer for Continuous Monitoring , 2008, IEEE Sensors Journal.

[8]  Liu Dichen,et al.  Electromagnetic vibration noise analysis of transformer windings and core , 2016 .

[9]  Arnaldo G. Leal-Junior,et al.  FBG-Embedded 3-D Printed ABS Sensing Pads: The Impact of Infill Density on Sensitivity and Dynamic Range in Force Sensors , 2018, IEEE Sensors Journal.

[10]  V. Chodavarapu,et al.  Cloud-connected real-time oil condition monitoring of utility transformers using impedance spectroscopy , 2021 .

[11]  Deokwoo Jung,et al.  Low-cost embedded optical sensing systems for distribution transformer monitoring , 2020 .

[12]  Wei Huo,et al.  Optical fiber sensor-based detection of partial discharges in power transformers , 2001 .

[13]  K. Hill,et al.  Fiber Bragg grating technology fundamentals and overview , 1997 .

[14]  Keen Ian Chan,et al.  A non-destructive experimental-cum-numerical methodology for the characterization of 3D-printed materials—polycarbonate-acrylonitrile butadiene styrene (PC-ABS) , 2019, Mechanics of Materials.

[15]  G. Kai,et al.  An embedded FBG sensor for simultaneous measurement of stress and temperature , 2006, IEEE Photonics Technology Letters.

[16]  M. I. Hasan.  Improving the cooling performance of electrical distribution transformer using transformer oil – Based MEPCM suspension , 2017 .

[17]  Moisés R. N. Ribeiro,et al.  Simultaneous measurement of pressure and temperature with a single FBG embedded in a polymer diaphragm , 2019, Optics & Laser Technology.

[18]  W. Zhong,et al.  Short fiber reinforced composites for fused deposition modeling , 2001 .

[19]  Wei Wang,et al.  Localization of partial discharge in transformer oil using Fabry-Pérot optical fiber sensor array , 2018, IEEE Transactions on Dielectrics and Electrical Insulation.

[20]  Zita Vale,et al.  Distributed energy resources management using plug-in hybrid electric vehicles as a fuel-shifting demand response resource , 2015 .

[21]  Gerhard P. Hancke,et al.  Opportunities and Challenges of Wireless Sensor Networks in Smart Grid , 2010, IEEE Transactions on Industrial Electronics.

[22]  R. E. Rossi,et al.  SYMMETRIC AND ANTISYMMETRIC NORMAL MODES OF A CANTILEVER RECTANGULAR PLATE: EFFECT OF POISSON'S RATIO AND A CONCENTRATED MASS , 1996 .