Active Piezoelectric Energy Harvesting: General Principle and Experimental Demonstration

In piezoelectric energy harvesting systems, the energy harvesting circuit is the interface between a piezoelectric device and an electrical load. A conventional view of this interface is based on impedance matching concepts. In fact, an energy harvesting circuit can also apply electrical boundary conditions, such as voltage and charge, to the piezoelectric device for each energy conversion cycle. An optimized electrical boundary condition can therefore increase the mechanical energy flow into the device and the energy conversion efficiency of the device. We present a study of active energy harvesting, a type of energy harvesting approach which uses switch-mode power electronics to control the voltage and/or charge on a piezoelectric device relative to the mechanical input for optimized energy conversion. Under quasi-static assumptions, a model based on the electromechanical boundary conditions is established. Some practical limiting factors of active energy harvesting, due to device limitations and the efficiency of the power electronic circuitry, are discussed. In the experimental part of the article, active energy harvesting is demonstrated with a multilayer PVDF polymer device. In these experiments, the active energy harvesting approach increased the harvested energy by a factor of five for the same mechanical displacement compared to an optimized diode rectifier-based circuit.

[1]  Heath Hofmann,et al.  Optimized piezoelectric energy harvesting circuit using step-down converter in discontinuous conduction mode , 2003 .

[2]  Yiming Liu,et al.  Investigation of electrostrictive polymers for energy harvesting , 2005, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[3]  Yong Wang,et al.  Direct piezoelectric response of piezopolymer polyvinylidene fluoride under high mechanical strain and stress , 2007 .

[4]  Claude Richard,et al.  Single crystals and nonlinear process for outstanding vibration-powered electrical generators , 2006, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[5]  J. Qiu,et al.  Piezoelectric vibration control by synchronized switching on adaptive voltage sources: Towards wideband semi-active damping , 2006 .

[6]  L. E. Cross,et al.  Electromechanical coupling and output efficiency of piezoelectric bending actuators , 1999, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[7]  L. E. Cross,et al.  Connectivity and piezoelectric-pyroelectric composites , 1978 .

[8]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless, remote power supply , 2001 .

[9]  Tore Undeland,et al.  Power Electronics: Converters, Applications and Design , 1989 .

[10]  Ieee Standards Board IEEE Standard on Piezoelectricity , 1996 .

[11]  Claude Richard,et al.  Enhanced semi-passive damping using continuous switching of a piezoelectric device on an inductor , 2000, Smart Structures.

[12]  D. Guyomar,et al.  Efficiency Enhancement of a Piezoelectric Energy Harvesting Device in Pulsed Operation by Synchronous Charge Inversion , 2005 .

[13]  D. Guyomar,et al.  Piezoelectric Energy Harvesting Device Optimization by Synchronous Electric Charge Extraction , 2005 .

[14]  Cyril Buttay,et al.  Semi-passive piezoelectric noise control in transmission by synchronized switching damping on voltage source , 2005 .