The effect of coal bottom ash (CBA) on mechanical and durability characteristics of concrete

The present paper would contribute to the efforts being made in the field of concrete technology towards development of concretes possessing good strength and durability properties along with economic and ecological advantage. In the present study it was found that with increase in amount of coal bottom ash, standard consistency, initial and final setting time increase at the same time workability of concrete decreases. Early age strength is less for bottom ash concrete compare to control mix, but as the age increases they show good improvement in strength due to pozzalanic reaction. Optimum dosage is observed to be 10% Grinded Bottom Ash (GBA) which shows about 14 % more strength compared to control mix at 56 days. Also 20% replacement by GBA gives results comparable to control concrete. GBA concrete shows more resistance to acid attack compared to Original Bottom Ash (OBA). Mix M7 with 30 % replacement by GBA shows highest resistance to acid attack. With the increase in amount of bottom ash water absorption capacity of concrete increases, also as the age increases for all the mix water absorption capacity decreases. It was also found that at optimum dosage i.e at 10% replacement of cement with GBA it is also economical and also less amount of CO2 is emitted that mean it is also environmental friendly compared to control mix.

[1]  C. Jaturapitakkul,et al.  Development of Bottom Ash as Pozzolanic Material , 2003 .

[2]  Yun Bai,et al.  Strength and Drying Shrinkage Properties of Concrete Containing Furnace Bottom Ash as Fine Aggregate , 2005 .

[3]  H. Lee,et al.  Improved chloride resistance of high-strength concrete amended with coal bottom ash for internal curing , 2014 .

[4]  J. Pera,et al.  Pozzolanic properties of pulverized coal combustion bottom ash , 1999 .

[5]  Rafat Siddique,et al.  Strength properties and micro-structural properties of concrete containing coal bottom ash as partial replacement of fine aggregate , 2014 .

[6]  Cenk Karakurt,et al.  Properties of the autoclaved aerated concrete produced from coal bottom ash , 2009 .

[7]  H. Lee,et al.  Use of power plant bottom ash as fine and coarse aggregates in high-strength concrete , 2011 .

[8]  M. Salim,et al.  Investigation of coal bottom ash and fly ash in concrete as replacement for sand and cement , 2016 .

[9]  R. Siddique,et al.  Influence of water/powder ratio on strength properties of self-compacting concrete containing coal fly ash and bottom ash , 2012 .

[10]  G. C. Isaia,et al.  Physical and pozzolanic action of mineral additions on the mechanical strength of high-performance concrete , 2003 .

[11]  Iman M. Nikbin,et al.  A comprehensive analytical study on the mechanical properties of concrete containing waste bottom ash as natural aggregate replacement , 2016 .

[12]  D. Singh,et al.  Physical, chemical, mineralogical, and thermal properties of cenospheres from an ash lagoon , 2001 .

[13]  Diana Bajare,et al.  Coal Combustion Bottom Ash as Microfiller with Pozzolanic Properties for Traditional Concrete , 2013 .

[14]  P. Bowen,et al.  Changes in portlandite morphology with solvent composition: Atomistic simulations and experiment , 2011 .

[15]  Rafat Siddique,et al.  COMPRESSIVE STRENGTH, WATER ABSORPTION, SORPTIVITY, ABRASION RESISTANCE, AND PERMEABILITY OF SELF-COMPACTING CONCRETE CONTAINING COAL BOTTOM ASH , 2013 .

[16]  Mine Kaya,et al.  Usage of coal combustion bottom ash in concrete mixture , 2008 .

[17]  Malik Cheriaf,et al.  Influence of coal bottom ash as fine aggregate on fresh properties of concrete , 2009 .

[18]  J. Rocha,et al.  Aspects of moisture kinetics of coal bottom ash in concrete , 2007 .