Thermal and Bending Strain on$rm Nb_3rm Sn$Strands

Recent experimental results on the International Thermonuclear Experimental Reactor (ITER) Central Solenoid Model Coil and Insert Coil have shown that the critical characteristics measured on a single strand are significantly different from those of a cabled conductor. This performance degradation seems to be due mostly to the bending effects on the strands subjected to the electromagnetic forces: a strand inside the cable behaves like a beam supported by the neighboring strands and loaded by the transversal Lorentz force. Recently at the University of Twente (The Netherlands) and at the Japan Atomic Energy Research Institute (JAERI) some experimental tests have been performed to study this effect. In this study we analyze the strand strain field resulting from the cool down and the successive bending loads. Due to the material non linearity it is not possible to calculate the two effects separately. To analyze the strain field in a strand experiencing an electromagnetic load at 4.2 K, it is hence necessary to follow the evolution of the deformation from the strand reaction temperature to its working conditions. One single strand is taken into consideration, and it is studied with three different approaches: assuming Kirchhoff hypothesis, applying Timoshenko beam theory and using a composite, fibrous beam model. The resulting strain field is used as input data for the THELMA code to compare the results with the experiment performed at JAERI. This work is detailed in a companion paper

[1]  Y. Nunoya,et al.  Experimental investigation on the effect of transverse electromagnetic force on the V-T curve of the CIC conductor , 2004, IEEE Transactions on Applied Superconductivity.

[2]  S. Ochiai,et al.  Prediction of variation of upper critical magnetic field of Nb3Sn superconducting composites as a function of applied stress at room temperature , 1989 .

[3]  G. Rupp.  The Importance of Being Prestressed , 1980 .

[4]  N. Mitchell,et al.  Mechanical and magnetic load effects in Nb3Sn cable-in-conduit conductors , 2003 .

[5]  Neil Mitchell,et al.  Analysis and interpretation of the full set (2000–2002) of TCS tests in conductor 1A of the ITER Central Solenoid Model Coil , 2003 .

[6]  Joseph V. Minervini,et al.  Test of the ITER central solenoid model coil and CS insert , 2001 .

[7]  Roberto Zanino,et al.  Performance evaluation of the ITER Toroidal Field Model Coil phase I. Part 2: M&M analysis and interpretation , 2003 .

[9]  J. Ekin,et al.  Mechanical Properties and Strain Effects in Superconductors , 1981 .

[10]  A. Nijhuis,et al.  Effect of periodic cyclic deformation on the voltage current transition of Nb/sub 3/Sn strands tested in the novel 'TARSIS' setup , 2004, IEEE transactions on applied superconductivity.

[11]  N. Mitchell.  Analysis of the effect of Nb3Sn strand bending on CICC superconductor performance , 2002 .

[12]  Roberto Zanino,et al.  Performance evaluation of the ITER Toroidal Field Model Coil Phase I Part 1: current sharing temperature measurement , 2003 .

[13]  B. Schrefler,et al.  Multiscale analysis of the influence of the triplet helicoidal geometry on the strain state of a Nb3Sn based strand for ITER coils , 2005 .

[14]  Bernard Schrefler,et al.  A multilevel homogenised model for superconducting strand thermomechanics , 2005 .

[15]  B. Schrefler,et al.  3-D finite element analysis of composite beams with parallel fibres, based on homogenization theory , 1994 .