Experimental study on performance of rubber particle and steel fiber composite toughening concrete

Abstract In this paper the effects of steel fiber and rubber particles on the mechanical properties, flexural behavior, compression behavior and seismic behavior of high strength concrete are studied. The results show that the compressive strength of concrete flexural strength, the elastic modulus of concrete with 5% rubber particles all decreased. After adding 0.9% steel fibers the compressive strength and elastic modulus increased slightly, but the flexural strength increased significantly. Rubber particles have an slight effect on the flexural toughness of concrete. While after adding 0.9% steel fiber the flexural toughness of concrete improve significantly, the failure mode changed from brittle fracture to ductile fracture with multiple cracking phenomenon and the descending segment of load-deflection curve becomes less steep. Rubber particles and steel fibers all can improve concrete compressive toughness obviously, increased the ductility and deformation capacity. After adding steel fibers and rubber particles, because the compressive strength of concrete reduced, the bearing capacity of seismic columns decreased slightly but the hysteresis loop changed fuller significantly, the ductility and energy dissipation capacity enhanced significantly and stiffness degradation become slower.

[1]  I. Topcu,et al.  Collision behaviours of rubberized concrete , 1997 .

[2]  A. Senouci,et al.  Rubber-Tire Particles as Concrete Aggregate , 1993 .

[3]  R. Park,et al.  A SUMMARY OF RESULTS OF SIMULATED SEISMIC LOAD TESTS ON REINFORCED CONCRETE BEAM-COLUMN JOINTS, BEAMS AND COLUMNS WITH SUBSTANDARD REINFORCING DETAILS , 2002 .

[4]  Rupert J. Myers,et al.  Phase diagrams for alkali-activated slag binders , 2017 .

[5]  Carlos Zanuy,et al.  Flexural response of SFRC under impact loading , 2017 .

[6]  Nemkumar Banthia,et al.  Impact resistance of fiber reinforced concrete at subnorma temperatures , 1998 .

[7]  A. Boyd,et al.  Durability performance of fiber-reinforced concrete in severe environments , 2011 .

[8]  Xiaoxing Liu,et al.  Effect of rubber particle modification on properties of rubberized concrete , 2014, Journal of Wuhan University of Technology-Mater. Sci. Ed..

[9]  Yue Li,et al.  Effects of fly ash, retarder and calcination of magnesia on properties of magnesia-phosphate cement , 2015 .

[10]  Paulo J M Monteiro,et al.  Surface characterization of recycled tire rubber to be used in cement paste matrix. , 2002, Journal of colloid and interface science.

[11]  P. J. Zhao,et al.  Using the split Hopkinson pressure bar to investigate the dynamic behaviour of SFRC , 2003 .

[12]  Dong-Joo Kim,et al.  High strain rate effects on direct tensile behavior of high performance fiber reinforced cementitious composites , 2014 .

[13]  D. Shapiro,et al.  Aluminum-induced dreierketten chain cross-links increase the mechanical properties of nanocrystalline calcium aluminosilicate hydrate , 2017, Scientific Reports.

[14]  Hanheng Wu,et al.  Effects of rubber particles on mechanical properties of lightweight aggregate concrete , 2015 .

[15]  Z. Khatib,et al.  Rubberized Portland Cement Concrete , 1999 .

[16]  H. Khabbaz,et al.  Enhancing mechanical performance of rubberised concrete pavements with sodium hydroxide treatment , 2016 .

[17]  B. H. Abu Bakar,et al.  Experimental investigation on compression toughness of rubberized steel fibre concrete , 2016 .

[18]  Yue Li,et al.  Capillary tension theory for prediction of early autogenous shrinkage of self-consolidating concrete , 2014 .

[19]  O. Onuaguluchi Effects of surface pre-coating and silica fume on crumb rubber-cement matrix interface and cement mortar properties , 2015 .

[20]  G. Sposito,et al.  Role of Adsorption Phenomena in Cubic Tricalcium Aluminate Dissolution. , 2017, Langmuir : the ACS journal of surfaces and colloids.

[21]  Oğuz Akın Düzgün,et al.  Effect of steel fibers on the mechanical properties of natural lightweight aggregate concrete , 2005 .

[22]  D. Hou,et al.  Chloride ions transport and adsorption in the nano-pores of silicate calcium hydrate: Experimental and molecular dynamics studies , 2016 .

[23]  R. Sharma,et al.  Impact resistance of concrete containing waste rubber fiber and silica fume , 2015 .

[24]  J. Deventer,et al.  MgO content of slag controls phase evolution and structural changes induced by accelerated carbonation in alkali-activated binders , 2014 .

[25]  Fatih Altun,et al.  Effects of steel fiber addition on mechanical properties of concrete and RC beams , 2007 .

[26]  C. Johnston,et al.  Comparative flexural performance evaluation of steel fibre-reinforced concretes acoording to ASTM C1018 shows importance of fibre parameters , 1992 .

[27]  Richard R. Taylor,et al.  Atomic and nano-scale characterization of a 50-year-old hydrated C3S paste , 2015 .

[28]  Ali A. Aliabdo,et al.  Utilization of waste rubber in non-structural applications , 2015 .

[29]  E. Ganjian,et al.  Scrap-tyre-rubber replacement for aggregate and filler in concrete , 2009 .

[30]  J. Hernández-Torres,et al.  Effect of the surface treatment of recycled rubber on the mechanical strength of composite concrete/rubber , 2015 .