Advanced impedance study of polymer electrolyte membrane single cells by means of distribution of relaxation times

Abstract Electrochemical impedance spectroscopy data of a polymer electrolyte membrane fuel cell are compiled across a wide range of operating conditions. In all cases, homogeneous operating conditions are applied over the entire cell area to set a clearly defined operating point and to derive unambiguous parameter dependencies. As a novelty, this diverse set of impedance spectra is deconvoluted by the distribution of relaxation times (DRT) method in the frequency range from 0.5 Hz to 60 kHz. In H2/air-operation five polarization contributions with different time constants are registered. The assignment to gas diffusion in the gas diffusion layer and catalyst layer, the oxygen reduction reaction at the Pt-catalyst and proton transport processes in the cathode catalyst layer is supported by a systematic analysis of parameter dependencies. Furthermore, DRT deconvolution in H2/H2-operation reveals three “new” anode contributions, usually hidden by the dominating cathode contributions. They are assigned to gas diffusion and hydrogen oxidation, including charge-transfer and proton transport in the anode catalyst layer. It is confirmed that the polarization contributions at the cathode side sum up to 96% for typical operating conditions, but the share changes to 80% cathode and 20% anode at low hydrogen partial pressure.

[1]  Yanghua Tang,et al.  PEM fuel cell open circuit voltage (OCV) in the temperature range of 23 °C to 120 °C , 2006 .

[2]  T. Springer,et al.  Characterization of polymer electrolyte fuel cells using ac impedance spectroscopy , 1996 .

[3]  E. Gonzalez,et al.  Effect of membrane characteristics and humidification conditions on the impedance response of polymer electrolyte fuel cells , 2001 .

[4]  B. Conway,et al.  Three-dimensional impedance spectroscopy diagrams for processes involving electrosorbed intermediates, introducing the third electrode-potential variable—examination of conditions leading to pseudo-inductive behavior , 1993 .

[5]  Alexandra Weiß,et al.  Distribution of Relaxation Times Analysis of High-Temperature PEM Fuel Cell Impedance Spectra , 2017 .

[6]  Belkacem Ould-Bouamama,et al.  Model based PEM fuel cell state-of-health monitoring via ac impedance measurements , 2006 .

[7]  Bastian Schaar,et al.  A “proton pump” concept for the investigation of proton transport and anode kinetics in proton exchange membrane fuel cells , 2009 .

[8]  Michael Eikerling,et al.  Analytical solutions for impedance of the cathode catalyst layer in PEM fuel cell: Layer parameters from impedance spectrum without fitting , 2013 .

[9]  E. Ivers-Tiffée,et al.  Approximability of Impedance Spectra By RC Elements and Implications for Impedance Analysis , 2015 .

[10]  A. Weber.  Characterization of SOFC Single Cells , 2001 .

[11]  Ellen Ivers-Tiffée,et al.  Evaluation of electrochemical impedance spectra by the distribution of relaxation times , 2017 .

[12]  Hubert A. Gasteiger,et al.  Proton Conduction and Oxygen Reduction Kinetics in PEM Fuel Cell Cathodes: Effects of Ionomer-to-Carbon Ratio and Relative Humidity , 2009 .

[13]  A. Kucernak,et al.  Performance measurements and modelling of the ORR on fuel cell electrocatalysts – the modified double trap model , 2015 .

[14]  K. Friedrich,et al.  Application of Electrochemical Impedance Spectroscopy for Fuel Cell Characterization: PEFC and Oxygen Reduction Reaction in Alkaline Solution , 2009 .

[15]  H. Schichlein,et al.  Deconvolution of electrochemical impedance spectra for the identification of electrode reaction mechanisms in solid oxide fuel cells , 2002 .

[16]  K. Karan,et al.  Investigation of Charge-Transfer and Mass-Transport Resistances in PEMFCs with Microporous Layer Using Electrochemical Impedance Spectroscopy , 2009 .

[17]  L. Arriaga,et al.  Impedance spectroscopy as a tool in the evaluation of MEA's , 2003 .

[18]  W. Gu,et al.  Modeling Platinum Oxide Growth of PEMFC Cathode Catalysts , 2015 .

[19]  Ellen Ivers-Tiffée,et al.  Evaluation and Modeling of the Cell Resistance in Anode-Supported Solid Oxide Fuel Cells , 2008 .

[20]  J. Jorné,et al.  Cathode Catalyst Utilization for the ORR in a PEMFC Analytical Model and Experimental Validation , 2007 .

[21]  E. Ivers-Tiffée,et al.  Practical Guidelines for Reliable Electrochemical Characterization of Solid Oxide Fuel Cells , 2017 .

[22]  Bernard A. Boukamp,et al.  A Linear Kronig‐Kramers Transform Test for Immittance Data Validation , 1995 .

[23]  Brian P. Setzler,et al.  A Physics-Based Impedance Model of Proton Exchange Membrane Fuel Cells Exhibiting Low-Frequency Inductive Loops , 2015 .

[24]  A. Weber,et al.  Modeling transport in polymer-electrolyte fuel cells. , 2004, Chemical reviews.

[25]  S. Holdcroft,et al.  Polarization-dependent mass transport parameters for orr in perfluorosulfonic acid ionomer membranes: an EIS study using microelectrodes , 2004 .

[26]  C. Jallut,et al.  A Multi‐Scale Dynamic Mechanistic Model for the Transient Analysis of PEFCs , 2007 .

[27]  Jian Colin Sun,et al.  AC impedance technique in PEM fuel cell diagnosis—A review , 2007 .

[28]  J. Weese.  A reliable and fast method for the solution of Fredhol integral equations of the first kind based on Tikhonov regularization , 1992 .

[29]  Jon G. Pharoah,et al.  Effect of Relative Humidity on Electrochemical Active Area and Impedance Response of PEM Fuel Cell , 2008 .

[30]  E. Ivers-Tiffée,et al.  A Method for Improving the Robustness of linear Kramers-Kronig Validity Tests , 2014 .

[31]  N. Wagner,et al.  Change of electrochemical impedance spectra (EIS) with time during CO-poisoning of the Pt-anode in a membrane fuel cell , 2004 .

[32]  A. Tikhonov,et al.  Numerical Methods for the Solution of Ill-Posed Problems , 1995 .

[33]  E. Ivers-Tiffée,et al.  Advanced impedance modelling of Ni/8YSZ cermet anodes , 2017 .

[34]  Sophie Didierjean,et al.  Effect of Gas Dilution on PEM Fuel Cell Performance and Impedance Response , 2006 .

[35]  Ellen Ivers-Tiffée,et al.  INFLUENCE OF CURRENT DENSITY AND FUEL UTILIZATION ON THE DEGRADATION OF THE ANODE , 1998 .

[36]  A. Kulikovsky,et al.  PEM Fuel Cell Characterization by Means of the Physical Model for Impedance Spectra , 2015 .

[37]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[38]  Andrei Kulikovsky,et al.  PEM Fuel Cell Impedance at Open Circuit , 2016 .

[39]  Moses Ender,et al.  Separation of Charge Transfer and Contact Resistance in LiFePO4-Cathodes by Impedance Modeling , 2012 .

[40]  Mark E. Orazem,et al.  Interpretation of Low-Frequency Inductive Loops in PEM Fuel Cells , 2007 .

[41]  S. Holdcroft,et al.  The reasons for the high power density of fuel cells fabricated with directly deposited membranes , 2016 .