CuInS2 thin films obtained through the annealing of chemically deposited In2S3–CuS thin films

[1]  Yun Sun,et al.  Fabrication and characterization of CuInS2 films by chemical bath deposition in acid conditions , 2009 .

[2]  B. Marí,et al.  CuInS2 thin films obtained by spray pyrolysis for photovoltaic applications , 2009 .

[3]  Zhengguo Jin,et al.  Effect of [Cu]/[In] ratio on properties of CuInS2 thin films prepared by successive ionic layer absorption and reaction method , 2006 .

[4]  M. Sotelo-Lerma,et al.  Structural and optical studies on thermal-annealed In2S3 films prepared by the chemical bath deposition technique , 2005 .

[5]  C. Lokhande,et al.  Chemical deposition and characterization of copper indium disulphide thin films , 2004 .

[6]  M. Hardt,et al.  Influence of the preparation conditions on the properties of CuInS2 films deposited by one-stage RF reactive sputtering , 2003 .

[7]  K. Ellmer,et al.  Copper indium disulfide solar cell absorbers prepared in a one-step process by reactive magnetron sputtering from copper and indium targets , 2002 .

[8]  V. Mikli,et al.  Composition of CuInS2 thin films prepared by spray pyrolysis , 2002 .

[9]  C. D. Kartha,et al.  Preparation of CuInS2 thin films using CBD CuxS films , 2000 .

[10]  P. K. Nair,et al.  Conversion of chemically deposited CuS thin films to and by annealing , 1998 .

[11]  Y. Yamamoto,et al.  Characterization of CuInS2 thin films prepared by sputtering from binary compounds , 1997 .

[12]  R. Scheer,et al.  CuInS2 based thin film solar cell with 10.2% efficiency , 1993 .