Remote Powered Medical Implants for Telemonitoring

Chronic diseases like diabetes mellitus often require a permanent monitoring of vital signs. Especially the use of telemedicine will increase the quality of life for affected patients. Therefore, novel systems are necessary which are able to permanently detect and provide health status information. But these systems must not control patient's life and should work autonomously. For this purpose, intelligent medical implants are well qualified. This work describes a system for wireless power supply and communication with medical implant applications. Monitoring vital signs will create a big amount of data. Therefore, high data rates are necessary provided by high operating frequencies which in turn lead to electromagnetic far-field conditions. In this case, high attenuation losses due to the permittivity of the human body εr have to be considered. Hence, high frequencies are not suitable for the transfer of energy into the human body. The presented concept is based on two different frequencies for power supply and data transmission. An independent development of both blocks is thereby possible. The power supply operates at a frequency of 13.56 MHz, using inductive coupling. Consequently, the human body does not affect the energy transfer. In contrast, the data transmission is operated at a frequency of the medical implant communication service (MICS) band. The elaborated system consists of a power supply unit, a data transmission unit, and a control unit. The implementation of the power supply and data transmission as well as associated theoretical basics are presented. Performed measurements demonstrate that the realized system is qualified for the use on human beings.

[1]  A. Graafstra.  Hands On , 2007, IEEE Spectrum.

[2]  D.J. Young,et al.  Wireless Batteryless Implantable Blood Pressure Monitoring Microsystem for Small Laboratory Animals , 2010, IEEE Sensors Journal.

[3]  K. Takahata,et al.  Stentenna: a micromachined antenna stent for wireless monitoring of implantable microsensors , 2003, Proceedings of the 25th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (IEEE Cat. No.03CH37439).

[4]  Pengfei Li,et al.  A low power battery management system for rechargeable wireless implantable electronics , 2006, 2006 IEEE International Symposium on Circuits and Systems.

[5]  Robert Weigel,et al.  Improvements of wireless communication and energy harvesting aspects for implantable sensor interfaces by using the Split Frequencies Concept , 2011, 2011 IEEE Radio and Wireless Symposium.

[6]  W Greatbatch,et al.  The solid-state lithium battery: a new improved chemical power source for implantable cardiac pacemakers. , 1971, IEEE transactions on bio-medical engineering.

[7]  Robert Weigel,et al.  Highly efficient multistandard RFIDs enabling passive wireless sensing , 2009, 2009 Asia Pacific Microwave Conference.

[8]  Robert Puers,et al.  Inductive powering of a freely moving system , 2005 .

[9]  Eberhard Waffenschmidt,et al.  Limitation of inductive power transfer for consumer applications , 2009, 2009 13th European Conference on Power Electronics and Applications.

[10]  I. Shimoyama,et al.  Implantable telemetry capsule for monitoring arterial oxygen saturation and heartbeat , 2008, 2008 30th Annual International Conference of the IEEE Engineering in Medicine and Biology Society.

[11]  Robert Puers,et al.  Inductive Powering: Basic Theory and Application to Biomedical Systems , 2009 .

[12]  Darrin J. Young,et al.  Integrated electronic system design for an implantable wireless batteryless blood pressure sensing microsystem , 2010, IEEE Communications Magazine.

[13]  M. St..  Grundlagen der Elektrotechnik , 1908 .

[14]  O. Dössel,et al.  CALCULATION OF THE DIELECTRIC PROPERTIES OF BIOLOGICAL TISSUE USING SIMPLE MODELS OF CELL PATCHES , 2002, Biomedizinische Technik. Biomedical engineering.

[15]  Klaus Finkenzeller,et al.  RFID-Handbuch : Grundlagen und praktische Anwendungen von Transpondern, kontaktlosen Chipkarten und NFC , 2015 .

[16]  K.R. Foster,et al.  RFID Inside , 2007, IEEE Spectrum.

[17]  Chit Hwei Ng,et al.  MIM capacitor integration for mixed-signal/RF applications , 2005, IEEE Transactions on Electron Devices.

[18]  Sudipto Chakraborty,et al.  Fully Wireless Implantable Cardiovascular Pressure Monitor Integrated with a Medical Stent , 2010, IEEE Transactions on Biomedical Engineering.

[19]  Maysam Ghovanloo,et al.  Design and Optimization of a 3-Coil Inductive Link for Efficient Wireless Power Transmission , 2011, IEEE Transactions on Biomedical Circuits and Systems.

[20]  H.T. Friis,et al.  A Note on a Simple Transmission Formula , 1946, Proceedings of the IRE.

[21]  E Romero,et al.  Energy scavenging sources for biomedical sensors , 2009, Physiological measurement.

[22]  Frederick Warren Grover,et al.  Inductance Calculations: Working Formulas and Tables , 1981 .

[23]  K. Wise,et al.  A wireless microsensor for monitoring flow and pressure in a blood vessel utilizing a dual-inductor antenna stent and two pressure sensors , 2004, 17th IEEE International Conference on Micro Electro Mechanical Systems. Maastricht MEMS 2004 Technical Digest.

[24]  Shyh-Liang Lou,et al.  A miniaturized glucose biosensor for in vitro and in vivo studies. , 2008, Conference proceedings : ... Annual International Conference of the IEEE Engineering in Medicine and Biology Society. IEEE Engineering in Medicine and Biology Society. Annual Conference.

[25]  K. Wise,et al.  Micromachined Antenna Stents and Cuffs for Monitoring Intraluminal Pressure and Flow , 2006, Journal of Microelectromechanical Systems.

[26]  Q. Balzano,et al.  Measurement of localized specific absorption rate (SAR) for contactless smartcard readers operating in the HF band , 1998 .

[27]  Hisateru Takano,et al.  Study on lithium-ion secondary battery for implantable artificial heart , 1997, Proceedings of the 19th Annual International Conference of the IEEE Engineering in Medicine and Biology Society. 'Magnificent Milestones and Emerging Opportunities in Medical Engineering' (Cat. No.97CH36136).

[28]  R. Weigel,et al.  Implantable antenna for medical sensor platforms , 2012, 2012 19th International Conference on Microwaves, Radar & Wireless Communications.

[29]  Marlin H. Mickle,et al.  Design and implementation of a volume conduction based RFID system for smart implants , 2011, 2011 Annual International Conference of the IEEE Engineering in Medicine and Biology Society.

[30]  Michael P. Theodoridis,et al.  Distant energy transfer for artificial human implants , 2005, IEEE Transactions on Biomedical Engineering.

[31]  Ryuji Kohno,et al.  Networking issues in medical implant communications , 2009, MUE 2009.

[32]  R. Weigel,et al.  A multistandard HF/ UHF-RFID-tag with integrated sensor interface and localization capability , 2012, 2012 IEEE International Conference on RFID (RFID).