Thermal cycling and stress relaxation response of Si-Al and Si-Al-SiO2 layered thin films

Abstract The deformation of Si-Al and Si-Al-SiO 2 multi-layered thin films in response to controlled sequences of constant- and variable-amplitude thermal cycling and isothermal exposures has been studied experimentally by recourse to in situ measurements of curvature changes which made use of the laser scanning technique. In an attempt to systematically isolate salient mechanistic features, a select set of companion experiments have also been conducted on the Si-SiO 2 bi-layer system. In some cases, the layered solids have been subjected to as many as 14 thermal cycles between 20 and 450°C to examine the stability of thermally induced deformation. It is found that the variation of curvature with temperature reaches saturation after the first thermal cycle for the Si-Al bi-layer system. The presence of the SiO 2 passivation layer, however, drastically alters the plastic deformation characteristics of the Al layer with the result that: (i) sharp transitions arise in the variation of curvature with temperature during constant-amplitude thermal cycling; (ii) as many as 12 thermal cycles are needed to attain saturation in the curvature-temperature hysteresis loops; (iii) the extent of stress relaxation is significantly reduced during isothermal hold periods in the heating or the cooling phase of the thermal cycle; and (iv) the effects of certain types of variable-amplitude thermal cycling on elastoplastic deformation are essentially suppressed. An elastoplastic analysis, presented by Suresh et al. ( J. Mech. Phys. Solids 42 , 979, 1994) for multi-layer systems, has been used to interpret some of the experimental results obtained in this paper. The predictions of this analysis for curvature changes during thermal cycling (without isothermal hold periods) are found to capture many trends experimentally observed in the Si-Al and Si-Al-SiO 2 layered systems. It is seen, however, that continuum analyses based upon assumptions of steady-state, power-law creep response for the thin Al film fail to capture the measured effects of the passivation layer on creep relaxation even at saturation.

[1]  P. Flinn,et al.  Measurement and Interpretation of stress in aluminum-based metallization as a function of thermal history , 1987, IEEE Transactions on Electron Devices.

[2]  Donald S. Gardner,et al.  Plastic properties of thin films on substrates as measured by submicron indentation hardness and substrate curvature techniques , 1986 .

[3]  J. Cohen,et al.  Stress relaxation in AlCu thin films , 1992 .

[4]  J. R. Liefting,et al.  Deformation mechanisms of Al films on oxidized Si wafers , 1994 .

[5]  William D. Nix,et al.  Mechanical properties of thin films , 1989 .

[6]  W. D. Nix,et al.  Thermal stresses in aluminum lines bounded to substrates , 1992 .

[7]  A. Giannakopoulos,et al.  Elastoplastic analysis of thermal cycling: Layered materials with sharp interfaces , 1994 .

[8]  Ramnath Venkatraman,et al.  Mechanical properties and microstructural characterization of Al-0.5%Cu thin films , 1990 .

[9]  C. A. Paszkiet,et al.  Stress relaxation of continuous film and narrow line metallizations of aluminum on silicon substrates , 1990 .

[10]  Yigal Komem,et al.  Stress relaxation in thin aluminium films , 1985 .

[11]  F. Brotzen,et al.  Mechanical behavior of aluminum and Al-Cu(2%) thin films☆ , 1988 .

[12]  S. Timoshenko,et al.  Theory of elasticity , 1975 .

[13]  I. Kiryushin,et al.  Stress relaxation in thin aluminium films , 1986 .

[14]  J. Cohen,et al.  Strain gradients in Al-2% Cu thin films , 1991 .

[15]  M. D. Thouless,et al.  Stress development and relaxation in copper films during thermal cycling , 1993 .

[16]  S. Suresh,et al.  Elastoplastic deformation of multilayered materials during thermal cycling , 1995 .

[17]  P. Flinn,et al.  Mechanical stress as a function of temperature in aluminum films , 1988 .

[18]  Ramnath Venkatraman,et al.  Separation of film thickness and grain boundary strengthening effects in Al thin films on Si , 1992 .

[19]  Robert Rosenberg,et al.  Measurement of thermal stress and stress relaxation in confined metal lines. I: Stresses during thermal cycling , 1993 .