The maximum operating region in SiGe HBTs for RF power amplifiers

Microwave waveforms of SiGe HBTs have been directly measured. The maximum operating region has been experimentally investigated by sweeping the load lines and power of the input signal. The device is found to operate beyond the conventional BVceo, while GaAs HBTs cannot survive at that voltage. The conventional BVceo is found to limit the average Vc of the maximum load lines, but has no influence on the peak voltage. Another BVceo measured with a voltage generator is proposed to represent the avalanche breakdown instead of the conventional one.

[1]  Pei-Der Tseng,et al.  A monolithic SiGe power amplifier for dual-mode (CDMA/AMPS) cellular handset applications , 1999, Proceedings of the 1999 Bipolar/BiCMOS Circuits and Technology Meeting (Cat. No.99CH37024).

[2]  R. Hattori,et al.  A 3.2-V operation single-chip dual-band AlGaAs/GaAs HBT MMIC power amplifier with active feedback circuit technique , 2000, IEEE Journal of Solid-State Circuits.

[3]  A. Schuppen,et al.  SiGe-power amplifiers in flipchip and packaged technology , 2001, 2001 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium (IEEE Cat. No.01CH37173).

[4]  G Kompa,et al.  A 40GHz large-signal double-reflectometer waveform measurement system designed for load-pull applications , 1996, 1996 26th European Microwave Conference.

[5]  A. Inoue,et al.  Direct measurement of the maximum operating region in GaAs HBTs for RF power amplifiers , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).