A micromachined CMOS distributed amplifier by CMOS compatible ICP deep-trench technology

A CMOS-process-compatible backside inductively coupled-plasma (ICP) dry etching technology to form deep trenches underneath the inductors of RF ICs is developed to enhance the performance of RF ICs with on-chip inductors. A 1-12.6-GHz CMOS distributed amplifier (DA) was designed and implemented in a standard CMOS process. The DA exhibits good input 1-dB compression point (P/sub 1 dB/) of -2 dBm and input third intercept point of 7 dBm both at 2.4 and 5.8 GHz. The authors demonstrate that a significant improvement in power gain (S/sub 21/) and noise figure (NF) can be achieved by conducting the proposed backside ICP dry etching to selectively remove the silicon underneath the inductors of the DA. The result shows that a 1.06-dB increase in S/sub 21/ (from 9.7 to 10.76 dB) and a 0.87-dB decrease (from 5.51 to 4.64 dB) in NF are achieved at 5.8 GHz mainly due to the improvement of the quality factor of the inductors in the DA. This means that this backside ICP dry-etching technique is very promising for system-on-a-chip applications.

[1]  Gary K. Fedder,et al.  Micromachined high-Q inductors in a 0.18-/spl mu/m copper interconnect low-k dielectric CMOS process , 2002 .

[2]  Han-Su Kim,et al.  Spiral inductors on Si p/p/sup +/ substrates with resonant frequency of 20 GHz , 2001, IEEE Electron Device Letters.

[3]  Shey-Shi Lu,et al.  A 2.17 dB NF, 5 GHz band monolithic CMOS LNA with 10 mW DC power consumption , 2002, 2002 Symposium on VLSI Circuits. Digest of Technical Papers (Cat. No.02CH37302).

[4]  Shey-Shi Lu,et al.  A 2.17 dB NF, 5 GHz band monolithic CMOS LNA with 10 mW DC power consumption , 2002, VLSIC 2002.

[5]  Mona E. Zaghloul,et al.  Optimization of backside micromachined CMOS inductors for RF applications , 2000, 2000 IEEE International Symposium on Circuits and Systems. Emerging Technologies for the 21st Century. Proceedings (IEEE Cat No.00CH36353).

[6]  A. Weisshaar,et al.  A comprehensive compact-modeling methodology for spiral inductors in silicon-based RFICs , 2004, IEEE Transactions on Microwave Theory and Techniques.

[7]  C. Yue,et al.  On-chip Spiral Inductors With Patterned Ground Shields For Si-based RF IC's , 1997, Symposium 1997 on VLSI Circuits.

[8]  Yo-Sheng Lin,et al.  Temperature and substrate-impedance dependence of noise figure of monolithic RF inductors on silicon , 2005 .

[9]  D. J. Allstot,et al.  A fully integrated 0.5-5.5 GHz CMOS distributed amplifier , 2000 .

[10]  S.P. Voinigescu,et al.  30-100-GHz inductors and transformers for millimeter-wave (Bi)CMOS integrated circuits , 2005, IEEE Transactions on Microwave Theory and Techniques.

[11]  Kun-Ming Chen,et al.  A simple systematic procedure of Si-based spiral inductor design , 2004, 2004 IEE Radio Frequency Integrated Circuits (RFIC) Systems. Digest of Papers.

[12]  A. Weisshaar,et al.  Wide-band compact modeling of spiral inductors in RFICs , 2002, 2002 IEEE MTT-S International Microwave Symposium Digest (Cat. No.02CH37278).

[13]  D. J. Allstot,et al.  A 0.5-8.5 GHz fully differential CMOS distributed amplifier , 2002 .

[14]  Daniel C. Edelstein,et al.  Spiral inductors and transmission lines in silicon technology using copper-damascene interconnects and low-loss substrates , 1997 .